Material Safety Data Sheet
May be used to comply with
OSHA's Hazard Communication Standard 29 CFR 1910.1200.
This standard must be consulted for specific requirements.
SECTION 1: PRODUCT AND COMPANY IDENTIFICATION
58-97-1000
Product Name : Hawg Wash Drawing Number:
January 2008
Product Numbers: Issue Date:
49-32-0081
July 2004
Supersedes Date:
Company Phone Number: 262-781-3600 or
Milwaukee Electric Tool Corporation
1-800-729-3878
13135 West Lisbon Road
Emergency Contact Number: 1-800-424-9300
Brookfield, Wisconsin 53005
(United States Only) (Chemtrec)
www.milwaukeetool.com
EMERGENCY OVERVIEW
? This product is a semi-solid that is soluble in water.
? Direct eye contact may cause minor, short term irritation.
? Short term skin exposure is not expected to be irritating.
? Inhalation and ingestion are not anticipated routes of exposure during normal conditions of use.
HMIS Rating: Health ?1 Flammability ?1 Reactivity ?0 PPE ?X, A
Hazard Ratings: 0 = Minimum Hazard 1 = Slight Hazard 2 = Moderate Hazard 3 = Serious Hazard 4 = Severe Hazard
A = Goggles B = Goggles & Gloves C = Face Shield, Gloves & Apron X = Special, See Sections 7, 8
SECTION 2: COMPONENT DATA
Components listed in this section may contribute to the potential hazards associated with exposure to the concentrate. The
product may contain additional non-hazardous or trade-secret components.
INGREDIENT % by OSHA OSHA ACGIH California IARC/NTP
Weight Reg. CAS # PEL TLV Prop 65 Reg. Y/N
Y/N Y/N
Petroleum oil 10-20 N/A 8002-05-9 5mg/m? 5mg/m? N
Petroleum sulfonate 1-10 N/A 61789-85-3 None None N
Chlorinated alkene polymer 1-5 N/A 68410-99-1 None None N
Sulfurized fat 1-10 N/A 61790-49-6 None None N
Borate 1-10 N/A 10043-35-3 None None N
Carboxylate acid 1-10 N/A 68990-37-4 None None N
Nonionic surfactant 1-10 N/A 68991-48-0 None None N
Propylene glycol ether 1-10 N/A 68603-15-6 None None N
Pine oil 1-10 N/A 8002-09-3 None None N
Propylene glycol <1 N/A 57-55-6 None None N
Aromatic alcohol <1 N/A 68603-15-6 None None N
Vegetable oil <1 N/A 68958-68-3 None None N
Substituted indole <1 N/A 63231-48-1 None None N
Silicone defoamer <1 N/A 63231-48-1 None None N
Water Balance N/A 7732-18-5 None None N
Page 1 of 7
MET P/N 58-97-1000
Hawg Wash
09A
Some CAS numbers refer to families rather than specific chemical identities. The exact chemical identities and
percentages of the raw materials used in Hawg Wash?are trade secrets. This information is being withheld as provided
for in the Occupational Safety and Health Administration's Hazard Communication rule.(29CFR 1910.1200).
SECTION 3: HAZARDOUS INDENTIFICATION
POTENTIAL HEALTH EFFECTS and SYMPTOMS from SHORT TERM/ACUTE EXPOSURE
?EYE EXPOSURE
This product is not expected to cause eye irritation under normal conditions of use. Symptoms of slight eye
irritation may result when direct contact occurs, or when exposed to high mist levels in poorly ventilated areas.
? SKIN EXPOSURE
Short term skin contact is not expected to cause skin irritation. Prolonged or repeated direct exposure to the skin
may result in symptoms of irritation and redness.
? INHALATION:
This product has low volatility and so is not expected to cause respiratory tract irritation during normal conditions
of use. Exposure to high mist levels in poorly ventilated areas may cause temporary irritation to the upper
respiratory tract.
? INGESTION
If large amounts are ingested contact a physician, in every case get medical attention as required.
POTENTIAL CHRONIC HEALTH EFFECTS:
No further data known.
MEDICAL CONDITIONS AGGRAVATED BY EXPOSURE:
No further data known.
CARCINOGENICITY:
This product is not listed as a known or suspected carcinogen by IARC, OSHA, or the NTP.
SECTION 4: FIRST AID MEASURES
EYE CONTACT:
Hold eyelids open and flush with a steady, gentle stream of water for at least 15 minutes. If symptoms persist, contact
a physician.
SKIN CONTACT:
Remove product from the skin by washing with a mild soap and water. Contaminated clothing should be removed to
prevent prolonged exposure. If product is injected under the skin, seek treatment immediately. If symptoms persist,
contact a physician.
INHALATION:
If signs or symptoms of overexposure occur, remove the employee to fresh air. If symptoms persist, seek medical
attention.
INGESTION:
Do not ingest. If large amounts are ingested seek medical attention.
NOTE TO PHYSICIAN:
No further data known.
Page 2 of 7
MET P/N 58-97-1000
Hawg Wash
09A
SECTION 5: FIRE FIGHTING MEASURES
FIRE AND EXPLOSIVE PROPERTIES:
Boiling Point: 217癋 (105癈)
Vapor Pressure (mm/Hg.) <1
Vapor Density (Air=1) N/A
Melting Point N/A
Evaporation Rate 1
Flash Point None (COC & TOC)
Flammable Limits LEL N/A
UEL N/A
EXTINGUISHING MEDIA:
In accordance with NFPA guidance, dry chemical, foam, or CO2 fire extinguishers are all acceptable. Note that while
water fog extinguishers are also acceptable, do NOT apply a direct stream of water onto burning product because it
may cause spreading and increase fire intensity.
UNUSUAL FIRE & EXPLOSION HAZARDS:
No further data known.
FIRE-FIGHTING PROCEDURES AND EQUIPMENT:
Emergency responders in the danger area should wear bunker gear and self-contained breathing apparatus for fires
beyond the incipient stage. See Section 8 of the MSDS for other PPE to be worn as conditions warrant.
SECTION 6: ACCIDENTAL RELEASE MEASURES
CLEAN-UP MEASURES:
Important: As with any spill or lead, before responding ensure that you are familiar with the potential hazards and
recommendations of the MSDS. Appropriate personal protective equipment must be worn. See Section 8 of this
MSDS for PPE recommendations.
If possible, safely contain the spill with dikes or other spill response equipment appropriate for petroleum or organic
material releases. Take measures to prevent spreading of product. Note that while product will ignite it will not
readily burn. However, as a precaution eliminate ignition sources. Prevent from entering sewers or waterways.
Large volumes may be transferred to an appropriate container for proper disposal. Small volumes or residues may be
soaked up with absorbents. Spill response materials should be collected for proper disposal.
SECTION 7: HANDLING AND STORAGE
HANDLING:
As with any industrial chemical, handle the product in a manner that minimizes exposure to practicable levels. Prior
to handling, consult Section 8 of this MSDS to evaluate personal protective equipment needs. Open containers slowly
to relieve any pressure. Follow all other standard industrial hygiene practices.
Empty containers may contain product residue. All safety precautions taken when handling this product should also
be taken when handling empty drums and containers. Keep containers closed when not in use.
Product residue in empty containers is combustible but will not readily burn. NOTE: however, that excessive heating
or cutting of empty containers may create an ignitions source sufficient to start a fire and in extreme cases, cause an
explosion.
Page 3 of 7
MET P/N 58-97-1000
Hawg Wash
09A
STORAGE:
Protect product quality by storing indoors and away from extreme temperatures. Close all containers when not in use
SPECIAL COMMENTS:
No further data known.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
PERSONAL PROTECTIVE EQUIPMENT:
Selection of personal protective equipment should be based upon the anticipated exposure and made in accordance
with OSHA's Personal Protective Equipment Standard found in 29 CFR 1910 Subpart I. The following information
may be used to assist in PPE selection.
? EYE PROTECTION
Wear eye protection appropriate to prevent eye exposure. Where splashing is not likely, chemical safety glasses
with side shields are recommended. Where splashing may occur, chemical goggles or full face shield is
recommended.
? SKIN PROTECTION:
Gloves are not normally needed during normal conditions of use. If health effects are experienced, oil or chemical
resistant gloves such as butyl or nitrile are recommended.
Where splashing or soaking is likely, wear oil or chemical resistant clothing to prevent exposure.
? RESPIRATORY PROTECTION:
Not normally required. A respirator may be worn to reduce exposure to vapors, dust, or mist. Select a
NIOSH/MSHA approved respirator appropriate for the type and physical character of the airborne material. A
self-contained breathing apparatus is recommended in all situations where airborne contaminant concentration has
not been confirmed to be below safe levels. Respirator use should comply with the OSHA Respirator Protection
Standard found in CFR 1910.134.
ENGINEERING CONTROLS:
Normal general ventilation is expected to be adequate. It is recommended that ventilation be designed in all
instances to maintain airborne concentrations at lowest practicable levels. Ventilation should at a minimum,
prevent airborne concentrations from exceeding any exposure limits listed in Section 2 of this
MSDS.
The user may wish to refer to 29 CFR 1910.1000 (d) (2) and the ACGIH "Threshold Limit Values for Chemical
Substances and Physical Agents Biological Exposure Indices" (Appendix C) for the determination of exposure
limits of mixtures. An industrial hygienist or similar professional may be consulted to confirm that the calculated
exposure limits apply.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical Appearance ......... Brown thick liquid
Odor ............................ Mild pleasant petroleum
Physical State ................. Semi Solid
Water Solubility............... 100% soluble
Specific Gravity............... 1.04
SECTION 10: STABILITY AND REACTIVITY
INCOMPATIBILITIES:
Page 4 of 7
MET P/N 58-97-1000
Hawg Wash
09A
This product is incompatible with strong oxidizersm acids and alkalis.
DECOMPOSITION PRODUCTS MAY INCLUDE:
Thermal decomposition products are dependent on combustion conditions. A complex mixture of airborne solid, liquid,
particulates and gasses may evolve when the material burns. Combustion by-products may include:
oxides of carbon,
incompletely burned hydrocarbons as fumes and smoke,
HCI,
SO2
CONDITIONS TO AVOID:
None
POLYMERIZATION:
This product is not expected to polymerize.
STABILITY:
This product is stable.
SECTION 11: TOXICOLOGY INFORMATION
EYE EFFECTS:
No further toxicological data known.
SKIN EFFECTS:
No further toxicological data known.
ORAL EFFECTS:
No further toxicological data known.
INHALATION EFFECTS:
No further toxicological data known.
OTHER:
No further data known.
SECTION 12: ECOLOGICAL INFORMATION
ECOTOXICOLOGICAL INFORMATION:
This product has not been evaluated for ecotoxicity. As with any industrial chemical, exposure to the environment
should be prevented and minimized wherever possible.
ENVIRONMENTAL FATE:
The degree of biodegradability and persistence of this product has not been determined.
SECTION 13: DISPOSAL CONSIDERATIONS:
WASTE DISPOSAL:
Ensure that collection, transport, treatment, and disposal of waste product, containers and rinsate complies with all
applicable laws and regulations. Note that use, mixture, processing, or contamination of the product may cause the
material to be classified as a hazardous waste. It is the responsibility of the product user or owner to determine at the
time of disposal, whether the product is regulated as a hazardous waste.
Page 5 of 7
MET P/N 58-97-1000
Hawg Wash
09A
SECTION 14: TRANSPORTATION INFORMATION
DOT HAZARDOUS MATERIAL INFORMATION:
* Not otherwise DOT regulated.
SECTION 15: REGULATORY INFORMATION
FEDERAL REGULATIONS:
SARA 313:
This product contains NONE of the substances subject to the reporting requirements of Section 313 of Title III of
the Superfund Amendments and Reauthorization Act of 1986 and 40 CFR Part 372.
Clean Water Act / Oil Pollution Act:
This product contains mineral oil and is subject to regulation by Section 311 of the Clean Water Act and the Oil
Pollution Act. Releases of the product into or leading to surface waters must be reported to the National
Response Center at 1-800-424-8802.
CERCLA Reportable Quantity:
Any components listed below have been assigned a reportable quantity (RQ) by the Federal EPA. Releases of the
product into the environment that exceed the RQ for a particular component must be reported to the National
Response Center at 1-800-424-8802.
__Component________________________________________________RQ_______________________________
Toxic Substance Control Act:
The components of this product are listed on the TSCA Inventory.
Ozone Depleting Substances:
This product contains no ozone depleting substances as defined by the Clean Air Act.
Hazardous Air Pollutants:
Any components listed below are defined by the Federal EPA as hazardous air pollutants.
__Component__________________________________________________________________________________
STATE REGULATIONS:
This product contains mineral oil, and as used, may be regulated by the state used oil regulations. Check with the
appropriate state agency to determine whether such a regulation exists.
No further data known.
SECTION 16: OTHER INFORMATION
Abbreviations:
TSCA Toxic Substance Control Act
ICAO International Civil Aviation Organization
IMDG International Maritime Dangerous
OSHA Occupational Safety and Health
IARC/NTP International Agency for Research on Cancer/National Toxicology Program
SARA Superfund Amendments and Reauthorization Act of 1986
Page 6 of 7
MET P/N 58-97-1000
Hawg Wash
09A
ACGIH American Conference of Governmental Industrial Hygienists
NIOSH/MSHA National Institute for Occupational Safety Health/
Mine Safety and Health Administration
WHMIS Workplace Hazardous Materials Information System
Prepared by: Milwaukee Electric Tool Corporation
The information and recommendations set forth are made in good faith and believed to be accurate as of the date of
preparation. MILWAUKEE ELECTRIC TOOL CORPORATION makes no warranty, expressed or implied, regarding
the accuracy of this data or the results to be obtained from the use thereto. All risks associated with product use are
assumed by the user.
Page 7 of 7
MET P/N 58-97-1000
Hawg Wash
09A
|