Alisyn Synthetic ATF
Material Safety Data Sheet
QUICK IDENTIFIER
May be used to comply with OSHA's ,Hazard Communication Standard.
Common Name: (used on Label and list)
29 CFR 1910. 1200 Standard must be consulted for specific requirements.
SECTION 1- MANUFACTURER
Manufacturer's
HEALTH 1
Name
Aerospace Lubricants, Inc
FLAMMABILITY 1
Address Emergency
Telephone No.
614-878-3600
1600 Georgesville Road
Other
City, State, and Zip
REACTIVITY 0
Information
614-878-3600
Columbus, Ohio 43228 Calls
B
January 3, 2006 PERSONAL PROTECTION
Signature of Person Date
Rev. D
Responsible for Preparation Prepared
Stephen E. Gates
SECTION 2- HAZARDOUS INGREDIENTS/IDENTITY
Hazardous Component(s) (chemical & common name(s) OSHA ACGIH Other Exposure % CAS
PEL TLV Limits (optional) NO.
No hazardous components were knowingly incorporated into this lubricant. This product is not considered hazardous according to the OSHA
Hazard Communication Standard 29CFR 1910.1200. Lubricant is a synthetic Hydrocarbon Basestock with proprietary additives.
SECTION 3 - PHYSICAL & CHEMICAL CHARACTERISTICS
Boiling Specific Vapor
Point Gravity (H O=1) Pressure (mm Hg)
>350潞F 0.8368 <1 mm @ 20潞C
Vapor
Density (Air=1)
N/A
Solubility Reactivity in
in Water Water
None
Insoluble
Melting
Appearance
Point
and Odor
N.A
Red oil, slight petroleum odor
SECTION 4 - FIRE & EXPLOSION DATA
UEL
Flammable Limits LEL
Flash Method
360潞F Upper
ASTM D-92 in Air % by Volume Lower
N.E. N.E.
Point N.E.
Used
Extinguisher
Auto-Ignition
Media
Temperature
Not Established CO , dry chemical, foam, water spray, water fog.
2
Special Fire
Fighting Procedures
Self contained breathing apparatus and protective clothing should be worn in fighting fires involving chemicals. Decomposition
at temperatures above 290潞C may cause the evolution of toxic gaseous compounds.
Unusual Fire and
Explosion Hazards
Toxic gases may be produced by combustion. Do not weld, heat or drill container as residue may ignite with explosive force if
heated sufficiently. Do not use pressure to empty drum or can
Alisyn Synthetic ATF
SECTION 5 - PHYSICAL HAZARDS (REACTIVITY DATA)
Conditions
Stability Unstable
Strong Oxidizers, temperatures above 360潞F
to Avoid
Stable X
Incompatability
(Materials to Avoid Oxidizing materials can cause a reaction
Hazardous
Oxides of Carbon, Nitrogen, Phosphorus, Sulfur, CO ,, traces of incompletely burned carbon.
Decomposition Products
2
May Cccur
Hazardous
Will Not Occur X
polymerization
None Known
SECTION 6 - HEALTH HAZARDS
Prolonged and/or repeated exposure may cause eye,
1. Acute 2. Chronic
None known
skin or lung irritation.
Signs and
Prolonged and repeated contact with skin may cause skin irritation.
Sympton of Exposure
Medical Condition Generally
No known medical condition that might be aggravated by exposure.
Aggravated by Exposure
National Toxicology I.A.R.C. OSHA Yes
Yes
Yes
Chemical Listed as Carcinogen
X
Program Monographs No
X X
No No
or Potential Carcinogen
Emergency and
First Aid Procedures
As indicated below. Consult physician if necessary.
1. Inhalation
Remove to fresh air, if necessary seek medical attention.
2. Eyes
ROUTES
Flush with water, if necessary get medical attention.
OF 3. Skin
ENTRY Remove contaminated clothing, wipe off and wash skin with soap and water.
4. Ingestion
Give two glasses of water; do not induce vomiting; consult physician.
SECTION 7 -SPECIAL PRECAUTION AND SPILL/LEAK PROCEDURES
Precautions to be Taken
Use reasonable care. Do not store above 250潞F or near flammables. Do not breath vapor or mist. Wash hands after handling.
in Handling and Storage
Other
Toxic vapors may evolve above 550潞F; provide adequate ventilation if used above this temperature.
Precautions
Avoid spills; causes slippery surfaces. Avoid contamination of smoking materials.
Steps to be Taken in Case
Stop the source of the leak. Contain liquid to prevent further contamination of soil, surface water or ground water.
Material is Released or Spilled
Apply non-skid absorbent material to floor. Collect waste materials for salvage or disposal.
Waste Disposal
Methods (Consult federal, state, and local regulations)
Dispose of in accordance with current Federal, State, and Local Regulations.
SECTION 8 - SPECIAL PROTECTION INFORMATION/CONTROL MEASURES
Respiratory Protection
Not required unless product is being used as a mist.
(Specify Type)
Mechanical Special
Local Other
Ventilation
Good industrial Practice Recommended
Not required
Exhaust (General)
Protective Eye
Rubber Gloves
Gloves Safety glasses or goggles recommeneded.
Protection
Other Protective
Clothing or Equipment Plastic apron, fabric laboratory coat recommended.
Work/Hygienic Practices
Do not contaminate smoking materials; wash hands and/or contaminated area after exposure.
|