MATERIAL SAFETY DATA SHEET
MSDS IDENTIFICATION NAME: TYFO餂? F Paint DATE: Nov. 20, 1997 PAGE: 1 OF 3
SUPERSEDES MSDS: TYFO餂? F PAINT
MSDS NUMBER: TYFO-F00-01
SECTION I: MATERIAL AND MANUFACTURER IDENTIFICATION
MANUFACTURER: EMERGENCY TELEPHONE NUMBER:
FYFE CO., LLC 800-282-8200
6044 Cornerstone Court West Suite 鈥淐鈥? INFORMATION TELEPHONE NUMBER:
San Diego, CA 92121-4730 619-642-0694
PRODUCTION IDENTIFICATION NUMBER: TYFO餂? F
CHEMICAL FAMILY: Paint
SECTION II: HAZARDOUS INGREDIENTS / SARA III INFORMATION
OCCUPATIONAL EXPOSURE LIMITS
VAPOR PRESSURE WT
HAZARDOUS COMPONENTS GAS NO ACGIN TLV NOTE OSHA PEL mm Hg @ TEMP PCT
NO REPORTABLE QUANTITIES OF HAZARDOUS INGREDIENTS ARE PRESENT
Some ingredients are regulated as 鈥淣uisance Dusts鈥? in their powder form, they are integrally dispersed into the product and are not
present in the powder form in this product.
No toxic chemical(s) subject to the reporting requirements of Section 313 of Title III and 40 CFR 372 are present.
If you repackage or otherwise redistribute this material, you must provide an MSDS and written notice concerning the above SARA
Title III Section 313 and 40 CFR 372 reporting requirements to your customer and other end users.
SECTION III: PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING POINT 212掳F
1.2
SPECIFIC GRAVITY (H2O=1)
LIGHTER THAN AIR
VAPOR DENSITY
SLOWER THAN ETHER
EVAPORATION RATE
DILUTABLE
SOLUBILITY IN WATER
White, milky, viscous liquid with slight ammonia odor
APPEARANCE AND ODOR
SECTION IV: FIRE AND EXPLOSION HAZARD DATA
NONE METHOD USED:
FLASH POINT
LOWER: N/A UPPER: N/A
FLAMMABLE LIMITS IN AIR / VOLUME
FOAM., ALCOHOL FOAM, CO2, DRY CHEMICAL, WATER FOG
EXTINGUISHING MEDIA
SPECIAL FIREFIGHTING PROCEDURES: Closed containers exposed to extreme heat may rupture due to pressure buildup.
Cool storage drum with water spray. Fire fighters must use self contained breathing apparatus.
UNUSUAL FIRE AND EXPLOSION HAZARDS: None
MSDS NUMBER: TYFO-F00-01 DATE: Nov. 20,1997 PAGE 2 OF 3
SECTION V: REACTIVITY DATA
STABILITY: Stable
CONDITIONS TO AVOID: None noted for stability
HAZARDOUS DECOMPOSITION OF BYPRODUCTS: Combustion may yield carbon monoxide and / or carbon dioxide and
traces of monomer and hydrochloric acid.
HAZARDOUS POLYMERIZATION: Will not occur
SECTION VI : HEALTH AND HAZARD DATA
INHALATION HEALTH RISKS AND SYMPTOMS OF EXPOSURE: Breathing high concentrations of vapors or aerosols of
this product may cause irritation of the nose, throat and respiratory tract. Asthma-like conditions may be aggravated by exposure to
aerosols of this product.
SKIN AND EYE CONTACT HEALTH RISKS AND SYMPTOMS OF EXPOSURE: Mild irritant to eyes causing stinging,
tearing and redness on direct contact. This material is not expected to be a skin irritant.
SKIN ABSORPTION HEALTH RISKS AND SYMPTOMS OF EXPOSURE: No effects expected from skin exposure.
INGESTION HEALTH RISK AND SYMPTOMS OF EXPOSURE: While this material has a low degree of toxicity, ingestion of
large amounts may cause gastrointestinal irritation.
HEALTH HAZARDS (ACUTE AND CHRONIC): May cause local irritations to skin and mucous membranes. No chronic effects
noted.
CARCINOGENITY:
NPT: No IARC MONOGRAPHS: No OSHA REGULATED: No
A minor component of this product (residual monomer ) has been indicated as a possible human cancer hazard in laboratory animals.
It HAS NOT been identified as a carcinogen by NPT, IARC, or OSHA. Residual monomer content less than 0.2%.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURES: breathing vapors or spray mist may aggravate
asthma or similar respiratory conditions.
EMERGENCY AND FIRST AID PROCEDURES:
SKIN CONTACT: Wash exposed area with soap and water.
EYE CONTACT: Flush eyes with gentle stream of water. If redness or irritation persist, consult a physician.
INHALATION: None normally required. Move person to fresh air, seek medical advice if any unusual symptoms develop.
INGESTION: None normally required. If material is ingested, and unusual symptoms develop, consult a physician.
SECTION VII : PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Contain spilled material and collect in suitable
containers. Small amount of spilled material may be absorbed into inert absorbent. Prevent spilled liquid from entering sewers, storm
drains and natural waterways.
WASTE DISPOSAL METHOD: Dispose of product in accordance with all applicable Federal, State and local waste disposal
regulations. Best when used immediately, storage of six months or longer may affect physical properties of product.
MSDS NUMBER: TYFO-F00-01 DATE: Nov. 20,1997 PAGE 3 OF 3
SECTION VII : PRECAUTIONS FOR SAFE HANDLING AND USE (CONTINUED)
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING: Keep containers closed and in a cool, dry place. Use product
only with adequate ventilation, keep containers closed when not in use. Avoid subjecting product to extreme temperature variations
and / or freezing conditions. Coagulation may be caused by extreme shear or addition of other chemicals. Do not wear clothing before
wearing.
OTHER PRECAUTIONS: In general, minimal health and safety hazards are expected from the use of this material. When working
with any chemical compound, basic personal hygiene practices should be observed and unnecessary exposures avoided. Launder
contaminated clothing before wearing.
SECTION VIII : CONTROL MEASURES
RESPIRATORY PROTECTION: respiratory protection may be necessary to minimize exposure to vapors and spray mists,
depending on the nature and concentration of the airborne material. Use a respirator with appropriate NIOSH approved cartridges of
fresh air supply as needed.
VENTILATION: Mechanical ventilation to keep vapor concentrations below TLV and PEL. Use respirator if local and mechanical
ventilation is insufficient to minimize exposure.
PROTECTIVE GLOVES: Use of gloves is recommended.
EYE PROTECTION: Safety glasses or goggles with impermeable side shields is recommended.
OTHER PROTECTIVE CLOTHING AND EQUIPMENT: Apron or other impermeable clothing recommended to minimize skin
contact. Eye wash and safety shower in work areas is recommended.
WORK / HYGIENIC PRACTICES: Wash hands before eating, drinking or smoking. Open containers of food or drink should not
be allowed in work areas.
SECTION XVI: OTHER INFORMATION
SPECIAL PRECAUTIONS: Empty containers will retain some of the product residue. When handling of disposing of them, follow
all label warnings, other instructions and waste disposal procedures.
EXPLANATION AND DISCLAIMER: Wherever such words of phrases as 鈥渉azardous,鈥? 鈥渢oxic,鈥? 鈥渃arcinogen,鈥? etc. appear herein,
they are used as defined or described under state employee right-to-know laws, Federal OSHA laws or the or the direct sources for
these laws such as the International Agency for Research on Cancer (ISRC), the National Toxicology Program (NTP), ect. The use of
such words or phrases should not be taken to mean that we deem or imply any substance or exposure to be toxic, hazardous or
otherwise harmful. ANY EXPOSURE CAN ONLY BE UNDERSTOOD WITHIN THE ENTIRE CONTEXT OF ITS
OCCURRENCE, WHICH INCLUDES SUCH FACTORS AS THE SUBSTANCE鈥橲 CHARACTERISTICS AS DEFINED IN THE
MSDS, AMOUNT AND DURATION OF EXPOSURES, OTHER CHEMICALS PRESENT AND PREEXISTING INDIVIDUAL
DIFFERENCES IN RESPONSE TO THE EXPOSURE.
The data provided is based on the information received from our raw material suppliers and other sources believed to be reliable.
THIS DATA DOES NOT CONSTITUTE A GUARANTEE (EXPRESSED OF IMPLIED), WARRANTY (INCLUDING
WARRANTY WITHOUT LIMITATION, MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE ) OR
REPRESENTATION (INCLUDING FREEDOM FROM PATENT LIABILITY) BY US WITH RESPECT TO THE DATA, THE
PRODUCT DESCRIBED OR ITS USE FOR ANY SPECIFIC PURPOSE, EVEN IF THAT PURPOSE IS KNOWN TO US. WE
DISCLAIM LIABILITY FOR DAMAGE OR INJURY INCURRING DIRECTLY OR INDIRECTLY FROM THE USE OF THIS
PRODUCT.
Edward R. Fyfe
APPROVED AND AUTHORIZED BY:
|