Emergency Phone: CHEMTREC 1-800-424-9300
For more Information Call:
1-800-537-3407
MATERIAL SAFETY DATA SHEET
1. Product and Company Identification
Trade Name: MASCOBOND LO MOD, COMPONENT B
Revised: April08
Chemical Family: AMINEMIXTURE
Product Code: MS2GLM
Company: MasonsSupplyCompany(MASCO)
2637SE12thAvenue
Portland,OR97202
2. COMPOSITION INFORMATION
ThisdocumentispreparedpursuanttotheOSHAHazardCommunicationStandard(29CFR1910.1200).
INGREDIENT CAS NO. TLV STEL PEL CONTENT
ALKYLPHENOL 84852-15-3 N/E N/E N/E <45%
POLYAMINE 68953-36-6 N/E N/E N/E <30%
ALIPHATICAMINE 111-40-0 4.2mg/m3 N/E 10-30ppm <10%
POLYETHERAMINE 9046-10-0 N/E N/E N/E <10%
AMINOPHENOL 90-72-2 N/E N/E N/E <5%
BISPHENOLA 80-05-7 N/E N/E N/E <5%
* Specific chemical identity of this component is being held as trade secret information in accordance with CFR 1910.1200
3. HAZARDS IDENTIFICATION
HMIS Hazard Rating No. 3 (HIGH)
PRIMARY ROUTE OF ENTRY: INHALATION,DERMAL,EYES
EFFECTS OF OVER EXPOSURE:
INHALATION: Vapors/mist may be corrosive to upper respiratory tract. Repeated or prolonged exposure can result in lung damage.
Lung damage may be evidenced by shortness of breath and may be accompanied by chronic cough.
EYES: Product may cause irritation to the eyes. Corrosive to the eyes and may cause severe damage including blindness.
SKIN CONTACT: Corrosivetotheskin.Maycauseskinsensitization.
SKIN ABORPTION: No known information available.
INGESTION: Not expected to be a relevant route of exposure. However, may cause permanent damage to mouth, throat and
stomach.
CHRONIC: Repeated exposure may cause skin sensitization, or sensitization to the respiratory tract and development of an
asthmatic reaction to future exposure. Preexisting eye, skin, and respiratory disorders may be aggravated by
exposure to this product.
4. FIRST AID MEASURES
INHALATION: Remove victim from exposure. If difficulty with breathing, administer oxygen. If breathing has stopped, administer
artificial respiration. Seek medical attention.
EYES: Flush eyes with water, lifting upper and lower lids occasionally for 15 minutes. Seek medical attention.
SKIN: Immediately remove contaminated clothing. Wash thoroughly with soap and water for at least 15 minutes. If irritation
occurs,getmedicalattention.Donotre-useclothinguntilthoroughlycleaned.
INGESTION: Do not induce vomiting. If vomiting occurs spontaneously, keep head below hips to prevent aspiration of liquid into
the lungs. Give one glass of water unless victim is drowsy, convulsing or unconscious. Seek medical attention.
-1-
MASCOBOND LO MOD, COMPONENT B | msds
5. FIRE FIGHTING METHODS
HMIS HAZARD RATING NO. 1 (Slight)
Flash Point: >200o F METHOD: SETAFLASH
AUTO-IGNITION TEMP.: Not available
LIMITS OF FLAMMABILITY:LEL: Not available UEL: Not Available
EXTINGUISHING MEDIA: Use water fog, dry chemical or CO2.
SPECIAL FIRE FIGHTING PROCEDURES AND PRECAUTIONS: Do not enter confined fire space without full bunker gear (helmet with face shield, bunker coats,
gloves and rubber boots), including a positive pressure NIOSH approved self-contained breathing apparatus. Cool fire exposed containers with water.
UNUSUAL FIRE AND EXPLOSION HAZARDS: Containers exposed to intense heat from fires should be cooled with water to prevent vapor pressure buildup,
which could result in container rupture. Delayed lung damage can be experienced after exposure to combustion product. Nitrogen oxides and nitrogen
containing organic comounds may be released upon combustion.
6. ACCIDENTAL RELEASE MEASURES
ACTION TO TAKE FOR SPILLS / LEAKS: Danger. Corrosive. Prevent all bodily contact with spilled material. Clean up personnel must be equipped with self-
contained breathing apparatus, rubber gloves, and protective clothing. Dike and contain the spill. Soak up residue with an absorbent such as clay, sand
or other suitable material. Dispose of the absorbent material in accordance with federal, state, and local regulations. Residue resin may be removed with
hot soapy water.
WASTE DISPOSAL METHOD: Dispose in compliance with federal, state and local regulations.
7. HANDLING AND STORAGE
HANDLING: Keep away from open flames and high temperatures. STORAGE: Store in a well ventilated area.
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
RESPIRATORY PROTECTION: Do not breath vapors/mists. Use a NIOSH approved respirator to prevent overexposure. In accord with 29 cfr 1910.134, use a full
face, air supplying respirator or an air-purifying respirator for organic vapors. Avoid breathing vapors which may be produced under some conditions such
as application of uncured material in large surfaces.
PROTECTIVE CLOTHING: Do not get on eyes, skin or clothing. Wear chemical resistant protective clothing, gloves, and boots. Wear chemical goggles or
glasses with safety side shields to prevent contact with eyes.
ADDITIONAL PROTECTIVE MEASURES: Use ventilation to control vapors or mist concentrations. Eye wash fountains and safety showers should be available for
emergencyuse.
9. PHYSICAL AND CHEMICAL PROPERTIES
Water/Oil Distribution Coefficient: Odor:
N/AV Ammonical
Boiling Point (0C): Solubility in Water:
N/AV Negligible
Percent Volatile: Specific Gravity:
0.1% 1.20
Freezing Point ( C): pH:
N/AV N/AV
0
Vapor Pressure mmHg @ 200C: Evaporation Rate:
N/AV N/AV
Vapor Density: >Air
Odor Threshold: N/AV N/AV = Not Available
Appearance: Amber Liquid ca. = Approximate
N/AV = Not Available ca. = Approximate
10. STABILITY AND REACTIVITY
HMIS Hazard Rating No. 0
STABILITY: Stable; hazardous polymerization will not occur.
CONDITIONS AND MATERIALS TO AVOID: Avoid heat, flame and contact with strong oxidizing agents.
HAZARDOUS DECOMPOSITION PRODUCTS: Nitrogen oxides, carbon monoxide and unidentified organic compounds may be formed during combustion.
-2-
MASCOBOND LO MOD, COMPONENT B | msds
11. TOXICITY INFORMATION
HMIS Hazard Rating No. 3 (High)
PRIMARY ROUTE OF ENTERY: Inhalation,Dermal,Eyes
EFFECTS OF OVEREXPOSURE
INHALATION: Vapors may be corrosive to upper respiratory tract.
LC(50) INHAL. N/AV
EYES: May cause severe damage including blindness.
SKIN CONTACT: Corrosivetotheskin.Insomeindividualsitmaycausesensitization.
SKIN ABSORPTION: No information available.
INGESTION: Not expected to be expected route of entry. May cause permanent damage to the mouth, throat, and stomach.
LD(50) ORAL: CAS.NO.
84852-15-3 58g/kg(rat)
90-72-2 >2169mg/kg(rat)
111-40-0 3.99g/kg(rat)
9046-10-0 1.10g/kg(rat)
CHRONIC: Product does not contain chemicals considered to be carcinogenic by NTP, IARC, or OSHA.
This product contains residual (<5ppm) quantities of epichlorohydrin ECH (cas no. 106-89-8). It is very unlikely that normal work practices with this product
could result in measurable ECH concentrations in the workplace atmosphere. Nevertheless, you should be aware that ECH has been reported to
produce cancer in laboratory animals and to produce mutagenic changes in bacteria and cultured human cells. It has been classified by IARC as a
probable human carcinogen. It has been classified as an anticipated human carcinogen by NTP.
12. ECOLOGICAL INFORMATION
Marine Pollutant:NL
(NL = Not Listed; P = Moderate; PP = Severe; ND = Not Determined)
13. DISPOSAL CONSIDERATIONS
Dispose in a manner which complies with local, state, and federal regulations.
14. TRANSPORT INFORMATION
DOT/UN SHIPPING NAME: POLYAMINES,LIQUID,CORROSIVE,N.O.S.,(ALKALINEAMINE)
DOT HAZARD CLASS: CLASS8(CORROSIVELIQUID),PGIII
DOT PLACARD: CORROSIVE
OTHER REQUIREMENTS: UN1760,CLASS60
15. REGULATORY INFORMATION
Components are listed on EPA/TSCA inventory of chemical substances.
TITLE III SECTION 302: No reportable materials.
TITLE III SECTION 311/312: Healthhazard:Immediate.
Physicalhazard:Fire.
TITLE III SECTION 313: No reportable materials.
16. REGULATORY INFORMATION
Information contained in this MSDS refers only to the specific material designated and does not relate to any process or to use with any
other materials. This information is based on data believed to be reliable as of the date hereof. It is furnished without warranty of any kind
express or implied. Since actual use is beyond our control, no guarantee, express or implied, and no liability is assumed by MASONS SUPPLY
COMPANY in conjunction with the use of this information. Nothing herein is to be construed as a recommendation to infringe any patents.
-3-
|