IPATOP HF
Product Trade Name: Page 1 of 4
Material Safety Data Sheet
Revision Date: 8/14/00 NA = Not Applicable NE = Not Established
Section 1. General Information
Product Name: IPATOP HF (High Flow)
Chemical Family: Cements
Manufacturer: IPA Systems, Inc.
2745 North Amber Street, Philadelphia, Pa. 19134
Phone: 800-523-3834 ?215-425-6607
Fax: 215-425-6234
E-mail: info@ipasystems.com
Website: www.ipasystems.com
HMIS Rating: Health: 2
Fire: 0
Reactivity: 1
Personal Protection: E
UN Hazard Class: Not regulated
Emergency Phone Number - Chemtrec: 800-424-9300
Section 2. Hazardous Ingredients
Principal Hazardous Components: C.A.S. Reg. No. Percent Threshold Limit Value (units)
0.1 mg/m3 resp.
Crystalline Silica (SD) 14808-60-7 < 65
5 mg/m3 resp., 10 mg/m3 total
Portland Cement (PC) 65997-15-1 < 25
10 mg/m3
Calcium Sulfate (CS) 7778-18-9 <5
2 mg/m3
Calcium Oxide (COx) 1305-78-8 <5
Section 3. Physical Data
Boiling Point (F): NA Specific Gravity: (H2O = 1): 2.8
Vapor Pressure (mm Hg.): NA Percent Volatile by Volume: NA
Vapor Density (Air = 1): NA Evaporation Rate: NA
Solubility in Water: pH: NA
Volatile Organic Compounds: 0
Appearance and Odor: Grey powder, no odor
01/08
IPATOP HF
Product Trade Name: Page 2 of 4
Material Safety Data Sheet
Revision Date: 8/14/00 NA = Not Applicable NE = Not Established
Section 4. Fire and Explosion Hazard Data
Flash Point: NA Auto Ignition Temperature: NA
Flammable Limits: LEL = NA UEL = NA
Extinguishing Media: CO2, dry chemical, water or fog
Special Fire Fighting Procedures: Firefighters should use pressure demand MSHA/NIOSH approved self-contained
breathing apparatus, protective clothing and full emergency equipment.
Unusual Fire & Explosion Hazards: This product is alkaline and releases considerable heat on contact with small
amounts of water. Avoid contact between resulting hot alkaline paste and metallic aluminum. Such contact could
generate hydrogen gas.
Section 5. Health Hazard Data
0.1 mg/m3 resp. ?SD 0.1 mg/m3 ?SD
OSHA PEL: ACGIH TLV:
5 mg/m3 resp., 10 mg/m3 total ?PC 5 mg/m3 resp., 10 mg/m3 total ?PC
10 mg/m3 resp. ?CS 10 mg/m3 ?CS
2 mg/m3 ?COx 2 mg/m3 ?COx
Carcinogen ?NTP Program: Yes (SD) Carcinogen ?IARC Program: Yes (SD)
Symptoms of Exposure: Acute ?Material can severely irritate the eyes. If not removed promptly, will injure eye
tissue and may result in permanent damage. Material may irritate skin and upper respiratory system. If
swallowed, material will irritate mouth, throat and stomach.
Chronic ?Cement dust can cause inflammation of the lining tissue of the interior of the nose and inflammation of
the cornea. Hypersensitive people may develop dermatitis. (Cement may contain traces of hexavalent
chromium.) This product contains silicon dioxide (quartz), which has been listed as a suspected human
carcinogen by NTP and IARC. Repeated or prolonged exposure to silica dust may cause permanent lung
damage and cancer (Silicosis).
Medical Conditions Aggravated by Exposure: Dermatitis.
Routes of Entry: Eye Contact, Skin Contact, Inhalation, Ingestion.
Emergency and First Aid Procedures:
Eye Contact: Flush eyes with water for at least 15 minutes. Get medical attention immediately.
Skin Contact: Remove contaminated clothing. Wash affected areas of the body immediately with soap and water. If
any symptoms occur, get medical attention.
Inhalation: Immediately remove victim to fresh air. Give oxygen or artificial respiration as needed. Get medical
attention immediately.
If Swallowed: Do not induce vomiting. Give victim a glass of water or milk. Never give anything to drink to an
unconscious person. Immediately contact a physician or poison control center. If vomiting occurs, be sure to
keep victim's head lower than hips to avoid aspiration of vomitus into lungs.
01/08
IPATOP HF
Product Trade Name: Page 3 of 4
Material Safety Data Sheet
Revision Date: 8/14/00 NA = Not Applicable NE = Not Established
Section 6. Reactivity Data
Stability: Stable
Conditions to Avoid: Keep dry until ready to use.
Incompatibility (Materials to Avoid Contact): Strong bases or oxidants. Strong Lewis or mineral acids.
Hazardous Decomposition or By-Products: Acrid fumes. Oxides of carbon.
Hazardous Polymerization: Will not occur under normal conditions.
Section 7. Procedures for Safe Handling and Use
Spill Response: Vacuum or sweep up material and place in a disposal container. Do not disperse the dust into the
air. Wear dust/mist mask or other appropriate protection to avoid breathing the dust. Ventilate the area. Keep
material out of surface waters, sewers and waterways entering or leading to surface waters.
Waste Disposal Method: Flush spill with excess water to a chemical sewer or soak up with inert absorbent. Always
dispose of waste according to local, state and federal regulations.
Other Precautions: See all other sections of this MSDS. Keep out of reach of children. Keep container closed when
not in use.
Section 8. Control Measures
Respiratory Protection: Concentrations greater than the TLV can occur when mixed or applied in a poorly ventilated
area. Use MSHA/NIOSH approved air respirator when concentrations are expected to exceed the TLV. (See
OSHA 29 CFR 1910.134) Avoid breathing vapors, mists, fumes and airborne dusts.
Ventilation: Local exhaust recommended to prevent build-up above the TLV during use.
Skin Protection: Use chemical resistant gloves and protective clothing to protect skin from contact.
Eye Protection: Use chemical safety goggles with face shield to prevent eye contact.
Other Protection: Avoid contact with eyes, skin and clothing. Wash thoroughly before eating. Wash contaminated
clothing before reuse.
Section 9. Special Precautions
Hygienic Practices in Handling and Storage: This product may contain 30 - 80% silica sand, a portion of which may
be respirable dust. In its dry state, refrain from inhalation of dust to prevent possible free silica exposure.
Precautions for Repair and Maintenance of Contaminated Equipment: NA
Other Precautions: Store material in a cool, dry place.
01/08
IPATOP HF
Product Trade Name: Page 4 of 4
Material Safety Data Sheet
Revision Date: 8/14/00 NA = Not Applicable NE = Not Established
Section 10. Regulatory Information
OSHA: Hazardous by definition of Hazard Communication Standard (29 CFR 1910.1200)
CERCLA SARA Hazard Category:
This product has been reviewed according to the EPA "Hazard Categories" promulgated under Sections 311 and
312 of the Superfund Amendment and Reauthorization Act of 1986 (SARA / Title III) and is considered, under
applicable definitions, to meet the following categories:
Immediate Health Hazard
Chronic Health Hazard
SARA / Title III ?Toxic Chemicals List:
This product does not contain a toxic chemical for reporting under Section 313 (40 CFR 372).
Toxic Substances Control Act (TSCA):
This product contains no substances subject to the reporting requirements of TSCA 12(B) if exported from the
United States.
WHMIS Classification: No information available
HMIS Rating: Health: 2
Fire: 0
Reactivity: 1
Personal Protection: E
California Proposition 65:
This product contains trace amounts of the following chemicals known to the state of California to cause cancer
and/or reproductive toxicity.
Hydrizine sulfate C.A.S. # 10034-93-2
Silica, quartz C.A.S. # 14808-60-7
01/08
|