The MSDS format adheres to the standards and regulatory requirements
of the United States and may not meet regulatory requirements
in other countries.
DuPont Page 1
Material Safety Data Sheet
----------------------------------------------------------------------
Teflon(r) Advanced Protector
05578264 Revised 20-OCT-2008
----------------------------------------------------------------------
----------------------------------------------------------------------
CHEMICAL PRODUCT/COMPANY IDENTIFICATION
----------------------------------------------------------------------
Tradenames and Synonyms
Aftermarket Carpet Protector
Company Identification
MANUFACTURER/DISTRIBUTOR
DuPont
1007 Market Street
Wilmington, DE 19898
PHONE NUMBERS
Product Information : 1-800-441-7515 (outside the U.S.
302-774-1000)
Transport Emergency : CHEMTREC 1-800-424-9300(outside U.S.
703-527-3887)
Medical Emergency : 1-800-441-3637 (outside the U.S.
302-774-1000)
----------------------------------------------------------------------
COMPOSITION/INFORMATION ON INGREDIENTS
----------------------------------------------------------------------
Components
Material CAS Number %
Water 7732-18-5 83-85
Hexylene Glycol 107-41-5 1-6
Partially Fluorinated Urethane 357624-15-8 1-6
Acrylic Copolymer 72892-39-8 1-6
----------------------------------------------------------------------
HAZARDS IDENTIFICATION
----------------------------------------------------------------------
Potential Health Effects
The product is not a skin or eye irritant when tested in
animals. There are inconclusive or unverified reports of
human sensitization to Hexylene Glycol.
Inhalation may cause irritation of the upper respiratory
passages with coughing and discomfort.
Ingestion may cause nonspecific discomfort such as nausea,
headache, or weakness, heartburn, vomiting, or diarrhea,
temporary nervous system depression with anaesthetic effects
such as dizziness, headache, confusion, incoordination, and
loss of consciousness.
Print Date: 4 - 9 - 2009
05578264 DuPont Page 2
Material Safety Data Sheet
(HAZARDS IDENTIFICATION - Continued)
Based on related products, inhalation of spray or mist may cause
nasal, throat, or lung irritation. Inhalation of large amounts of
respirable particles may be toxic to the lungs. Symptoms may be
modest initially, followed in hours by severe shortness of breath
requiring prompt medical attention.
Carcinogenicity Information
None of the components present in this material at concentrations
equal to or greater than 0.1% are listed by IARC, NTP, OSHA or ACGIH
as a carcinogen.
----------------------------------------------------------------------
FIRST AID MEASURES
----------------------------------------------------------------------
First Aid
INHALATION
If inhaled, remove to fresh air. If not breathing, give
artificial respiration. If breathing is difficult, give oxygen.
Call a physician.
SKIN CONTACT
In case of contact, immediately wash skin with soap and water.
Wash contaminated clothing before reuse.
EYE CONTACT
In case of contact, immediately flush eyes with plenty of water
for at least 15 minutes. Call a physician.
INGESTION
If swallowed, do not induce vomiting. Immediately give 2 glasses
of water. Never give anything by mouth to an unconscious person.
Call a physician.
Notes to Physicians
Activated charcoal mixture may be administered. To prepare
activated charcoal mixture, suspend 50 grams activated charcoal in
400 mL water and mix thoroughly. Administer 5 mL/kg, or 350 mL
for an average adult.
Print Date: 4 - 9 - 2009
05578264 DuPont Page 3
Material Safety Data Sheet
----------------------------------------------------------------------
FIRE FIGHTING MEASURES
----------------------------------------------------------------------
Flammable Properties
This material is not expected to have a flash point based on
testing done with similar materials.
Hazardous decomposition products including carbon dioxide, carbon
monoxide, hydrogen fluoride, toxic gases or particles may be
formed during combustion. These products may cause severe eye,
nose, throat, and lung irritation or toxic effects.
Extinguishing Media
Water Spray, Foam, Dry Chemical, CO2.
Fire Fighting Instructions
Evacuate personnel to a safe area. Wear self-contained breathing
apparatus. Wear full protective equipment.
----------------------------------------------------------------------
ACCIDENTAL RELEASE MEASURES
----------------------------------------------------------------------
Safeguards (Personnel)
NOTE: Review FIRE FIGHTING MEASURES and HANDLING (PERSONNEL)
sections before proceeding with clean-up. Use appropriate
PERSONAL PROTECTIVE EQUIPMENT during clean-up.
Spill Clean Up
Soak up with sawdust, sand, oil dry or other absorbent material.
Flush away traces with water. Dispose of in an approved container.
----------------------------------------------------------------------
HANDLING AND STORAGE
----------------------------------------------------------------------
Handling (Personnel)
Avoid breathing vapors or mist. Avoid contact with eyes, skin, or
clothing. Wash thoroughly after handling. Wash clothing after
use.
Avoid circumstances that produce respirable particles unless
suitable ventilation and respirator are used.
Handling (Physical Aspects)
Keep away from heat, sparks and flames.
Storage
Store in a well ventilated place.
Print Date: 4 - 9 - 2009
05578264 DuPont Page 4
Material Safety Data Sheet
----------------------------------------------------------------------
EXPOSURE CONTROLS/PERSONAL PROTECTION
----------------------------------------------------------------------
Engineering Controls
Use only with adequate ventilation. Avoid breathing mists or
spray. Keep away from open flames.
Vent dryer fumes outside work area. Do not aerosolize. In
spray applications, use airless type pressure spray
equipment at less than 60 psi and exhaust ducts, drip pans
or other design features to minimize worker exposure to
mists and overspray.
Personal Protective Equipment
EYE/FACE PROTECTION
Wear safety glasses or where splash potential exists wear
chemical splash goggles.
RESPIRATORS
Wear NIOSH approved respiratory protection, as appropriate.
PROTECTIVE CLOTHING
Where there is potential for skin contact have available and
wear as appropriate impervious gloves, apron, pants and
jacket.
Exposure Guidelines
Applicable Exposure Limits
Hexylene Glycol
PEL (OSHA) : None Established
TLV (ACGIH) : Ceiling 25 ppm, 121 mg/m3
AEL * (DuPont) : None Established
* AEL is DuPont's Acceptable Exposure Limit. Where governmentally
imposed occupational exposure limits which are lower than the AEL
are in effect, such limits shall take precedence.
Exposure Guideline Comments
No AEL has been established for this product. Other
products with fluorinated material components have an AEL of
0.1 mg/m3 to 1 mg/m3 (8 hour TWA) for respirable size
aerosol particles.
Air monitoring studies conducted at customer sites indicates
that the use of the recommended low pressure (less than 60
psi) airless type, garden type or deck specific hand pump
sprayer with spray tip orifice minimum of 0.031 inches in
diameter does not produce respirable size aerosol particle
concentrations near the AEL.
Print Date: 4 - 9 - 2009
05578264 DuPont Page 5
Material Safety Data Sheet
----------------------------------------------------------------------
PHYSICAL AND CHEMICAL PROPERTIES
----------------------------------------------------------------------
Physical Data
Boiling Point : ~100 C (~212 F) @ 760 mm Hg
Freezing Point : ~0 C (~32 F)
% Volatiles : 82-97 WT%
Solubility in Water : Dispersible
pH : 6-8
Odor : Slight, Acrylic
Form : Liquid
Color : White
Specific Gravity : 1.02
----------------------------------------------------------------------
STABILITY AND REACTIVITY
----------------------------------------------------------------------
Chemical Stability
Stable at normal temperatures and storage conditions.
Incompatibility with Other Materials
None reasonably foreseeable.
Decomposition
Hazardous decomposition products including carbon dioxide, carbon
monoxide, hydrogen fluoride, toxic gases or particles may be
formed during combustion. These products may cause severe eye,
nose, throat, and lung irritation or toxic effects.
Polymerization
Polymerization will not occur.
----------------------------------------------------------------------
TOXICOLOGICAL INFORMATION
----------------------------------------------------------------------
Animal Data
Hexylene glycol:
Oral LD50: 3.7 g/kg in rats
Dermal LD50: 7.88 g/kg in rabbits
Inhalation 8 hour ALC: >18,000 ppm in rats
The product is not a skin irritant and is not an eye
irritant when tested in animals.
Hexylene glycol is untested for animal sensitization. Single
exposure to Hexylene glycol by ingestion caused
hypoactivity, sedation, dyspnea, ataxia, weakness,
gastrointestinal inflammation and pneumonitis. Repeated
exposure caused increased liver and kidney weights and
Print Date: 4 - 9 - 2009
05578264 DuPont Page 6
Material Safety Data Sheet
(TOXICOLOGICAL INFORMATION - Continued)
decreased adrenal weights. No animal data are available to
define the carcinogenicity of Hexylene glycol. Animal data
show developmental effects only at exposure levels producing
other toxic effects in the adult animal. Tests in animals
demonstrate no reproductive toxicity. Hexylene glycol does
not produce genetic damage in bacterial cell cultures. In
mammalian cell cultures it was positive in one test and
negative in one test. Hexylene glycol has not been tested
in animals for genetic toxicity.
----------------------------------------------------------------------
ECOLOGICAL INFORMATION
----------------------------------------------------------------------
Ecotoxicological Information
Hexylene Glycol:
96 hour LC50 - Fathead minnows: 8,690 mg/L
----------------------------------------------------------------------
DISPOSAL CONSIDERATIONS
----------------------------------------------------------------------
Waste Disposal
Treatment, storage, transportation, and disposal must be in
accordance with applicable Federal, State/Provincial, and Local
regulations.
----------------------------------------------------------------------
TRANSPORTATION INFORMATION
----------------------------------------------------------------------
Shipping Information
Not Regulated as a hazardous material by DOT, IMO, or IATA.
----------------------------------------------------------------------
REGULATORY INFORMATION
----------------------------------------------------------------------
U.S. Federal Regulations
TITLE III HAZARD CLASSIFICATIONS SECTIONS 311, 312
Acute : Yes
Chronic : No
Fire : No
Reactivity : No
Pressure : No
Print Date: 4 - 9 - 2009
05578264 DuPont Page 7
Material Safety Data Sheet
(REGULATORY INFORMATION - Continued)
TSCA Inventory Status:
This material contains one or more substances which are not
listed on Toxic Substances Control Act (TSCA) Chemical
Inventory. Therefore, this material should only be used for
TSCA-exempted applications or under the requirements of the
TSCA R&D Exemption (40CFR 720.36)
This material contains one or more substances which are
subject to a TSCA Section 5 Consent Order or Significant New
Rule (SNUR).
This material contains one or more substances which requires
export notification under TSCA Section 12(b):
Ingredient 窩AS No.
---------- 父父-------
Fluorinated Polyurethane Trade Secret (PMNP-07-87)
This material shall not be distributed to consumers for use
in spray applications. Contact your local DuPont sales or
technical representative for more information.
----------------------------------------------------------------------
OTHER INFORMATION
----------------------------------------------------------------------
NFPA, NPCA-HMIS
NPCA-HMIS Rating
Health :1
Flammability :0
Reactivity :0
----------------------------------------------------------------------
The data in this Material Safety Data Sheet relates only to the
specific material designated herein and does not relate to use in
combination with any other material or in any process.
Responsible for MSDS : MSDS Coordinator
> : DuPont Chemical Solutions Enterprise
Address : Wilmington, DE 19898
Telephone : (800) 441-7515
This information is based upon technical information believed to be
reliable. It is subject to revision as additional knowledge and
experience is gained.
End of MSDS
Print Date: 4 - 9 - 2009
|