Permatex, Inc.
10 Columbus Blvd.
Hartford, CT 06106 USA
Telephone: 1-87-Permatex
(877) 376-2839
Emergency: 800-255-3924
International Emergency: +01-813-248-0585
Material Safety Data Sheet
1. PRODUCT IDENTIFICATION
Product Name: THE RIGHT STUFF GASKET MAKER 5 FL.OZ PROMO PAK
Item No: 99070
Product Type: Elastomeric rubber
2. COMPOSITION/INFORMATION ON INGREDIENTS
Component Weight% ACGIH; TLV-TWA OSHA PEL:
10 mg/m3
CALCIUM CARBONATE 25-50 Not Listed
471-34-1
POLY (DIMETHYLSILOXANE), 20-40 Not listed Not Listed
HYDROXY TERMINATED
70131-67-8
POLYDIMETHYLSILOXANE 5-20 Not listed Not Listed
63148-62-9
VINYL OXIMINOSILANE <5 Not listed Not Listed
2224-33-1
STEARIC ACID <3 Not listed Not Listed
57-11-4
2-BUTANONE OXIME 0.5-2.0 Not listed Not Listed
96-29-7
3. HAZARDS IDENTIFICATION
May cause eye and skin irritation. May irritate lips, gums, tongue, mouth, nose and throat. May be harmful
Toxicity:
if swallowed. ****When this product is exposed to moisture, methyl ethyl ketoxime may be formed. Note:
This product does not contain microcyrstalline silica.
Eye and skin contact, ingestion, inhalation
Primary Routes of Entry:
Methyl ethyl ketoxime produced during cure is toxic and irritates eyes, nose and throat Overexposure may
Signs and Symptoms of Exposure:
cause eye and skin redness
None known.
Medical Conditions Recognized as
Being Aggravated by Exposure:
4. FIRST AID MEASURES
Rinse mouth. If swallowed, DO NOT induce vomiting. Keep individual calm. Obtain medical attention.
Ingestion:
Move to fresh air in case of accidental inhalation of vapours. Obtain medical attention.
Inhalation:
Wipe off material with paper towel or cloth. Wash off with soap and water. If skin irritation persists, call a
Skin Contact:
physician.
In case of contact, immediately flush eyes with plenty of water for at least 15 minutes and get medical
Eye Contact:
attention if irritation persists.
5. FIRE FIGHTING MEASURES
>200癋 TCC
Flash Point 癋(C?:
Carbon Dioxide, Dry Chemicals, Foam.
Recommended Extinguishing Media:
Firefighters should wear self-contained breathing apparatus.
Special Fire-Fighting Procedures:
Formaldehyde, Silica fume, Oxides of carbon
Hazardous Products of Combustion:
None
Unusual Fire/Explosion Hazards:
Not determined
Lower Explosive Limit:
Not determined
Upper Explosive Limit:
6. ACCIDENTAL RELEASE MEASURES
Wipe or scrape up spill material. Maintain good ventilation for large spills. Place scrap material in a well-
Spill Procedures:
ventilated area and allow to cure to rubber. Clean up spills thoroughly as residue is slippery.
1 of 3
Product Name: THE RIGHT STUFF GASKET MAKER 5 Item No: 99070
FL.OZ PROMO PAK
7. HANDLING AND STORAGE
Store in a dry area below 90 degrees F. Keep container closed when not in use.
Storage:
Avoid contact with skin and eyes. Do not inhale vapors.
Handling:
8. EXPOSURE CONTROLS/PERSONAL PROTECTION
Safety glasses.
Eyes:
Neoprene or nitrile gloves recommended.
Skin:
General; local exhaust ventilation as necessary to control any air contaminants to within their exposure
Ventilation:
limits (or to the lowest feasible levels when limits have not been established) during the use of this
product.
Not required under normal use. An approved organic vapor respirator should be worn when exposures are
Respiratory Protection:
expected to exceed the applicable limits.
When heated to temperatures above 300 degrees F. in the presence of air, this product can form
Comments:
formaldehyde vapors. Formaldehyde is a potential cancer hazard and a known skin and respiratory
sensitizer. Safe handling conditions may be maintained by keeping vapor concentrations below the OSHA
permissible limit for formaldehyde
9. PHYSICAL AND CHEMICAL PROPERTIES
Black paste
Appearance:
MILD
Odor:
Not applicable, polymeric material
Boiling Point:
7-8
pH:
Polymerized
Solubility in Water:
1.34
Specific Gravity:
<4%
VOC Content(Wt.%):
<5 mmHg @ 70癋
Vapor Pressure:
3.0
Vapor Density (Air=1):
Slower than butyl acetate
Evaporation Rate:
10. STABILITY AND REACTIVITY
Stable at normal conditions
Chemical Stability:
WILL NOT OCCUR.
Hazardous Polymerization:
Strong oxidizers, Polymerized by contact with moisture
Incompatabilities:
Exposure to moisture
Conditions to Avoid:
Formaldehyde, Silica fume, Oxides of carbon
Hazardous Products of Combustion:
11. TOXICOLOGICAL INFORMATION
See Section 3
12. ECOLOGICAL INFORMATION
No data available
13. DISPOSAL CONSIDERATIONS
Recommended Method of Disposal: Disposal should be made in accordance with federal, state and local regulations.
NH - Not a RCRA Hazardous Waste Material
US EPA Waste Number:
14. TRANSPORTATION INFORMATION
DOT (49CFR 172)
Domestic Ground Transport
Unrestricted
DOT Shipping Name:
None
Hazard Class:
None
UN/ID Number:
IATA
Not regulated
Proper Shipping Name:
None
Class or Division:
None
UN/ID Number:
IMDG
Unrestricted
Proper Shipping:
2 of 3
Product Name: THE RIGHT STUFF GASKET MAKER 5 Item No: 99070
FL.OZ PROMO PAK
None
Hazard Class:
None
UN Number:
None
Marine Pollutant:
15. REGULATORY INFORMATION
SARA 313 Chemicals: The following component(s) is listed as a SARA Section 313 Toxic Chemical.
NONE
CALIFORNIA PROP 65:
No California Prop 65 chemicals are known to be present at or above the No Significant Risk Level.
TSCA Inventory Status:
Listed on Inventory: YES All components of this product are listed (or exempt) on the EPA TSCA inventory.
16. OTHER INFORMATION
HEALTH 1, FLAMMABILITY 1 , REACTIVITY 0.
Estimated NFPA Rating:
HEALTH 1, FLAMMABILITY 1, PHYSICAL HAZARD 0
Estimated HMIS Classification:
NFPA is a registered trademark of the National Fire Protection Assn.
HMIS is a registered trademark of the National Paint and Coatings Assn.
Denise Boyd, Manager-Environmental, Health & Safety
Prepared By: Revision Date: January/12/2007
Permatex. Inc. 10 Columbus Blvd. Hartford, CT USA 06106 5
Company: Revision
Number:
3 of 3
|