MATERIAL SAFETY DATA SHEET
COMPLIES WITH OSHA'S HAZARD COMMUNICATION STANDARD (29 CFR 1910.1200)
SECTION I ?PRODUCT IDENTIFICATION
Product Name: SKIN SHIELD Formula: Proprietary HMIS Rating (Based on Aerosol Conc.):
Product Number: 855 Date Prepared: 06/27/06 0-Minimal 1- Slight 2- Moderate
Product Type: AEROSOL Emergency Phone: (800) 255-3924 3- Serious 4- Extreme
Supplier's Name: Terand Industries, Inc. Information Phone: (954) 974-5440 HEALTH: 0 FIRE: 0 REACTIVITY: 0
Supplier's Address: P.O. Box 667770 ?Pompano Beach, FL 33066 Personal Protection : A
D.O.T. Hazard Class: CONSUMER COMMODITY ?ORM-D
SECTION II ?INGREDIENTS
CHEMICAL NAME CAS # %WT 313/Chem Skin Carcinogen PEL TWA/TLV
Stearic Acid 57-11-4 01-05 NO NO NO N/E N/E
Polydimethylsiloxane 63148-62-9 01-05 NO NO NO N/E N/E
Propylene Glycol 57-55-6 01-05 NO NO NO N/E N/E
Triethanolamine 102-71-6 01-05 NO NO NO N/E N/E
Isopropyl Myristate 110-27-0 01-05 NO NO NO N/E N/E
Liquefied Petroleum Gas 68476-85-7 05-10 NO NO NO 1000ppm 1000ppm
SECTION III ?PHYSICAL DATA
Data Below Based On Aerosol Concentrate Only:
Boiling Point: ~ 212癋
pH: 8.0 Vapor Density(Air=1): >1
Solubility In Water: Complete Specific Gravity (H2O=1)@75癋: 1.00
Appearance/Odor: White Foam, Perfumed Scent
Data Below Based On Total Contents:
Vapor Pressure of can (psig @70癋): 64
Total VOC %: ~ 5%
SECTION IV ?FIRE AND EXPLOSION DATA
Flash Point (of Concentrate Only): None to Boiling (~212?F - T.O.C) Flammability (as per USA Flame Projection Test): Non-Flammable Spray
Extinguishing Media: Foam, CO2, Dry Media
Special Fire Fighting Procedures: Wear self-contained breathing apparatus and protective clothing. Cool fire exposed containers to prevent rupturing.
Unusual Fire and Explosion Hazards: Exposure to temperature above 120?F may cause bursting.
SECTION V ?REACTIVITY DATA
Stability: Material Stable. Hazardous Polymerization: Will not Occur.
Incompatibility: Avoid contact with strong oxidizing agents.
Hazardous Decomposition Products: Carbon Dioxide, Carbon Monoxide.
SECTION VI ?STORAGE AND HANDLING
KEEP OUT OF REACH OF CHILDREN.
For Industrial and Institutional use only.
Store in a cool, dry area away from heat or open flame.
Do not store at temperatures above 120?F. NFPA Code 30B Rating: Level 1 Aerosol.
SECTION VII ?HEALTH AND FIRST AID
PRIMARY ROUTES OF ENTRY & EFFECTS OF OVER EXPOSURE:
Eyes: May cause slight irritation but does not injure eye tissue.
Skin: None
Inhalation: None
Ingestion: Can cause gastrointestinal irritation, nausea, vomiting and diarrhea. Aspiration of material into the lungs can cause chemical pneumonitis. Minimal
toxicity.
FIRST AID PROCEDURES:
Eyes: Flush with large amounts of cool running water for at least 15 minutes while holding upper and lower lids open. If irritation persists get medical attention
immediately.
Skin: If, in rare cases, allergic reaction occurs, wash with soap and water. If irritation persists seek medical attention.
Inhalation: Remove to fresh air. Seek medical attention immediately. If breathing stops give artificial respiration.
Ingestion: Do not induce vomiting. Seek medical attention immediately.
SECTION VIII ?SPECIAL PROTECTION DATA
Respiratory Protection: None
Ventilation: None
Protective Gloves: None
Eye Protection: None needed unless it is anticipated that a splash or spray back will occur, then wear safety glasses or chemical proof goggles.
SECTION IX ?SPILL OR LEAK PROTECTION
STEPS TO BE TAKEN IN CASE OF SPILL OR LEAK: Allow propellant to evaporate. Maintain local exhaust and adequate ventilation. No smoking. Keep sparks,
heat sources and open flame far away from spill or leak. Cover with absorbent material and sweep up. Wash area to prevent slipping. Dispose of soaked absorbent
material in accordance with Federal, State and local laws.
WASTE DISPOSAL METHOD: Aerosol cans, when emptied and depressurized through normal use, pose no disposal hazard and should be recycled. Consult
Federal, State and local authorities for approved procedures.
N/A= NOT APPLICABLE ?N/E=NOT ESTABLISHED ?N/D=NOT DETERMINED ?<=LESS THAN ?>=MORE THAN
NOTICE: The information contained on this Material Safety Data Sheet is considered accurate as of the date of publication. It is not necessarily all inclusive nor fully adequate in every
circumstance. The suggestions should not be confused with, nor followed in vi olation of applicable laws, regulations, rules or insurance requirements. No warranty, express or implied, of
merchantability, fitness, accuracy of data, or the results to be obtained from the use thereof is made. The vendor assumes no responsibility for injury or damages resulting from the
inappropriate use of this product.