Chem Alert Report Manufacturer's Material Safety Data Sheet
1. IDENTIFICATION OF THE MATERIAL AND SUPPLIER
CELOTEX MINERAL FIBRE CEILING PRODUCTS (HYTONE)
Product Name
Synonyms HYTONE, MINERAL FIBRE CEILING TILES.
Uses CEILING PANEL.
Supplier Name CSR LIMITED
Address 9 Help Street, Chatswood NSW, 2067, AUSTRALIA
Telephone +61 2 9235 8044; +61 2 235 8000
Fax +61 2 235 8044
Emergency 1800 807 668
2. HAZARDS IDENTIFICATION
CLASSIFIED AS HAZARDOUS ACCORDING TO NOHSC CRITERIA
NOT CLASSIFIED AS A DANGEROUS GOOD BY THE CRITERIA OF THE ADG CODE
3. COMPOSITION / INFORMATION ON INGREDIENTS
Ingredient Formula Conc. CAS No.
SLAG WOOL <50% Not Available
AMYLODEXTRIN STARCH <40% 9005-84-9
CLAY <20% Not Available
GUAR GUM <16% 9000-30-0
WAX <8% Not Available
4. FIRST AID MEASURES
Eye Flush gently with running water. Seek medical attention if irritation develops.
Inhalation If exposure occurs leave exposure area immediately. If irritation persists, seek medical attention.
Skin Remove contaminated clothing and gently flush affected areas with water. Seek medical attention if irritation
develops. Launder clothing before reuse.
Ingestion Ingestion is considered unlikely. For advice, contact a Poisons Information Centre on 13 11 26 (Australia Wide) or a
doctor.
Advice To Treat symptomatically.
Doctor
5. FIRE FIGHTING MEASURES
Flammability Non flammable. No fire or explosion hazard exists.
Fire and Non flammable. No fire or explosion hazard exists.
Explosion
Extinguishing Not applicable.
Hazchem Code None Allocated
Colour
Rating
AMBER
Copyright 漏 2005 RMT. The data contained herein is protected by copyright and may not be reproduced for any reason.
Printed by : RMT Page 1 of 5
Chem Alert Report Manufacturer's Material Safety Data Sheet
6. ACCIDENTAL RELEASE MEASURES
Spillage If product is damaged, seal and minimise fibre release. Wear dust-proof goggles, PVC/rubber gloves, a Class P2
(Particulate) respirator and coveralls. Clean area using approved micro-filter equipped vacuum cleaner or wet
sweep. Reuse where possible or place in a sealable plastic bag for safe disposal to an approved landfill.
7. HANDLING AND STORAGE
Handling Use safe work practices to avoid eye or skin contact and inhalation. Observe good personal hygiene. Prohibit eating,
drinking and smoking in contaminated areas. Wash hands before eating. Remove contaminated clothing and
protective equipment before entering eating areas.
Storage Store in cool, dry area, removed from foodstuffs. Ensure containers are labelled, protected from physical damage
and sealed when not in use.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Ventilation Use with adequate natural or mechanical ventilation during installation. If cutting, local extraction ventilation is
recommended. Clean area with micro equipped vacuum cleaner or by wet sweeping.
Exposure GUAR GUM (9000-30-0)
ES-TWA : 10 mg/m3
Standards
PPE Wear PVC or rubber gloves, dust-proof goggles, coveralls and a Class P2 (Particulate) Respirator. Use particular
caution during installation ie. whilst handling fibrous material and during cutting operations.
9. PHYSICAL AND CHEMICAL PROPERTIES
Appearance: WHITE PAINTED CEILING TILE
Odour: ODOURLESS
pH: NOT AVAILABLE
Vapour Pressure: NOT AVAILABLE
Vapour Density: NOT AVAILABLE
Boiling Point: NOT AVAILABLE
Melting Point: NOT AVAILABLE
Evaporation Rate: NON VOLATILE
Solubility (water): INSOLUBLE
Specific Gravity: 0.3 - 0.4
% Volatiles: NOT AVAILABLE
Flammability: NON FLAMMABLE
Flash Point: NOT RELEVANT
Upper Explosion Limit: NOT RELEVANT
Lower Explosion Limit: NOT RELEVANT
Autoignition Temperature: NOT AVAILABLE
10. STABILITY AND REACTIVITY
Reactivity Compatible with most commonly used materials.
Decomposition May evolve toxic gases if heated to decomposition.
Products
Colour
Rating
AMBER
Copyright 漏 2005 RMT. The data contained herein is protected by copyright and may not be reproduced for any reason.
Printed by : RMT Page 2 of 5
Chem Alert Report Manufacturer's Material Safety Data Sheet
11. TOXICOLOGICAL INFORMATION
Health Hazard Low to moderate toxicity. This product has the potential to cause adverse health effects from excessive exposure to
fibers from cutting - drilling - sanding of panels, or with poor handling techniques. Use safe work practices to avoid
Summary
fibre generation-inhalation. Mineral fibre is a reported experimental animal carcinogen and is classified as possibly
carcinogenic to humans (IARC Group 2B).
Eye Irritant. Exposure may result in lacrimation, irritation, pain and redness.
Inhalation Irritant. Exposure to fibres released during the installation process or with the use of power tools may result in upper
respiratory and mucous membrane irritation. Mineral fibre is classified as possibly carcinogenic to humans (IARC
Group 2B).
Skin Irritant. Contact with fibres may result in itching, pain, redness and skin rash.
Ingestion Not applicable. Due to product form, ingestion is considered highly unlikely.
Toxicity Data GUAR GUM (9000-30-0)
LD50 (Ingestion) : 6000 mg/kg (Hamster)
12. ECOLOGICAL INFORMATION
Environment Limited ecotoxicity data was available for this product at the time this report was prepared. Ensure appropriate
measures are taken to prevent this product from entering the environment.
13. DISPOSAL CONSIDERATIONS
Waste Place in sealed, appropriately labelled plastic bags and dispose of to landfill.
Disposal
Legislation Dispose of in accordance with relevant local legislation.
14. TRANSPORT INFORMATION
Transport Not classified as a Dangerous Good according to the Australian Code for the transport of Dangerous Goods by Road
and Rail.
UN Number None Allocated
DG Class None Allocated
Subsidiary None Allocated
Risk(s)
Packing Group None Allocated
Hazchem Code None Allocated
15. REGULATORY INFORMATION
Poison A poison schedule number has not been allocated to this product using the criteria in the Standard for the Uniform
Scheduling of Drugs and Poisons (SUSDP).
Schedule
16. OTHER INFORMATION
Additional GLASSWOOL (FIBREGLASS) - ROCKWOOL - MINERAL WOOL TILES: Please note that stringent standards are
required when installing fibrous glass and ceramic materials. NOHSC and Building Industry Standards and
Information
procedures exist for the use of these products.
Colour
Rating
AMBER
Copyright 漏 2005 RMT. The data contained herein is protected by copyright and may not be reproduced for any reason.
Printed by : RMT Page 3 of 5
Chem Alert Report Manufacturer's Material Safety Data Sheet
16. OTHER INFORMATION cont.
GLASSWOOL (FIBREGLASS) - MINERAL FIBRE: Worksafe exposure standards for synthetic mineral fibres are 0.5
fib/ml - TWA as respirable and 2.0 mg/m3 - TWA for inspirable fibres (> 3 microns). It should be noted that these
levels should be used as a guide only and all measures taken to keep levels as low as practicable.
RESPIRABLE FIBRES - If fibres have a diameter of less than 3 microns, length greater than 5 microns, and a length
to width ratio greater than 3:1, these are classified as 'respirable fibres'. When inhaled, respirable fibres are able to
reach the lower region of the lungs, where, depending on the chemical nature of the fibre(s), chronic health effects
may develop.
WORKSAFE AUSTRALIA SYNTHETIC MINERAL FIBRE: National Code of Practice. This code details minimum
requirements for the safe handling of mineral fibres. Issues such as training, air monitoring, application procedures
to reduce fibre release and personal protective equipment are detailed within. RMT recommend this publication be
referred to when developing site specific procedures.
ABBREVIATIONS:
mg/m3 - Milligrams per cubic metre
ppm - Parts Per Million
TWA/ES - Time Weighted Average or Exposure Standard.
pH - relates to hydrogen ion concentration - this value will relate to a scale of 0 - 14, where 0 is highly acidic and 14
is highly alkaline.
CAS# - Chemical Abstract Service number - used to uniquely identify chemical compounds.
M - moles per litre, a unit of concentration.
IARC - International Agency for Research on Cancer.
PERSONAL PROTECTIVE EQUIPMENT GUIDELINES:
The recommendation for protective equipment contained within this Chem Alert report is provided as a guide only.
Factors such as method of application, working environment, quantity used, product concentration and the
availability of engineering controls should be considered before final selection of personal protective equipment is
made. Information provided by Risk Management Technologies is summarised for ease of use. Additional technical
information is available by calling +61 8 9322 1711.
HEALTH EFFECTS FROM EXPOSURE:
It should be noted that the effects from exposure to this product will depend on several factors including: frequency
and duration of use; quantity used; effectiveness of control measures; protective equipment used and method of
application. Given that it is impractical to prepare a Chem Alert report which would encompass all possible
scenarios, it is anticipated that users will assess the risks and apply control methods where appropriate.
COLOUR RATING SYSTEM: Chem Alert reports are assigned a colour rating of Green, Amber or Red for the
purpose of providing users with a quick and easy means of determining the hazardous nature of a product. Safe
handling recommendations are provided in all Chem Alert reports so as to clearly identify how users can control the
hazards and thereby reduce the risk (or likelihood) of adverse effects. As a general guideline a Green colour rating
indicates a low hazard, an Amber colour rating indicates a moderate hazard and a Red colour rating indicates a high
hazard.
Report 11th October 2004
Reviewed
Date Printed 13th January 2005
Report Status Chem Alert reports are compiled as an independent source of information by RMT's scientific department, based on
the latest chemical and toxicological research and, where appropriate, in compliance with relevant standards,
guidance notes and legislation. Where available the manufacturer's original MSDS is also provided to Chem Alert
subscribers as a scanned image for their convenience. In many instances Chem Alert reports are compiled on
behalf of manufacturers in which case they serve as the "Manufacturer's MSDS" and are clearly identifed as such on
the relevant reports.
Prepared By Risk Management Technologies
5 Ventnor Avenue, West Perth
Western Australia 6005
Colour
Rating
AMBER
Copyright 漏 2005 RMT. The data contained herein is protected by copyright and may not be reproduced for any reason.
Printed by : RMT Page 4 of 5
Chem Alert Report Manufacturer's Material Safety Data Sheet
16. OTHER INFORMATION cont.
Phone: +61 8 9322 1711
Fax: +61 8 9322 1794
Web: www.rmt.com.au
Colour
Rating
AMBER
Copyright 漏 2005 RMT. The data contained herein is protected by copyright and may not be reproduced for any reason.
Printed by : RMT Page 5 of 5
|