Material Safety Data Sheet
According to 91/155/EEC and OSHA Hazard Communication Std. 29CFR1910.1200
1. CHEMICAL PRODUCT AND COMPANY IDENTIFICATION:
Commercial Product Name: POWR-CLEAN HD
Company: Power Coolant & Chemical, LLC
15619 Frohock Place
Charlotte, NC 28277
Phone: 1-704-759-3435
Fax: 1-704-759-1989
Emergency Telephone Number: 1-313-933-1500
2. COMPOSITION/INFORMATION ON INGREDIENTS:
Ingredient CAS # % weight Exposure Limits
1.) 2-Hydroxyethlamine 141-43-5 5-10 7.5 mg/m3
2.) Triethanolamine 102-71-6 11-5 5.0 mg/m3
3.) Boric Acid 10043-35-3 1-5 NE
4.) Dibasic Acid Mixture 72162-23-3 <5 NE
5.) Edetic acid 60-00-4 <5 NE
6.) Alkylether hydroysultaine 108797-84- <5 NE
8
7.) Water 7732-18-5 > 55 NE
8.)
3. HAZARDS IDENTIFICATION:
Emergency Overview: Clear light amber liquid, slight amine odor. Concentrate can cause eye
and skin damage.
Inhalation: Not expected to be a relevant route of exposure. However, high vapor
or aerosol mist concentrations may be irritating to the nose, throat, and
upper respiratory tract.
Skin: Prolonged contact may cause irritation and/or defatting
Ingestion: Will causes severe gastric distress, and possible mucosal damage. May cause
nausea and vomiting.
Eye Contact: Concentrate may cause irritation and cornea damage. Dilute (ready to use)
material is an irritant.
POWR-CLEAN HD Page 2 0f 5
Date: 09/16/09
4. FIRST AID MEASURES:
Eye Contact: Immediately flush eyes with plenty of water for at least 15 minutes
while holding eyelids open. Get medical attention.
Skin Contact: Flush skin with plenty of water for at least 15 minutes. If irritation persists, get
medical attention.
Inhalation: Remove individual to fresh air. Usually no further problem excepted.
Ingestion: Wash mouth thoroughly with water. Give large quantities of milk or water to
drink. Induce vomiting and repeat until clear. Seek medical attention. Never
give anything by mouth to an unconscious person.
5. MEASURES FOR FIRE FIGHTING:
Flash Point (Typical) Not Applicable
Autoignition Temperature None
Upper Flammable Limit None
Lower Flammable Limit none
Products of Combustion Mainly oxides of carbon and sulfur with small amounts of
other unidentified organic compounds.
Extinguishing Media Water Fog, Dry Chemical, Foam
Firefighting Procedures No special procedures required.
Unusual Fire and Explosion
Hazards None.
Explosion Data Material does not have explosive properties.
Flush spillage to sewer or treatment plant. Clean area well.( no free caustic present in the
material). Follow all state, federal and local regulations.
POWR-CLEAN HD Page 3 0f 5
Date: 09/16/09
7. HANDLING AND STORAGE:
Storage temperature (oC) 0-40
Storage Precautions None.
Suitable materials/Coatings All plastics, and most common metals
Unsuitable Materials None.
Storage Procedures Keep containers closed when not in use. Wash thoroughly after
handling. Empty containers contain product residue that may
exhibit hazards of product. No special storage procedures
required.
8. EXPOSURE CONTROLS AND PERSONAL PROTECTION:
Ventilation Procedures Use with adequate ventilation. Avoid breathing mists or spray
formed during machining operations.
Hand Protection Use nitrile or neoprene gloves.
Eye Protection Use chemical safety glasses with side shields.
Respiratory Protection Under normal conditions of use, respirator is not required.
Clothing Industrial overalls would be suitable, but protection of forearms
is recommended.
9. TYPICAL PHYSICAL AND CHEMICAL PROPERTIES:
Appearance Clear light amber liquid
Solubility Completely dispersible in water.
Odor Slight amine
Specific Gravity 1.05?.05
pH neat 9.7?.5
Boiling Point >210F
Vapor Pressure N/D
Vapor Density N/D
10. STABILITY AND REACTIVITY:
Stability Material is normally stable at moderately elevated temperatures
and pressures.
Incompatibility Strong oxidizing agents.
Hazardous Polymerization Will not occur.
Hazardous Decomposition
Products: Carbon monoxide and other oxides of carbon may be formed.
POWR-CLEAN HD Page 4 0f 5
Date: 09/16/09
11. TOXICOLOGICAL INFORMATION:
Eyes: May cause eye damage.
Skin: May cause chemical irritation with prolonged contact with skin
Respiratory: If material is misted or if exposure to vapors generated through heating
occurs, irritation of mucous membranes and upper respiratory tract may
occur. Under normal standards of industrial hygiene irritation should not
occur.
Oral LD50: Not Determined
Dermal LD50: Not Determined
Chronic Toxicity: No data available to indicate product or components present at greater
than 1% are chronic health hazards.
Carcinogenicity: No data available to indicate product or components present at greater
than 0.1% present a carcinogenic hazard.
Mutanogenicity: No data available to indicate product or components present at greater
than 0.1% are mutagenic or genotoxic.
Teratogenicity: No data available to indicate product or components present at greater
than 0.1% may cause birth defects.
Occupational Exposure
Limits: Under conditions which may generate mists observe the OSHA PELof
5mg/m3 and ACGIH STEL of 10mg/m3.
Other: No other health hazard known.
12. ECOLOGICAL INFORMATION:
Do not allow access to natural waterways. Dispose of properly.
13. DISPOSAL CONSIDERATIONS:
Product: As chemical waste in accordance with federal, state, and local
regulations.
Packaging, Empty: Uncleaned containers should be recycled or disposed of.
Receiver of container should be informed about the possible
hazards as described in this Material Safety Data Sheet.
14. TRANSPORT INFORMATION:
This product is not considered hazardous for transport by D.O.T.
S.A.R.A. Title III section 311 and 312
This product is classified as a minimal health hazard.
S.A.R.A. Title III section 313
The following chemicals are present at or above de minimis concentrations in the
product: NONE
CERCLA section 103
The following chemical(s) are present in this product:
None.
TSCA Inventory Status
The components of this product are listed or are exempt from the Toxic
Substances Control Act (TSCA) Chemical Substance Inventory.
16. FURTHER DATA:
None.
All data in this Safety Data Sheet is based on present state of our knowledge and
experience. They are to characterize our product with regards to any possible safety
requirements. We do, however, pass them on to you without any warranty or property
assurances.