MATERIAL SAFETY DATA SHEET MSDS DATE: 4/8/09
IAQ 1000TM
SECTION 5: FIRE-FIGHTING MEASURES
Per OSHA-recommended ANSI Z400.1-2004 standard format & in accordance with
European standard format Product is non-combustible
Flash point: Autoignition Temperature:
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
F: Not flammable F: Not Established
C: Not flammable C: Not Established
Product Name: IAQ 1000TM
Product Description: Hydrogen Peroxide Stain Mold Stain Remover
Product Code: 8315
Extinguishing Media:
Chemical Family: Hydrogen Peroxide
Supplier: Fiberlock Technologies, Inc. Use extinguishing media appropriate for surrounding fire
Address:
Water Spray OK
Fiberlock Technologies
150 Dascomb Road Carbon Dioxide OK
Andover MA, 01810
Foam OK
Contact Info:
Tel: (800) 342-3755 Dry Chemical OK
Fax: (978) 475-6205 Halon NO
Emergency Phone: 24 Hour Contact: CHEM-TEL: (800) 255-3924
Other N/A
INTERNATIONAL 24 HOUR EMERGENCY Phone: 813-248-0585
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
SECTION 6: ACCIDENTAL RELEASE MEASURES
Hazardous:
Accidental Release Measures:
Personal Precautions: Do not get in eyes. Do not take internally. Avoid skin
Chemical Name CAS# Percent OSHA PEL ACGIH TLV contact. Prevent prolonged or repeated breathing of vapor or spray mists. Keep
unnecessary people away. Floor may be slippery, use care to avoid falling.
1 - Hydrogen 7722-84-1 <10% 1.4 mg/m3 1 mg/m3
Remove all sources if ignition. Ventilate the area. Remove with inert absorbent.
Peroxide
Environmental Precautions: Keep spills and cleaning run-offs out of municipal
sewers and open bodies of water. Comply with local, national and state
This product does not contains any toxic chemical(s) subject to the reporting regulations.
requirements of section 313 of the Emergency Planning and Community Right-To-
Know Act of 1986 and of 40 CFR 372.
SECTION 7: HANDLING AND STORAGE
SECTION 3: HAZARDS IDENTIFICATION Handling and Storage:
Maximum Storage Temperature: 100癋 (38癈), minimum 35癋 (2癈).
Potential Health Hazards:
Keep closure tight and containers upright to prevent leakage.
Skin Contact: No effects of exposure expected due to contact. Keep out of reach of children.
Eyes Contact: Burning or irritation of eyes. Precautionary labeling: KEEP FROM FREEZING".
Product is non-combustible.
Inhalation: No noticeable effects
Ingestion: May cause irritation to mouth, nose and throat. Possible nausea and
discomfort.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Precautions:
SECTION 4: FIRST AID MEASURES Use only with adequate ventilation.
Eyes: Flush with large quantities of water, holding eyelids open. Seek medical Work Hygienic Practices: Avoid contact with skin. Do not get in eyes. Do not
attention. take internally. Avoid breathing vapors or spray mists.
Skin: Remove contaminated clothing. Flush affected areas with large quantities of Ventilation: Use in well-ventilated areas. Provide local exhaust to keep TLV
water. Seek medical attention if irritation persists. of
Ingestion: Give large quantities of water. Seek medical attention immediately. Do Section 2 ingredients below acceptable limit.
not induce vomiting. Respiratory Protection: Use a NIOSH/OSHA approved mask when spray
Inhalation: Remove victim to fresh air and monitor. Seek medical attention if mist is present and or the TLV has been exceeded.
symptoms persist.
Eye Protection: Safety glasses or chemical splash goggles.
Skin Protection: Wear neoprene, rubber, vinyl, or nitrile gloves to prevent
skin contact if prolonged skin contact is likely. Wash hands before eating,
smoking or using the wash room.
Page 1: MSDS for Fiberlock Technologies IAQ 1000TM Hydrogen Peroxide Stain Mold Stain Remover No. 8315
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES SECTION 15: REGULATORY INFORMATION
Appearance: Solubility in Water: U.S. Federal Regulations:
Thin liquid Total
TSCA (TOXIC SUBSTANCE CONTROL ACT): All components of this product are
Odor: Color:
Pleasant Clear
in compliance with the inventory listing requirements of the U.S. Toxic Substances
odor
Control Act (TSCA) Chemical Substance Inventory.
Boiling Point: Viscosity @ 77癋:
212癋 N/A
CERCLA (COMPREHENSIVE RESPONSE COMPENSATION, AND LIABILITY
ACT): Releases of this material to air, land, or water are not reportable to the
Evaporation Rate: Vapor Density
N/A N/A
National Response Center under the Comprehensive Environmental Response,
(Butyl Acetate=1) (AIR = 1) @ 68癋:
Compensation, and Liability Act (CERCLA) or to state and local emergency planning
Vapor Pressure: Specific Gravity (H2O
N/A 1.013 committees under the Superfund Amendments and Reauthorization Act (SARA) Title
= 1) @ 68癋: III Section 304.
SARA TITLE III: No ingredients in this product are subject to SARA 313 (40 CFR
pH Percent Volatile
6.5 - 7.5 90+
372.65C) Supplier Notification.
CALIFORNIA SAFE DRINKING WATER AND TOXIC ENFORCEMENT ACT
SECTION 10: STABILITY AND REACTIVITY
(PROPOSITION 65): No Components of this product are on the California Proposition
65 lists.
Stability: Stable
Incompatibility: (Material to Avoid): N/A
Hazardous Decomposition or By-Products: From thermal reaction carbon
SECTION 16: OTHER INFORMATION
dioxide and carbon monoxide.
N/A
Hazardous Polymerization: Will not occur.
SECTION 11: TOXICOLOGICAL INFORMATION CAS. No.: CHEMICAL INGREDIENTS
Toxicological Information: 7732-18-5 Water
No Data Available
7722-84-1 Hydrogen Peroxide
1310-58-3 Potassium Hydroxide
SECTION 12: ECOLOGICAL INFORMATION
Not Available+ Proprietary Sufactant
Ecological Information:
Not Available+ Proprietary Chelating Agent
No Data Available
(+) Contents Partially Unknown
SECTION 13: DISPOSAL CONSIDERATIONS
HMIS HAZARD RATING
Waste Disposal Method:
Health 2 Flammability 0 Physical Hazard 1 Personal
Dispose of in accordance with Federal, State/Provincial, and Local regulations
Protection B
regarding pollution. Do not dump into sewers, any body of water or onto the
ground. HAZARD INDEX: 0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe
PERSONAL PROTECTION CODE:
SECTION 14: TRANSPORT INFORMATION
This company cannot anticipate all conditions of handling and use of this product.
U.S. Department of Transportation
Therefore, this company accepts no responsibility for results obtained by the application
Proper Shipping Name: "Non Regulated"
of this information, or the safety and suitability of our products either alone or in
Hazard Class: "Non Regulated"
combination with other products. It is the responsibility of the user to provide a safe
Shipping Class: Cleaning Compound
workplace, using the health and safety information contained herein as a guide. This
company will accept no liability for damages or loss incurred from the
improper handling and use of this product.
Page 2: MSDS for Fiberlock Technologies IAQ 1000TM Hydrogen Peroxide Stain Mold Stain Remover No. 8315
|