EMERGENCY PHONE: 1-800-424-9300 Chemtrec
INTERNATIONAL TRANSPORTATION ACCIDENTS: 1-703-527-3887 Chemtrec
I. CHEMICAL PRODUCT IDENTIFICATION
Product Name : 030L White Strippable Booth Coating
03/18/08
Date Printed :
03/18/08
Revision Date : Revision Number : 1
Supercedes : None CHEMCO INFO:800-323-0431 WWW.CHEMCOMFG.COM
II. COMPOSITION/INFORMATION ON INGREDIENTS - (EXPOSURE LIMITS - SEE SECTION VIII)
INGREDIENT NAME CAS # %
Water - for information only 7732-18-5 50.01 - 75.00
Titanium dioxide 13463-67-7 1.01 - 5.00
Triethanolamine 102-71-6 1.01 - 5.00
If ingredient percentages do not total 100%, the balance is due to rounding or applies to ingredient(s) deemed nonhazardous under 29 CFR 1910.1200 (Hazard Communication Standard).
III. HAZARDS IDENTIFICATION
HMIS
2
HEALTH
1
FLAMMABILITY
0
REACTIVITY
0 = Least 1 = Slight 2 = Moderate 3 = High 4 = Extreme * = Chronic Health Effects
Routes of Entry: Inhalation, Ingestion, Skin contact, Eye contact.
Lung disease.
Medical Conditions Aggravated:
Immediate (Acute) Health Effects:
Can cause moderate respiratory irritation, dizziness, weakness, fatigue, nausea and headache.
Inhalation:
Can cause moderate skin irritation, defatting, and dermatitis. Not likely to cause permanent damage.
Skin Contact:
Contact with the eyes may cause moderate to severe eye injury. Eye contact may result in tearing and
Eye Contact:
reddening, but not likely to permanently injure eye tissue. Temporary vision impairment (cloudy or
blurred vision) is possible.
No absorption hazard in normal industrial use.
Skin Absorption:
Not normally toxic by ingestion. Can cause abdominal discomfort, nausea, vomiting and diarrhea.
Ingestion:
Respiratory System.
Target Organ Acute Toxicity:
Long-Term (Chronic) Health Effects:
Upon prolonged and/or repeated exposure, can cause moderate respiratory irritation, dizziness,
Inhalation:
weakness, fatigue, nausea and headache.
Upon prolonged or repeated contact, can cause moderate skin irritation, defatting, and dermatitis. Not
Skin Contact:
likely to cause permanent damage.
Upon prolonged or repeated contact, can cause moderate to severe eye injury. Eye contact may result
Eye Contact:
in tearing and reddening, but not likely to permanently injure eye tissue. Temporary vision impairment
(cloudy or blurred vision) is possible.
Upon prolonged or repeated exposure, no hazard in normal industrial use.
Skin Absorption
CHEMCO MFG. CO., INC. 515 HUEHL ROAD, NORTHBROOK, IL 60062 PH:800-323-0431 WWW.CHEMCOMFG.COM
Page 1 of 4
IARC: No NTP: No OSHA: No
Carcinogenicity:
Respiratory Tract.
Target Organ Chronic Toxicity:
NOTICE - Reports have associated repeated and prolonged occupational overexposure to solvents with
brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the
contents may be harmful or fatal.
IV. FIRST AID
Remove to fresh air. If breathing is difficult, have a trained individual administer oxygen. Seek
Inhalation:
medical attention if symptoms persist.
Immediately flush eyes with plenty of luke warm water for at least 20 minutes retracting eyelids often.
Eyes:
Tilt the head to prevent chemical from transferring to the uncontaminated eye. Get immediate medical
attention and monitor the eye daily as advised by your physician.
Wash with soap and water. Remove contaminated clothing and launder. Get medical attention if
Skin Contact:
irritation develops or persists.
Seek medical advice immediately. Provide ingredients information from Section II of this MSDS to
Ingestion:
the medical care provider. Contact your local Poison Control Center (listed in the telephone book), or
dial the local "Emergency" (911) number for additional information. Do not induce vomiting unless
instructed to do so by a physician or other competent medical personnel. Never give anything by
mouth to an unconscious person.
V. FIRE FIGHTING MEASURES
Liquid material not combustible
Flammability Summary:
N/A
Flash Point:
N/A
Autoignition Temperature:
1.3 8.5
Lower Flammable/Explosive Limit, % in air: Upper Flammable/Explosive Limit, % in air:
Material may be ignited only if preheated to temperatures above the high flash point, for example in a
Fire Hazards:
fire.
Use alcohol resistant foam, carbon dioxide, or dry chemical when fighting fires. Water or foam may
Extinguishing Media:
cause frothing if liquid is burning but it still may be a useful extinguishing agent if carefully applied to
the surface of the fire. Do Not direct a stream of water into the hot burning liquid.
Do not enter fire area without proper protection including self- contained breathing apparatus and full
Fire Fighting Instructions:
protective equipment.
Carbon dioxide, Carbon monoxide, Nitrogen containing gases.
Hazardous Combustion Products:
VI. ACCIDENTAL RELEASE MEASURES
Exposure to the spilled material may be irritating or harmful. Follow personal protective equipment
Health Consideration for Spill Response:
recommendations found in Section VIII of this MSDS. Additional precautions may be necessary based
on special circumstances created by the spill including: the material spilled, the quantity of the spill,
and the area in which the spill occurred. Also consider the expertise of employees in the area
responding to the spill. Isolate area. Keep unnecessary personnel away.
CHEMCO MFG. CO., INC. 515 HUEHL ROAD, NORTHBROOK, IL 60062 PH:800-323-0431 WWW.CHEMCOMFG.COM
Page 2 of 4
Spill Mitigation Procedures:
Prevent the spread of any spill to minimize harm to human health and the environment if safe to do so.
General Methods:
Wear complete and proper personal protective equipment following the recommendation of Section
VIII at a minimum. Dike with suitable absorbent material like granulated clay. Gather and store in a
sealed container pending a waste disposal evaluation.
Ventilate the area by opening door and/or turning on fans and blowers.
Air Release:
Retain all contaminated water for treatment.
Water Release:
Avoid runoff into storm sewers and ditches that lead to waterways.
Land Spills:
VII. HANDLING AND STORAGE
Harmful or irritating; avoid overexposure to the material. Use only in a well ventilated area. As with
Handling:
all chemicals, good industrial hygiene practices should be followed when handling this material. Do
not get in eyes, on skin and clothing. Remove contaminated clothing and wash before reuse.
Store in a cool dry place. Isolate from incompatible materials. Keep container closed when not in use.
Storage:
Store in a cool place in original container and protect from sunlight
VIII. ENGINEERING CONTROLS, PERSONAL PROTECTIVE EQUIPMENT, AND EXPOSURE LIMITS
Local exhaust ventilation, process enclosures, or other engineering controls are necessary when
Engineering Controls:
handling or using this product to avoid overexposure.Engineering controls must be designed to control
vapor concentrations to below levels published in 29 CFR 1910.1000. Use process enclosures, local
exhaust ventilation, or other engineering controls to control airborne levels below recommended
exposure limits.
Protective Equipment:
If general or local exhaust ventilation is not available or sufficient to reduce exposure to below
Respiratory Tract:
acceptable levels, then respiratory protection is required to avoid overexposure when handling this
product.
Wear safety glasses with side shields when handling this product. When the possibility exists for eye
Eyes:
contact with splashing or spraying liquid, or airborne material, wear additional eye protection such as
chemical splash goggles and/or face shield . Do not wear contact lenses. Have an eye wash station
available.
Wear protective gloves. Inspect gloves for chemical break-through and replace at regular intervals.
Skin:
Clean protective equipment regularly. Wash hands and other exposed areas with mild soap and water
before eating, drinking, and when leaving work.
Wear chemically resistant gloves and apron. (Consult your safety equipment supplier).
Protective Clothing:
CHEMICAL NAME CAS ACGIH TLV OSHA PEL IDLH
#
Water - for information only 7732-18-5 No TLV No PEL established Not determined.
Titanium dioxide 13463-67-7 10 mg/m3 TWA 15 mg/m3 TWA (total dust) 5,000 mg/m3 IDLH
Triethanolamine 102-71-6 5 mg/m3 TWA No PEL established Not determined.
IX. PHYSICAL DATA
White Liquid.
Appearance:
White
Color:
N/A
pH:
Not Determined.
Octanol/Water Coeff:
Complete.
Solubility in Water:
N/A
Vapor Density:
CHEMCO MFG. CO., INC. 515 HUEHL ROAD, NORTHBROOK, IL 60062 PH:800-323-0431 WWW.CHEMCOMFG.COM
Page 3 of 4
Not determined
Evaporation Rate:
1.068 / 8.91 Lbs./Gl.
Specific Gravity/Density:
0.5 Lbs/Gl less water & 60 g/l less water & 0.2 Lbs/Gl as
V.O.C.
exempt solvent; exempt solvent; packed
The VOC content is determined by using a percent solids basis, less water and exempt solvents, for adhesives, coatings and inks and the calculations of EPA
Reference Method 24 or equivalent ASTM method approved by the executive office.
100 ?C; 212 ?F
Initial Boiling Point:
0 ?C; 32 ?F
Initial Freezing Point:
X. STABILITY AND REACTIVITY
Stable under normal conditions.
Stability Information:
Temperatures above the high flash point of this combustible material in combination with sparks, open
Conditions to Avoid:
flames, or other sources of ignition.Contamination., Contact with air, Visible lightDo not freeze.
Acids, Aldehydes, Copper, Copper alloys, Strong acids, Strong alkalies.
Chemical Incompatibility:
Carbon dioxide, Carbon monoxide, Nitrogen containing gases.
Hazardous Decomposition Products:
XI. TOXICOLOGICAL INFORMATION
Chemical Name LD50/LC50
Ethanol, 2,2',2''-nitrilotri- Oral LD50 Rat : 4920 uL/kg; Oral LD50 Mouse : 5846 mg/kg; Dermal LD50 Rabbit : >20 mL/kg
XII. ECOLOGICAL INFORMATION
Care should be taken to minimize releases of any industrial chemicals to the environment.
Overview:
XIII. DISPOSAL CONSIDERATIONS
Spent or discarded material is not expected to be a hazardous waste.
Waste Description for Spent Product:
Information in this MSDS is provided only as a guide. Consult with competent authority to determine
Disposal Methods:
proper waste disposal procedures. Clean up and dispose of waste and clean-up materials in accordance
with all federal, state, and local environmental regulations.
Not determined., .
Potential EPA Waste Codes:
Some Components Possibly Subjected to USEPA Land Disposal Restrictions:
When disposing of unused products or any waste, the preferred options are to send to a licensed reclaimer or to permitted incinerators. There may be some other ingredients subject to LDR categories.
None expected.
XIV. TRANSPORTATION INFORMATION
Agency Basic Description and Label
Not regulated per DOT.
DOT
Hazardous Substance
None expected.
XV. REGULATORY INFORMATION
Regulation
SARA 313 Reportable : This product contains no Section 313 chemicals at or above de minimis values.
TSCA Inventory : All components of this product are listed in, or exempt from, the TSCA 8(b) Inventory.
California Proposition 65 : The following statement is made in order to comply with the California Safe Drinking Water and Toxic Enforcement Act of 1986 -
Proposition 65: "WARNING: This product contains chemical(s) known to the State of California to cause cancer."
XVI. ADDITIONAL INFORMATION
Major References: VENDOR'S MSDS's, PAINT & COATINGS HANDBOOK, EPA's LIST OF LISTS, AND OTHER PUBLISHED MATERIALS.
IMPORTANT: WHILE THE DESCRIPTIONS, DATA AND INFORMATION CONTAINED HEREIN ARE PRESENTED IN GOOD FAITH AND BELIEVED TO BE ACCURATE, THEY ARE
PROVIDED FOR YOUR GUIDANCE ONLY. BECAUSE MANY FACTORS MAY AFFECT PROCESSING OR APPLICATION/USE, WE RECOMMEND THAT YOU PERFORM AN ASSESSMENT TO
DETERMINE THE SUITABILITY OF A PRODUCT FOR YOUR PARTICULAR PURPOSE PRIOR TO USE. NO WARRANTIES OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING
CHEMCO MFG. CO., INC. 515 HUEHL ROAD, NORTHBROOK, IL 60062 PH:800-323-0431 WWW.CHEMCOMFG.COM
Page 4 of 4
FITNESS FOR A PARTICULAR PURPOSE, ARE MADE REGARDING PRODUCTS DESCRIBED, DATA OR INFORMATION SET FORTH. IN NO CASE SHALL THE DESCRIPTIONS,
INFORMATION, OR DATA PROVIDED BE CONSIDERED A PART OF OUR TERMS AND CONDITIONS OF SALE. FURTHER, THE DESCRIPTIONS, DATA AND INFORMATION FURNISHED
HERE ARE GIVEN GRATIS. NO OBLIGATIONS NOR LIABILITIES FOR THE DESCRIPTION, DATA AND INFORMATION GIVEN ARE ASSUMED. ALL SUCH BEING GIVEN AND ACCEPTED
AT YOUR RISK.
CHEMCO MFG. CO., INC. 515 HUEHL ROAD, NORTHBROOK, IL 60062 PH:800-323-0431 WWW.CHEMCOMFG.COM
Page 5 of 4
|