MATERIAL SAFETY DATA SHEET
(Essentially similar to OSHA form 174, Sept. 1985 - For Compliance with OSHA鈥檚 Hazard Communication Standard, 29CFR 1910.1200)
Section I - Product Identity: Lag Kast庐 (6432/6433)
Date of Preparation: March 7, 2007
Manufacturer鈥檚 Name:
Fiberlock Technologies, Inc. Information Telephone Number: (978) 623-9987
150 Dascomb Rd. Emergency Telephone Numbers:
Andover, MA 01810 Weekdays: (978) 623-9987
After hours, weekends & holidays: 鈥淐HEM-TEL鈥?
Emergency Contact Number: (800) 255-3924
Section II - Hazardous Ingredients/Identity Information
HAZARDOUS COMMON CAS. PEL TLV-TWA TLV-STEL
COMPONENT NAME(S) Wt. % NO. mg/m3 mg/m3 mg/m3
Potassium Sulfate (K2 SO4) 藴1 7778-80-5 N/E N/E N/E
Notes: N/A = Not Applicable N/E = Not Established
Section III - Physical/Chemical Characteristics
Boiling Points of Major Constituent: N/E N/E
Specific Gravity (H2O=1) Wgt./gal.
(Water)
N/A Melting Point
Vapor Pressure (mm Hg) @ 68掳F N/E
N/A
Percent Volatility (By wt):
Vapor Density (AIR=1)
N/A
Heavier
Evaporation Rate: N/A
Lighter
Appearance: Woven cotton gauze fabric Maximum VOC鈥檚
Reactivity in Water Hardens substrate coated with Plaster of Paris formula N/A
Insoluble
Solubility in Water Odor: No discernible odor pH: N.A
Section IV - Fire and Explosion Hazard Data (Nonflammable)
Flash Point and Method: Autoignition Temperature: Flammable Limits: DOT Hazard Class:
N/A N/A LEL: N/A UEL:N/A Not Regulated
Extinguishing Media: Water, carbon dioxide or dry chemical. Special Fire Fighting Procedures: Fire fighters should wear a self-
contained breathing apparatus. Unusual Fire and Explosion Hazards: Decomposition by-products may include oxides of sulfur and
potassium, carbon monoxide and carbon dioxide.
Section V - Reactivity Data
Hazardous Polymerization: Will not occur. Conditions to Avoid: Exposure to Excessive Heat or moisture contamination
Stability: Stable
Incompatibility: Avoid Contact with: Strong oxidizing agents and ionic aluminum and magnesium
Hazardous Decomposition Products: Some carbon monoxide and carbon dioxide; oxides of sulfur and potassium
Section VI - Health Hazard Data, Toxicity Data
Route(s) of Entry: Eye, Inhalation, Skin, Ingestion
Carcinogen listed in: Not Listed Carcinogenicity: IARC: No, NTP: No, OSHA: No, LD50: N.E., LC50: N.E.
POTENTIAL HEALTH EFFECTS: Eye Contact: Particles may cause irritation. Ingestion: Plaster hardens when wetted and may result in
an obstruction. Large oral doses may result in gastrointestinal disturbances and irritation. Inhalation: Possible nuisance dust effect,
sneezing or coughing. Skin Contact: May develop sufficient heat to cause burns if a large mass is kept in contact with the skin while
hardening. May dry skin. See product insert for specific application instructions. Chronic: None known
EMERGENCY AND FIRST AID PROCEDURES: Eye Contact: Immediately flush eyes with copious amounts of water for at least 15
minutes. Ingestion: Plaster hardens when wetted and ingestion may result in obstruction. Seek immediate medical attention. Inhalation:
Remove to fresh air. Seek medical attention for any breathing difficulty. Skin Contact: Wash affected area with water. If irritation
persists, seek medical attention.
SUPPLEMENTAL INFORMATION
To comply with New Jersey DOH Right-To-Know labeling law
(N.J.A.C. 8:59 - 5.1 & 5.2)
CAS. No.: CHEMICAL INGREDIENTS:
HMIS HAZARD RATING
10101-41-4 Calcium sulfate
Health 0 Flammability 0 Reactivity 0 Personal Protection A
7778-18-9 Calcium sulfate
HAZARD INDEX: 0=Minimal, 1=Slight, 2=Moderate, 3=Serious, 4=Severe
1317-65-3 Calcium carbonate
Not avail.* Latex Pemulsion PERSONAL PROTECTION CODE
7778-80-5 Potassium sulfate A=Safety Glasses
10043-35-3 Boric acid
*Contents partially unknown
Section VII: Precautions for Safe Handling and Use
SPILL OR LEAK PROCEDURES: Product is packaged in individual packets, therefore, spills will not likely
occur.
WASTE DISPOSAL METHOD: Dispose of in accordance with all Federal, State and Local environmental
regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Store product at 75潞F or cooler for maximum
shelf life. Protect product from moisture. Exposure to water (including ambient humidity) will cause the product
to harden. Do not puncture or open the pouch unless the product is to be used immediately. Observe good
housekeeping and sanitary procedures.
OTHER PRECAUTIONS: Do not get in eyes. Avoid skin contact. Do not handle until the manufacturer鈥檚
safety precautions and label instructions have been read and understood. Avoid breathing sanding
dust. Do not puncture the pouch unless the product is to be used immediately.
Section VIII: Control Measures
Engineering Controls: General exhaust is adequate.
Personal protection
Eyes: Use of safety glasses/goggles is recommended.
Respirator: None necessary under normal conditions of use.
Skin: Use of gloves is recommended.
Other: None required under normal use conditions.
Work/Hygienic Practices: Practice good personal hygiene.
Section IX: Other Information:
CERCLA (Comprehensive Environmental Response Compensation and Liability Act): No Reportable Quantity.
OSHA Hazard Communication Standard, 29 CFR 1910.1200: All products are listed.
SARA Title III (Superfund Amendments and Reauthorization Act): No listed ingredient.
TSCA (Toxic Substances Control Act): All products are listed.
The information in this Material Safety Data Sheet meets the requirements of the United States Occupational
Safety and Health Act and regulations promulgated thereunder (29 CFR 1910.1200 ET.SEQ.).
|