Material Safety Data Sheet
Page 1 of 2
Distributor: Advanced Document Systems & Supply, Inc.
701 E Gardena Blvd
Gardena, California 90278
(310) 516-7778
Manufacturer: The General Graphic Company
2525 Mandela Parkway
Oakland, California 94607
(510) 832-4404
Prepared: 5-22-87 Updated: 06-96
I Product Identification
Generic ID: Complex Aerosol Mixture
DOT Shipping Name: Consumer Commodity
DOT Hazard Class: ORM-D
Trade Name: SILICONE SPRAY
II Hazardous Components
Ingredient CAS Number WT% TLV(ppm)
1,1,1 鈥? Trichloroethane 71-55-6 350 350
Poly (Dimethyl) Siloxane 63148-62-9 ----- -----
Isopropyl Alcohol 67-63-0 400 400
Propellants:
Propane 74-98-6 ----- 1000
Butane 75-28-5 ----- 1000
III Physical Data
Boiling Point: 1,600掳F
Specific Gravity: 1.297
Vapor Pressure (psig at 750 F): 45
Percent Volatiles: 98%
Specific Vapor Density (Air = 1): Not Determined
Volatile Organic Content (VOC): 1297g/1 or 10.8 Ib./gal
IV Fire & Explosion Data
Flash Point (TOC): 63掳F
Lower Explosive Limit: N/A
Extinguishing Media: Foam, Carbon Dioxide, Dry Chemical
Special Firefighting Procedures: Keep containers cool. Use equipment or shielding
required to protect personnel against bursting, rupturing or venting containers.
Silicone Spray Page 2 of 2
Unusual Fire & Explosion Hazards: At elevated temperatures (above 120掳F) containers
may vent, rupture or burst.
V Health Hazard Data
Effects of Acute Overexposure
Eyes: Can cause irritation, redness, tearing, blurred vision.
Skin: Can cause irritation, defatting, dermatitis.
Inhalation: Can cause dizziness, drowsiness and throat irritations.
Swallowing: Low to moderate toxicity.
First Aid
Eyes: Flush with water lifting upper and lower lids. Get medical attention.
Skin: Wash exposed area with soap and water.
Inhaled: Remove to fresh air. Give oxygen or artificial respiration as required.
Swallowed: DO NOT induce vomiting. Get medical attention.
Chronic Effects of Overexposure
Aspiration of material into lungs due to vomiting can cause chemical
pneumonitis. Blood pressure depression, cardiac sensitization,
ventricular arrythmia, unconsciousness and death possible at levels
above 10,000 PPM.
VI Reactivity Data
Hazardous Polymerization: Will not occur.
Stability: Stable
Incompatibility (Avoid Contact With): Strong alkalis, oxidizers, aluminum and other
reactive metals.
VII Spill or Leak Procedures
Spill Procedures: Eliminate all ignition sources. Clean with absorbent materials and place
in closed containers for waste disposal.
Waste Disposal: Consult Federal, State and Local disposal authorities for approved
disposal procedures. When used properly aerosol products do not generate
hazardous waste.
VIll Special Protection & Precautions
Respiratory Protection: Approved organic vapor type respirator if TLV (or PEL) values
are exceeded.
Ventilation: Provide ventilation to maintain safe exposure levels.
Protective Gloves: Wear resistant gloves such as: Neoprene, nitrile rubber, polyvinyl
chloride.
Eye Protection: Chemical splash goggles in compliance with OSHA regulations.
Other Protective Equipment: N/A
Comments: Pressurized containers must not be exposed to temperatures above 120掳F and
spray should not be directed towards face or eyes, open flame, or other source of
ignition.
|