MATERIAL SAFETY DATA SHEET



   Epoxy 600 Part B - Fast Cure





   SECTION I

   Product Identification and General Information

   Product Name: Epoxy 600 Part B Fast Cure                                Date Prepared: 11/10/2009

   Product Class: Aliphatic Amine Adduct                                   24 Hour Emergency Assistance: Chemtrec

   HMIS Codes: H F R P                                                     1-800-424-9300

                 31 0G



   SECTION II

   Hazardous Ingredients                                          CAS#                OSHA PEL            ACGIH TLV

   Modified Aliphatic Amine                                      686-105-60              N/E                 N/E

   Bisphenol A                                                   80-05-7                 N/E                 N/E

   Diethylenetriamine                                            111-40-0                N/E                 N/E

   1,3 Cyclohexanedimethanamine                                  2579-20-6               N/E                 N/E

   Benzyl Alcohol                                                100-51-6                N/E                 N/E

   Isophorone Diamine                                            2855-13-2               N/E                 N/E

   Benzyl Dimethylamine                                          103-83-3                N/E                 N/E

   Diglycidyl Ether of Bisphenol A                               25068-38-6              N/E                 N/E

   Nonyl Phenol                                                  25154-52-3              N/E                 N/E



   SECTION III

   Physical Data

   Boiling Point: N/A                                                      Solubility in Water: Moderate

   Vapor Pressure: N/A                                                     Evaporation Rate: N/A

   Vapor Density: Heavier Than Air                                         Appearance: Yellow to Brown Liquid

   Specific Gravity: 1.01                                                  Odor: Ammonia

   Percent Volatiles: N/A



   SECTION IV

   Fire and Explosion Hazard Data

   Flash Point: 180°F

   Flammable Limits:

   LEL: N/A

   UEL: N/A

   Extinguishing media: Water Fog, Foam, Dry Chemical or CO2.

   Hazardous Combustion Products: Ammonia, Oxides of Nitrogen, Toxic Fumes.

   Special Fire Fighting Procedures: Wear full protective clothing including NIOSH approved Self-Contained

   breathing apparatus.

   Fire and Explosion Hazards: Exposure to heat will build pressure in container. Cool with water spray.



   SECTION V

   Reactivity Data

   Stability: Stable

   Hazardous Polymerization: Will not occur

   Incompatibility: Mineral acids, organic acids and strong oxidizing agents







                  SPECIALIZED FLOOR COATINGS & DECORATIVE CONCRETE SYSTEMS

                                    th

Arizona Polymer Flooring . 7731 N. 68 Avenue . Glendale, AZ 85303 . Ph: 623.435.2277 OR 1.800.562.4921 . Fx: 623.435.8585 . www.apfepoxy.com

SECTION VI

Health Hazard Data

Primary Route of Entry: Dermal, inhalation, eye contact.

Eye Contact: Exposure to liquid or vapors may cause severe eye irritation. Symptoms include tearing,

redness, burning, swelling and eye damage.

Skin Contact: May cause skin irritation. Redness, burning and skin damage.

Inhalation: Excessive inhalation of vapors can cause nasal and respiratory irritation, CNS effects include

dizziness, weakness, nausea, headache and possible unconsciousness.

Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea.

Chronic Overexposure: May cause skin sensitization.



SECTION VII

First Aid

Eyes: Immediately flush eyes with copious amounts of water for 15 minutes. Seek medical attention.

Skin: Immediately remove contaminated clothing. Wipe excess from skin. Wash with plenty of soap and

water. Seek medical attention. Do not reuse clothing until thoroughly cleaned.

Ingestion: Do not induce vomiting. Give large quantities of water. Call physician immediately.

Inhalation: Remove victim to fresh air and provide oxygen if breathing is difficult. Seek medical attention.



Note to Physician: After ingestion, the patient may improve after the initial crisis, but perforation of

gastrointestinal tract may occur 2-4 days later with severe abdominal pain, rigidity and tenderness of the

abdomen and shock. Strictures of the esophagus may occur.



SECTION VIII

Special Protection Information

Respiratory Protection: Use appropriate NIOSH approved respirator for organic vapor to prevent

overexposure.

Ventilation: Provide sufficient ventilation to maintain exposure below level of overexposure.

Eye Protection: Chemical goggles and full face shield.

Skin Protection: Wear chemical resistant gloves and other clothing as required to prevent any contact

with the skin.



SECTION IX

Spill or Leak Procedures

Steps to be taken if material is released or spilled: Ventilate spill area. Cover with inert, absorbent

material and remove to disposal container. Observe all federal, state and local regulations. Do not flush

to surface water or sanitary sewer.

Waste Disposal Method: Do not contaminate any lakes, streams, pond or underground water supply.

Follow all federal, state and local regulations for disposal.



SECTION X

Shipping Data

D.O.T. Shipping Name: Amines, Liquid Corrosive N.O.S.

Technical Shipping Name: Aliphatic Amine

D.O.T. Hazard Class: 8 Corrosive Liquid

UN/NA Number: UN2735

Reportable Quantity: None

D.O.T. Labels Required: Corrosive Liquid

Freight Class: 55

Packing Group: III









                                                                               Epoxy 600 Part B - Fast Cure p.2