Material Safety Data Sheet Revised: 11/09
Chromatic Technologies, Inc. Phone: (719) 592-1557
4870 Centennial Blvd., Suite 126 Emergency phone: (800)424-9300
Colorado Springs, CO 80919
Section I -- Product Identification
Identity: Hardener for Epoxy Screen Ink
Chemical Family: Amine
Section II -- Ingredient Information
COMPONENT CAS # % wt. EXPOSURE GUIDELINES
OSHA ACGIH MFR
PEL TLV
Triethylenetetramine 112-24-3 NR NE NR NE
Polyamide Resin 68410-23-1 NR NE NR NR
2,4,6-Tris(Dimethylaminomethyl) 90-72-2 NR NE NE TL5
Phenol ppm
HAZARDOUS MATERIALS IDENTIFICATION SYSTEM (HMIS):
Health Flammability Reactivity Personal Protection
3 1 0 B
Section III -- Physical Data
Color: Dark Amber
Odor: Amine
Physical State: Medium Viscosity Liquid
Solubility in Water: Moderate
Vapor Pressure: Not Determined
Specific Gravity: 0.95 ?0.99 (water=1)
Boiling Point: Not Determined.
Evaporation Rate: Not Determined.
Section IV -- Fire and Explosion Information
Flash Point: >200 F
Flash Pont Method Used: Estimated
Fire Fighting Extinguishing Media: Carbon dioxide, dry chemical, foam, water.
Fire Fighting Equipment: Use self-contained breathing apparatus.
Fire and Explosion Hazards: Decomposition and combustion products may be toxic.
Section V - - Hazardous Identification
Emergency Overview: Danger! Corrosive ?causes skin and eye burns. May cause allergic reaction.
Primary Route of Entry: Dermal; heated product may produce inhalable vapors.
Acute Exposure: Danger! Corrosive. Causes skin and eye burns.
Section VI--First Aid Measures
Ingestion: if conscious give 2 ?4 glasses of water to drink. Do not induce vomiting. Call physician.
Chromatic Technologies, Inc. Page 1
4870 Centennial Blvd., Suite 126 Tel. (719) 592-1557
Colorado Springs, CO 80919 Fax (719) 592-1455 www.ctiinks.com
Skin: Immediately wash with soap and water. Remove contaminated clothing and launder before reuse.
Destroy contaminated shoes.
Inhalation: Remove to fresh air. Call a physician.
Eyes: Immediately flush eyes for at least 15 minutes. Call physician
Overexposure Effects: Danger! Corrosive. Causes skin and eye burns. Causes allergic reactions.
Medical Conditions Aggravated by Overexposure: Skin and eye conditions
Additional Information: Referral to a physician is recommended if there is any question about the
seriousness of any injury.
Section VII- - Accidental Release Measures
Accidental Release Measures: Remove spillage by absorbing in absorbent material. Avoid contact.
Section VIII- - Handling and Storage
Precautions: Danger! Corrosive. Causes skin and eye burns. May cause allergic skin reaction. Do not get in
skin, on skin, on clothing. Avoid breathing vapor or mist. Keep container closed. Use with adequate
ventilation. Wash thoroughly after handling.
Other Handling Information: Nuisance dust may be generated when sanding or sawing cured material.
Section IX- - Exposure Controls / Personal Protection
Skin Protection: Impermeable gloves and protective clothing.
Respiratory Protection: Use NIOSH approved organic vapor cartridge respirator when vapor/mist exposure
is likely.
Eye Protection: Wear splash-proof chemical goggles.
Engineering Controls: General mechanical and local exhaust in accordance with ACGIH recommendations.
Section X- - Stability and Reactivity
Conditions to Avoid: Excessive heat for prolonged periods of time.
Stability: Stable
Incompatibility: Strong oxidizers, acids and bases.
Hazardous Decomposition Products: Combustion may form toxic materials such as carbon monoxide,
carbon dioxide and nitrogen oxides.
Hazardous Polymerization: Will not occur.
Section XI- - Transportation Information
DOT: Non-Bulk
Proper Shipping Name: Ployamines, liquid, Corrosive N.O.S.
Technical Shipping Name (if n.o.s.): 2,4,6-Tris(dimethylaminomethyl)Phenol,
Hazard Class: 8
ID Number: UN2735
PG: PG II
Label: Corrosive
Section XII - - Regulatory Information
US Federal Regulations
Chromatic Technologies, Inc. Page 2
4870 Centennial Blvd., Suite 126 Tel. (719) 592-1557
Colorado Springs, CO 80919 Fax (719) 592-1455 www.ctiinks.com
Occupational Safety and Health Act(OSHA): This Material Safety Data sheet has been prepared in
compliance with the federal OSHA Hazard Communication standard 29 CFR 1910.1200. This product is
considered to be a hazardous chemical under that standard.
Resource Conservation and Recovery act (RCRA): Not a hazardous waste under RCRA (40 CFR261) but
handle with care due to corrosive effect on skin and eyes.
Sara Title III: Section 313 Toxic Chemical List (TCL): This Product does not contain any chemicals for
routine annual toxic chemical release reporting under section 313 (40 CFR 372)
TSCA Section 8(b) ?Inventory Status: Chemical components listed on TSCA Inventory.
TSCA Section 12(b) ?Export Notification: This product does not contain any chemicals that are subject to a
section 12(b) export notification.
State Regulations
California Proposition 65: This product does not contain any chemicals currently on the California list of
known Carcinogens and Reproductive Toxins.
Pennsylvania Right-to-Know: The following is required composition information:
Chemical Name: Fatty acids, C18-unsatd., dimmers, reaction products with Polyethylenepolyamines
Common Name: Polyamide Resin
CAS number: 68410-23-1
Comment: Not on Pennsylvania Hazardous Substance List
Chemical Name: Phenol, 2,4,6-tris[(dimethylamino)methyl]-
Common Name:2,4,6- Tris (Dimethylaminomethyl) Phenol
CAS Number: 90-72-2
Comment: Not on Pennsylvania Hazardous Substance List
Chemical Name: 1,2-Ethanediamine, N,N'-bis(2-aminoethyl)-
Common Name: Triethylenetetramine
CAS Number: 112-24-3
Comment: Hazardous Substance
DISCLAIMER
The information herein is given in good faith, and is confidential. No warranty is expressed or implied. Any
use of these data must be determined by the users.
Chromatic Technologies, Inc. Page 3
4870 Centennial Blvd., Suite 126 Tel. (719) 592-1557
Colorado Springs, CO 80919 Fax (719) 592-1455 www.ctiinks.com
|