Wednesday, February 27, 2008
Page 1 of 5
MSDS - Material Safety Data Sheet
Product Name: LIQUID WRENCH SUPER LUBRICANT
(UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
I. Basic Information:
Manufacturer: RADIATOR SPECIALTY COMPANY Contact: Robert Geer
Address: 600 RADIATOR ROAD Information Telephone Number: 704-684-1811
City, ST Zip: INDIAN TRAIL, NC 28079 Emergency Contact: Rocky Mountain Poision Control Center
Country: Emergency Telephone Number: 303-623-5716
Emergency Restrictions:
Product Name: LIQUID WRENCH SUPER LUBRICANT (UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
Issue Date: 02/20/2008
Supersedes Date: 12/07/2007
II. Hazards Identification:
EMERGENCY OVERVIEW
Danger: Flammable. Harmful or fatal if swallowed. Eye and skin irritant. Contents under pressure.
Level 3 Aerosol
OSHA Regulatory Status
This material is considered hazardous by the OSHA Hazard Communication Standard (29 CFR 1910.1200).
Potential Health Effects
Route(s) of Entry:
Absorption, Inhalation, and Ingestion.
Health Hazards (Acute and Chronic):
See signs and symptoms below
Signs and Symptoms:
Eye Contact: Irritant. Prolonged contact may cause conjunctivitis.
Skin Contact: Irritant. Defatting of tissue, dermatitis may occur.
Inhalation: Irritant to mucous membranes. Repeated exposure may cause narcosis, dizziness, respiratory or lung irritation.
Ingestion: HARMFUL OR FATAL IF SWALLOWED. May cause burns to mouth, throat & stomach.
Medical Conditions Generally Aggravated by Exposure:
None Known
Other Health Warnings:
Vomiting and subsequent aspiration into the lungs may lead to chemical pneumonia and pulmonary edema which is a potentially fatal condition.
Potential Environmental Effects
Not Available
III. Composition/Information on Ingredients:
Chemical Name CAS No. % Range Trade Secret
1,2,4-Trimethylbenzene 95-63-6 1.0 - 5.0
2-Butoxy-1-Ethanol 111-76-2 1.0 - 5.0
Aliphatic Hydrocarbon - Non Exempt. 8052-41-3 30.0 - 60.0
Carbon dioxide 124-38-9 1.0 - 5.0
Mesitylene 108-67-8 1.0 - 5.0
Naphthenic Petroleum Distillate 64742-52-5 30.0 - 60.0
Xylene (mixed isomers) 1330-20-7 1.0 - 5.0
Wednesday, February 27, 2008
Page 2 of 5
MSDS - Material Safety Data Sheet
Product Name: LIQUID WRENCH SUPER LUBRICANT
(UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
IV. First Aid Measures:
Emergency and First Aid Procedures:
Eye Contact: Flush eyes with clean water for 20 minutes while lifting eyelids. Get prompt medical attention.
Skin Contact: Wash skin with soap and water thoroughly. If adverse effects persist, get prompt medical attention. Remove and isolate
contaminated clothing. Launder contaminated clothing before reuse.
Inhalation: Move victim to fresh air. If breathing becomes difficult, administer oxygen and get prompt medical attention. If breathing stops, give
artificial respiration and get prompt medical attention.
Ingestion: DO NOT INDUCE VOMITING! Call Poison Control Center, physician, or hospital emergency room immediately. Aspiration of vomitus
into the lungs can cause pneumonitis, which can be fatal.
Note to Physicians:
N/E
V. Fire Fighting Measures:
Suitable Extinguishing Media:
Water Fog, Foam, Carbon Dioxide, Dry Chemical
Unsuitable Extinguishing Media:
Do not use forced water stream as this could cause the fire to spread.
Products of Combustion:
Normal products of combustion, smoke, carbon dioxide, carbon monoxide, and sulfur trioxides.
Protection of Firefighters:
Wear self-contained positive pressure breathing apparatus and protective clothes. Use shield to protect from rupturing and venting containers. At
elevated temperatures containers may vent, rupture or burst, even violently
VI. Accidental Release Measures:
Personal Precautions:
Eliminate all ignition sources. Persons not wearing protective equipment should be excluded from area of spill until clean-up has been completed.
Environmental Precautions:
Prevent run-off to sewers, streams, or other bodies of water. If run-off occurs, notify proper authorities as required that a spill has occured. Run off
to sewer may create fire or explosion hazard.
Methods for Containment:
Dike or contain spill and absorb with inert materials (sand, sawdust, absorbent sweeping compounds, rags, etc).
Methods for Cleanup:
Using a non-metalic scoop, place contaminated material into an approved chemical waste container. Where possible, vacuum spilled liquid using
an explosion proof vacuum to recover material.
Other Information:
All equipment used with handling the concentrate must be grounded. If run-off occurs, notify proper authorities as required that a spill has occured.
VII. Handling and Storage:
Handling Precautions:
Use with adequate ventilation and proper protective equipment.
Do not use or store near fire, sparks, or open flame. Do not puncture or incinerate container. Exposure to temperatures above 120掳 may cause
container to vent, rupture, or burst.
Storage Precautions:
Store in cool, well ventilated area below 120掳F away from heat, fire, sparks or flame.
VIII. Exposure Controls/Personal Protection:
Wednesday, February 27, 2008
Page 3 of 5
MSDS - Material Safety Data Sheet
Product Name: LIQUID WRENCH SUPER LUBRICANT
(UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
Chemical Name OSHA PEL ACGIH TLV Other Limits
Aliphatic Hydrocarbon - Non Exempt. 100 ppm 100 ppm Not Available
2-Butoxy-1-Ethanol 50 ppm 25 ppm Not Available
Carbon dioxide N/AV 5000 ppm Not Available
1,2,4-Trimethylbenzene N/E 25 ppm Not Available
Naphthenic Petroleum Distillate 5 mg/m3 5 mg/m3 Not Available
Mesitylene N/A N/A Not Available
Xylene (mixed isomers) 100 ppm 100 ppm Not Available
Engineering Controls:
Use with adequate ventilation. If TLV is exceeded, wear NIOSH approved respirator.
Personal Protective Equipment:
See Section 2 for applicable exposure limits. For prolonged exposure wear protective safety glasses, gloves, and apron.
IX. Physical and Chemical Properties:
Boiling Point: 320 F Melting Point: N/A
Boiling Range: N/D Freezing Point: N/D
Solubility In Water: Insoluble Evaporation Rate (Butyl Acetate = 1): N/A
Flash Point: 132F Flash Point Method: TCC
Odor Threshold: N/D Appearance and Odor: Clear light yellow with sweet vanilla odor
Vapor Density (AIR = 1): N/D Vapor Pressure (mm Hg.): N/D
pH Range: N/A N/D
Partition Coefficient:
Decomposition Temp: N/D Auto-Ignition Temp: N/D
Lower Explosive Limit: 0.7% Upper Explosive Limit: 5%
Specific Gravity (H20 = 1): 0.81
Other Information: VOC Content: 44.0 %
X. Stability and Reactivity:
Stability:
Product is stable
Conditions to Avoid:
Avoid heat, sparks, and flames. Avoid incompatible materials.
Incompatible Materials:
Avoid contact with strong oxidizers
Hazardous Decomposition Products:
Normal products of combustion, smoke, carbon dioxide, carbon monoxide, and sulfur trioxides.
Possibility of Hazardous Reactions:
Will not occur
XI. Toxicological Information:
N/D
Wednesday, February 27, 2008
Page 4 of 5
MSDS - Material Safety Data Sheet
Product Name: LIQUID WRENCH SUPER LUBRICANT
(UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
XII. Ecological Information:
N/D
XIII. Disposal Considerations:
DISPOSAL: This container may be recycled in aerosol recycling centers when empty. Before offering for recycling, empty the can by using the
product according to the label. DO NOT PUNCTURE! If recycling is not available, wrap the container and discard in the trash. Dispose of unused
product in accordance with all local, state government and federal laws and regulations.
XIV. Transport Information:
Shipping Name: Consumer Commodity
DOT Subsidiary Hazard Class: Not Available
DOT Hazard Class: ORM-D
Not Available
UN/NA#: 1950 Packing Group:
Transportation Information:
DOT Hazard Class: ORM-D
Shipping Name: Consumer Commodity
The DOT description is provided to assist in the proper shipping classification of this product and may not be suitable for international and air
shipping purposes.
ICAO/IATA (US)
Shipping Name: Aerosols
Class: 2.1
UN number: UN1950
International:
ICAO/IATA
UN number: UN1950
Shipping Name: Aerosols
Class: 2.1
IMDG
UN number: UN1950
Shipping Name: Aerosols
Class: 2.1
EmS: F-D, S-U
XV. Regulatory Information:
See Section 2 for SARA Reportable Chemicals.
USA TSCA: All components of this material are either exempt or listed on the US TSCA Inventory.
Warning: This product contains a chemical(s) known to the State of California to cause cancer or birth defects or other reproductive harm.
New Jersey RTK
Aliphatic Hydrocarbon 8052-41-3
1,2,4-Trimethylbenzene 95-63-6
1,3,5-Trimethylbenzene 108-67-8
Xylene 1330-20-7
Pennsylvania RTK
Aliphatic Hydrocarbon 8052-41-3
1,2,4-Trimethylbenzene 95-63-6
Xylene 1330-20-7
Wednesday, February 27, 2008
Page 5 of 5
MSDS - Material Safety Data Sheet
Product Name: LIQUID WRENCH SUPER LUBRICANT
(UPC: 078698120256) (AAP SKU: 7070020)
MSDS No.: L212
XVI. Other Information:
Liquid Gas Solid
Chemical State: X
Pure Mixture
Chemical Type: 2
X
Hazard Category: 2 0
Acute Chronic Fire
X X
Pressure Reactive
X
Additional Manufacturer Warnings:
Do not used in confined area without proper ventilation. Contact lenses 2
may cause further damage in case of splash into eye. KEEP AWAY FROM
2
CHILDREN AND ANIMALS!
0
N/E: Not Established
N/D: Not Determined C
N/A: Not Applicable
N/AV: Not Available
Additional Product Information:
While Radiator Specialty Company believes this data is accurate as of the revision date, we make no warranty with respect to the
data and we expressly disclaim all liability for reliance thereon. The data is offered solely for information, investigation, and
verification. Various government agencies may have specific regulations regarding the transportation, handling, storage, use, or
disposal of this product which may not be covered by this MSDS. The user is responsible for full compliance.
|