AMALIE OIL COMPANY Compounding
Better than it has to be庐
Blending
1601 McCloskey Boulevard Blow Molding
Hookers Point - Tampa, Florida 33605-6710 U.S.A. Packaging
E-MAIL: info@amalie.com
www.amalie.com
Telephone: (813) 248-1988 Telecopier: (813) 248-1488
MATERIAL SAFETY DATA SHEETS
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
SM,SL, SJ/CF LUBRICATING JULY 2005
GENERIC NAME: ISSUE DATE:
MOTOR OIL
THIS MSDS REPRESENTS THE FOLLOWING AMALIE OIL CO. PRODUCTS:
PRO HIGH PERFORMANCE SYNTHETIC BLEND 50, 70, 5w20, 5w30, 10w30, 10w50, 20w50
MIXTURE
CAS NUMBER:
MOTOR OIL
SYNONYMS / GENERAL NAMES:
(CHEMTREC) 1-800-424-9300
24 HOUR EMERGENCY TELEPHONE:
1-800-388-1264
TECHNICAL INFORMATION:
2. COMPOSITION / INFORMATION ON INGREDIENTS / HAZARDOUS INGREDIENTS
COMPONENTS CAS NO. % HAZARD DATA
1) HIGHLY-REFINED SYNTHETIC BASE OILS MIXTURE 10 ORAL (LD50): >5000 mg/kg
2) HIGHLY REFINED PARAFFINIC PETROLEUM MIXTURE 75-80 DERMAL (LD50): >2000 mg/kg
OILS 10-25
3) PETROLEUM ADDITIVES MIXTURE <1
68649-42-3
4) ZINC ALKYLDITHIOPHOSPHATE
NONE
HAZARDOUS INGREDIENTS:
NO
HAZARDOUS PER 29 CFR 1916.1200:
3. HAZARDOUS IDENTIFICATION
SKIN CONTACT
ROUTES OF ENTRY:
SKIN
TARGET ORGANS:
THIS PRODUCT CAN CAUSE MILD, TRANSIENT, EYE IRRITATION WITH
IRRITANCY:
SHORT-TERM CONTACT WITH LIQUID OR SPRAYS.
N/A
REPRODUCTIVE EFFECTS:
THIS PRODUCT DOES NOT CONTAIN ANY COMPONENTS AT
CANCER INFORMATION:
CONCENTRATIONS ABOVE 0.1% WHICH ARE CONSIDERED CARCINOGENIC
BY OSHA, IARC, OR NTP.
4. FIRST AID MEASURES
CHECK FOR AND REMOVE CONTACT LENSES. FLUSH EYES WITH COOL, CLEAN, LOW-PRESSURE
EYES:
WATER WHILE OCCASIONALLY LIFTING AND LOWERING EYELIDS. SEEK MEDICAL ATTENTION IF
EXCESSIVE TEARING, REDNESS, OR PAIN PERSISTS.
REMOVE CONTAMINATED SHOES AND CLOTHING. WIPE OFF EXCESS MATERIAL. WASH EXPOSED SKIN
DERMAL:
WITH SOAP AND WATER. SEEK MEDICAL ATTENTION IF TISSUE APPEARS DAMAGED OR IF IRRITATION
PERSISTS. THOROUGHLY CLEAN CONTAMINATED CLOTHING BEFORE REUSE. DISCARD
CONTAMINATED LEATHER GOODS.
DO NOT INDUCE VOMITING UNLESS DIRECTED TO BY A PHYSICIAN. DO NOT GIVE ANYTHING TO DRINK
INGESTION:
UNLESS DIRECTED TO BY A PHYSICIAN. NEVER GIVE ANYTHING BY MOUTH TO A PERSON WHO IS NOT
FULLY CONSCIOUS. SEEK MEDICAL ATTENTION IMMEDIATELY.
MOVE VICTIM TO FRESH AIR. IF VICTIM IS NOT BREATHING, IMMEDIATELY BEGIN RESCUE BREATHING.
INHALATION:
IF BREATHING IS DIFFICULT, 100 PERCENT HUMIDIFIED OXYGEN SHOULD BE ADMINISTERED BY A
QUALIFIED INDIVIDUAL. SEEK MEDICAL ATTENTION IMMEDIATELY. KEEP THE AFFECTED INDIVIDUAL
WARM AND AT REST.
INJECTION OF PRESSURIZED HYDROCARBONS CAN CAUSE SEVERE, PERMANENT TISSUE DAMAGE.
INJECTION:
INITIAL SYMPTOMS MAY BE MINOR. INJECTION OF PETROLEUM HYDROCARBONS REQUIRES IMMEDIATE
MEDICAL ATTENTION.
___________________________________________________________________________________________________
NA - NOT APPLICABLE ND - NO DATA NE - NOT ESTABLISHED
Revision: N/A Printed: 10/28/2005 Page 1 of 4
5. FIRE FIGHTING MEASURES
FLASH POINT, 掳C( 掳F): 216掳C( 421掳F)
NO DATA NO DATA
FLAMMABLE LIMITS (% BY VOLUME): LOWER: UPPER:
USE DRY CHEMICAL, FOAM, CARBON DIOXIDE OR WATER FOG.
EXTINGUISHING MEDIA:
N/A
SPECIAL FIRE FIGHTING PROCEDURES:
N/A
AUTOIGNITION TEMPERATURE:
N/A
EXPLOSION DATA:
2 1 0
NFPA RATING: HEALTH: FLAMMABILITY: REACTIVITY
6. ACCIDENTAL RELEASE MEASURES
DO NOT TOUCH DAMAGED CONTAINERS OR SPILLED MATERIAL UNLESS WEARING
SPILL PROCEDURES:
APPROPRIATE PROTECTIVE EQUIPMENT. SLIPPING HAZARD; DO NOT WALK THROUGH
SPILLED MATERIAL. STOP LEAK IF YOU CAN DO SO WITHOUT RISK. FOR SMALL SPILLS,
ABSORB OR COVER WITH DRY EARTH, SAND, OR OTHER INERT NON-COMBUSTIBLE
ABSORBENT MATERIAL AND PLACE INTO WASTE CONTAINERS FOR LATER DISPOSAL.
CONTAIN LARGE SPILLS TO MAXIMIZE PRODUCT RECOVERY OR DISPOSAL. PREVENT ENTRY
INTO WATERWAYS OR SEWERS. IN URBAN AREA, CLEANUP SPILL AS SOON AS POSSIBLE. IN
NATURAL ENVIRONMENTS, SEEK CLEANUP ADVICE FROM SPECIALISTS TO MINIMIZE
PHYSICAL HABITAT DAMAGE. THIS MATERIAL WILL FLOAT ON WATER. ABSORBENT PADS
AND SIMILAR MATERIALS CAN BE USED. COMPLY WITH ALL LAWS AND REGULATIONS.
7. HANDLING AND STORAGE
AVOID WATER CONTAMINATION AND EXTREME TEMPERATURES TO MINIMIZE PRODUCT
HANDLING PROCEDURES:
DEGRADATION. EMPTY CONTAINERS MAY CONTAIN PRODUCT RESIDUES THAT CAN IGNITE
WITH EXPLOSIVE FORCE. DO NOT PRESSURIZE, CUT, WELD, BRAZE SOLDER, DRILL, GRIND
OR EXPOSE CONTAINERS TO FLAMES, SPARKS, HEAT OR OTHER POTENTIAL IGNITION
SOURCES. CONSULT APPROPRIATE FEDERAL, STATE AND LOCAL AUTHORITIES BEFORE
REUSING, RECONDITIONING, RECLAIMING, RECYCLING OR DISPOSING OF EMPTY
CONTAINERS AND/OR WASTE RESIDUES OF THIS PRODUCT.
KEEP CONTAINER CLOSED. DO NOT STORE WITH STRONG OXIDIZING AGENTS. DO NOT
STORAGE PROCEDURES:
STORE AT TEMPERATURES ABOVE 120掳F OR IN DIRECT SUNLIGHT FOR EXTENDED
PERIODS OF TIME. CONSULT APPROPRIATE FEDERAL, STATE AND LOCAL AUTHORITIES
BEFORE REUSING, RECONDITIONING, RECLAIMING, RECYCLING OR DISPOSING OF EMPTY
CONTAINERS OR WASTE RESIDUES OF THIS PRODUCT.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
PROVIDE EXHAUST VENTILATION OR OTHER ENGINEERING CONTROLS TO KEEP
ENGINEERING CONTROLS:
THE AIRBORNE CONCENTRATIONS OF MISTS AND/OR VAPORS BELOW THE
RECOMMENDED EXPOSURE LIMITS. AN EYE WASH STATION AND SAFETY
SHOWER SHOULD BE LOCATED NEAR THE WORK-STATION.
USE GLOVES CONSTRUCTED OF CHEMICAL RESISTANT MATERIALS SUCH AS
GLOVES PROTECTION:
NEOPRENE OR HEAVY NITRILE RUBBER IF FREQUENT OR PROLONGED CONTACT
IS EXPECTED. USE HEAT PROTECTIVE GLOVES WHEN HANDLING PRODUCT AT
ELEVATED TEMPERATURES.
SAFETY GLASSES EQUIPPED WITH SIDE SHIELDS SHOULD BE ADEQUATE
EYE PROTECTION:
PROTECTION UNDER MOST CONDITIONS OF USE. WEAR GOGGLES AND/OR FACE
SHIELD IF SPLASHING OR SPRAYING IS LIKELY, ESPECIALLY IF MATERIAL IS
HEATED ABOVE 125掳 F (OR 51掳 C). HAVE SUITABLE EYE WASH WATER AVAILABLE.
VAPORIZATION OR MISTING IS NOT EXPECTED AT AMBIENT TEMPERATURES.
RESPIRATORY PROTECTION:
THEREFORE, THE NEED FOR RESPIRATORY PROTECTION IS NOT ANTICIPATED
UNDER NORMAL USE CONDITIONS AND WITH ADEQUATE VENTILATION. IF
ELEVATED AIRBORNE CONCENTRATIONS ABOVE APPLICABLE WORKPLACE
EXPOSURE LEVELS ARE ANTICIPATED, A NIOSH-APPROVED ORGANIC VAPOR
RESPIRATOR EQUIPPED WITH A DUST/MIST PREFILTER SHOULD BE USED.
PROTECTION FACTORS VARY DEPENDING UPON THE TYPE OF RESPIRATOR
USED. RESPIRATORS SHOULD BE USED IN ACCORDANCE WITH OSHA
REQUIREMENTS (29 CFR 1910.134).
AVOID PROLONGED AND/OR REPEATED SKIN CONTACT, ESPECIALLY AFTER THIS
CLOTHING RECOMMENDATION:
PRODUCT HAS BEEN USED IN A CRANKCASE. IF SPLASHING OR SPRAYING IS
EXPECTED, CHEMICAL-RESISTANT (TYVEK庐, NITRILE, OR NEOPRENE)
PROTECTIVE CLOTHING SHOULD BE WORN. THIS MIGHT INCLUDE LONG-
SLEEVES, APRON, SLICKER SUIT, BOOTS, AND ADDITIONAL FACIAL PROTECTION.
IF GENERAL CONTACT OCCURS, PROMPLY REMOVE SOAKED CLOTHING AND
TAKE A SHOWER.
__________________________________________________________________________________________________
NA - NOT APPLICABLE ND - NO DATA NE - NOT ESTABLISHED
Revision: N/A Printed: 10/28/2005 Page 2 of 4
9. PHYSICAL AND CHEMICAL PROPERTIES
LIQUID
APPEARANCE:
MILD PETROLEUM ODOR
ODOR:
N/A
pH:
VAPOR PRESSURE, mm Hg (25 掳C): <0.0001
10+ (AIR =1)
VAPOR DENSITY:
NOT AVAILABLE.
MELTING POINT:
BOILING POINT, 760 mm Hg, 掳C: NOT AVAILABLE
INSOLUBLE IN COLD WATER.
SOLUBILITY IN WATER:
0.86 (WATER = 1)
SPECIFIC GRAVITY:
N/A
EVAPORATION RATE:
N/A
VISCOSITY 40掳C (100掳C)
N/A
MOLECULAR WEIGHT:
NEGLIGIBLE VOLATILITY
PERCENT VOLATILE:
10. STABILITY AND REACTIVITY
STABLE
STABILITY:
STRONG OXIDIZERS
INCOMPATIBILITY:
NOT EXPECTED TO OCCUR
POLYMERIZATION:
CO2, CO, SMOKE, FUMES, UNBURNED HYDROCARBONS AND TRACE OXIDES OF
THERMAL DECOMPOSITION:
SULFUR, NITROGEN, PHOSPHORUS AND ZINC.
11. TOXICOLOGICAL INFORMATION
THIS PRODUCT CAN CAUSE MILD, TRANSIENT, EYE IRRITATION WITH SHORT-
EYE IRRITATION:
TERM CONTACT WITH LIQUID OR SPRAYS.
THIS MATERIAL CAN CAUSE MILD, TRANSIENT SKIN IRRITATION WITH SHORT-
DERMAL IRRITATION:
TERM EXPOSURE.
NO SIGNIFICANT ADVERSE HEALTH EFFECTS ARE EXPECTED TO OCCUR UPON
INHALATION TOXICITY:
SHORT-TERM EXPOSURE TO THIS PRODUCT. ASPIRATION OF LIQUID INTO THE
LUNGS CAN CAUSE SEVERE LUNG DAMAGE OR DEATH.
IF SWALLOWED, NO SIGNIFICANT ADVERSE HEALTH EFFECTS ARE ANTICIPATED.
INGESTION IRRITATION:
INGESTION CAN CAUSE MILD IRRITATION TO THE DIGESTIVE TRACT OR CAUSE A
LAXATIVE EFFECT.
INJECTION UNDER THE SKIN, IN MUSCLE, OR INTO THE BLOOD STREAM CAN
INJECTION SENSITATION:
CAUSE IRRITATION, INFLAMMATION, SWELLING, FEVER, AND SYSTEMIC EFFECTS
AND MILD CENTRAL NERVOUS SYSTEM DEPRESSION. INJECTION OF
PRESSURIZED HYDROCARBONS CAN CAUSE SEVERE, PERMANENT TISSUE
DAMAGE. INITIAL SYMPTOMS MAY BE MINOR. INJECTION OF PETROLEUM
HYDROCARBONS REQUIRES IMMEDIATE MEDICAL ATTENTION.
PROLONGED OR REPEATED CONTACT CAN CAUSE MILD SKIN IRRITATION AND
CHRONIC EXPOSURE SYMPTOMS
INFLAMMATION CHARACTERIZED BY DRYING, CRACKING, (DERMATITIS) OR OIL
ACNE.
12. HEALTH INFORMATION
2 0
1 REACTIVITY:
HMIS CODE: HEALTH: FIRE:
HIGHLY TOXIC SENSITIZER
No No
TOXIC REPRODUCTIVE EFFECTS
No No
CORROSIVE MUTAGEN
No No
IRRITANT
No
13. DISPOSAL CONSIDERATIONS
It is the responsibility of the user to determine if the material is a hazardous waste at the time of
WASTE DISPOSAL:
disposal. Determine compliance status with all applicable requirements prior to disposal.
___________________________________________________________________________________________________
NA - NOT APPLICABLE ND - NO DATA NE - NOT ESTABLISHED
Revision: N/A Printed: 10/28/2005 Page 3 of 4
14. TRANSPORT INFORMATION
DOT (DEPARTMENT OF TRANSPORTATION)
PETROLEUM LUBRICATING OIL
PROPER SHIPPING NAME:
NOT A DOT CONTROLLED MATERIAL (UNITED STATES).
HAZARD CLASS:
HAZARD IDENTIFICATION NUMBER: N/A
N/A
DOT PLACARD:
N/A
COMPATIBILITY CATEGORY:
15. REGULATORY INFORMATION
SARA SECTION 313 - TOXIC CHEMICALS:
This product does not contain toxic chemicals under SARA Section 313 and 40 CFR Part 372.
COMPONENTS CAS # %
SARA SECTION 311 - HAZARD CATEGORIES:
This product may meet one or more of the criteria for the hazard categories defined in 40 CFR Part 370 as established be
Sections 311 and 312 of SARA as indicated below:
IMMEDIATE (ACUTE) HEALTH HAZARD SUDDEN RELEASE OF PRESSURE HAZARD
NO NO
DELAYED (CHRONIC) HEALTH HAZARD REACTIVE HAZARD
NO NO
FIRE HAZARD
NO
SARA SECTION 302 - EXTREMELY HAZARDOUS WASTE:
This product is not known to contain any components in concentrations greater than one percent that are listed as
Extremely Hazardous Substances in 40 CFR Part 355 pursuant to the requirements of Section 302(a) of SARA.
CLEAN WATER ACT (CWA):
Under the CWA, discharges of crude oil and petroleum products to surface water without proper Federal and State permits
must be reported immediately to the National Response Center at (800) 424-8802.
CERCLA HAZARDOUS SUBSTANCES:
As defined by CERCLA, the term 鈥渉azardous substance鈥? does not include petroleum, including crude oil or any fraction
thereof which is not otherwise specifically listed or designated as a hazardous substance.
U.S. TSCA INVENTORY
All components of this material are on the U.S. TSCA Inventory or are not required to be listed on the U.S. TSCA Inventory
16. OTHER INFORMATION
THE INFORMATION IN THIS MATERIAL SAFETY DATA SHEET SHOULD BE PROVIDED TO ALL WHO WILL USE, HANDLE, STORE,
TRANSPORT, OR OTHERWISE BE EXPOSED TO THIS PRODUCT. THIS INFORMATION HAS BEEN PREPARED FOR THE GUIDANCE
OF PLANT ENGINEERING, OPERATIONS AND MANAGEMENT AND FOR PERSONS WORKING WITH OR HANDLING THIS PRODUCT.
AMALIE OIL CO. BELIEVES THIS INFORMATION TO BE RELIABLE AND UP TO DATE AS OF THE DATE OF PUBLICATION, BUT
MAKES NO WARRANTY THAT IT IS.
least - 0 slight - 1 moderate - 2 high - 3 extreme - 4
NFPA HAZARD RATING
least - 0 slight - 1 moderate - 2 high - 3 extreme - 4
HMIS HEALTH RATING
NA - NOT APPLICABLE ND - NO DATA NE - NOT ESTABLISHED
Revision: N/A Printed: 10/28/2005 Page 4 of 4
|