AQUA-RESIN庐
Material Safety Data Sheet
庐
Product Identification: Aqua-Resin L鈩?, K, SF, G, EZG Liquid Component
_______________________________________________________________________________________________________________
Section I:
Manufacturer's Name: ADM Tronics Unlimited, Inc. Emergency Phone: (201) 767-6040
Address: 224 Pegasus Avenue
Northvale, NJ 07647 Date: April 8, 2002
Supersedes all previous Material Safety Data Sheets
_______________________________________________________________________________________________________________
Section II: Composition Information or Ingredients
Components CAS # OSHA PEL ACGIH TLV
ppm ppm
No Hazardous Ingredients
_______________________________________________________________________________________________________________
Section III: Physical/Chemical Characteristics
Boiling Point: 212 F Evaporation Rate (BuAc=1): <1
pH 6.0 - 7.0 Solubility in Water: Miscible as supplied.
Vapor Pressure (mm Hg): 17.1 mm Hg Appearance: L - milky liquid blue/greenish tint.
Vapor Density (Air=1): <1 K - creamy pale yellow liquid
Specific Gravity: 1.02 - 1.08 SF, GEZG - milky pink.
Melting Point: 32 F Odor: mild, agreeable
_______________________________________________________________________________________________________________
Section IV: Fire and Explosion Hazard Data
Flash Point (method used): N/A Extinguishing Media: N/A
Flammable Limits: N/A Special Fire Fighting Method: N/A
LEL: N/A Unusual Fire/Explosion
UEL: N/A Hazard: Dried material can ignite from flame.
_______________________________________________________________________________________________________________
Section V: Reactivity Data
Stability
Unstable: Stable: X Conditions to Avoid: Excess Heat. Freezing
Incompatibility to Avoid: None
Hazardous Decomposition Irritating and toxic fumes may result at extreme temperatures. Acid conditions below pH 6,
Or Byproducts: over time, may cause product degradation. Formaldehyde may be generated. Avoid long term
storage of this material premixed with Aqua-Resin庐 product XLR-8鈩?.
Hazardous Polymerization
May Occur: Will Not Occur: X Conditions to Avoid: N/A
_______________________________________________________________________________________________________________
Section VI: Health Hazard Data
Routes of Entry Signs and Symptoms of Overexposure
Acute Chronic
Inhalation: Inhalation of vapor or mist can cause None known
irritation of nose, throat and lungs
accompanied by headache and nausea.
Ingestion: Unknown. Consult physician. None known
Eyes: Irritation. None known
Skin: Repeated or prolonged skin contact may None known
cause irritation and/or dermatitis.
_______________________________________________________________________________________________________________
Carcinogenicity
NTP: None IARC: None OSHA: None
Medical Conditions Generally
Aggravated by Exposure: None known
1/03/02- 鈥淟鈥?
Rev. 5/2/06
AQUA-RESIN庐
Emergency and First Aid
Inhalation: Remove patient to fresh air.
Ingestion: May be harmful if swallowed. Consult physician
Eyes: Flush immediately with water for fifteen (15) minutes. Consult physician.
Skin: Wash affected areas with soap and water.
_______________________________________________________________________________________________________________
Section VII: Precautions for Safe Handling and Use
Steps to be Taken In Case
Material is Spilled or Released: Contain and absorb with inert material. Insure adequate ventilation.
Waste Disposal Method: Dispose in accordance with local, state and federal regulations.
Precautions to be Taken in
Storing and Handling: Do not freeze. Avoid excess heat.
Once Aqua-Resin庐 liquid components have been reacted with the appropriate Aqua-Resin庐 powder
Other Precautions:
component, cured and hardened, if sanding is necessary, wet sanding should be employed to control
dust. Keep out of reach of children.
CAUTION: Do not allow an Aqua-Resin庐 mix to harden on, or encase any part of the body. Doing so,
because of the heat generated, the possible expansion of the material, and the difficulty of removal in a
timely manner, may cause serious bodily injury.
_______________________________________________________________________________________________________________
Section VIII: Control Measures
Respiratory Protection: None required. However, for extreme conditions use a NIOSH approved respirator fitted with an
organic vapor cartridge.
Ventilation
Local Exhaust: None required, unless extreme conditions encountered.
Mechanical (general): None required, unless extreme conditions encountered.
Special or Other: N/A
Protective gloves: Neoprene gloves recommended (other gloves may be suitable).
Eye Protection: Chemical splash goggles recommended.
Other Protective Equipment
or Clothing: Eyewash station should be available.
Work/Hygiene Practices Do not eat or smoke while working with this product.
_______________________________________________________________________________________________________________
Section IX: Transportation Classification
US DOT Hazard Class: Not Regulated
_______________________________________________________________________________________________________________
Note: NA 鈥? Not Applicable ND 鈥? Not Determine
The information in this MSDS relates only to the specific materials designated, and to the specific ADM Tronics鈥? products
identified in our instructions. It does not relate to use in combination with any other materials or processes. This
information is provided in good faith, and as of the date of this document, is believed to be correct. However, ADM Tronics
does not make any representation as to its accuracy or completeness. Users are advised to make their own determination as
to the suitability of this product for their particular purpose. Accordingly, ADM Tronics disclaims responsibility for
damages of any kind resulting from the use of this information.
www.aquaresin.com
1/03/02- 鈥淟鈥?
Rev. 5/2/06
|