MATERIAL SAFETY DATA SHEET
A: Product Identification:
Manufacturing Site: Asia Building Materials Limited
Address: Suite 1201-4, Tower 2 The Gateway,
25-27 Canton Road TST, Kowloon
Hong Kong
Telephone Number: (852) 3105-3221
Trade Name: Polyvinyl Chloride Compound (PVC, Vintec I, Vintec II, Celtec,
Century Trim) Sheet and Trim.
Synonyms: Vinyl Polymers
CAS Number: 9002-86-2
B: Composition/Information on Ingredients:
Component CAS Number WT%
Polyvinyl Chloride Resin 9002-86-2 >70%
Calcium Carbonate 1317-65-3 <10%
Titanium Dioxide 13463-97-7 <20%
Proprietary Additives Mixture <20%
This product is an article as defined in 29 CFR 1910.1200. It will not result in exposure to
hazardous chemicals under normal conditions of use. This product is not subject to the
reporting requirements of Section 313 of Title III of the Superfund Amendments and
Reauthorization Act of 1986 and 40CFR Part 372.
C: Physical Data:
Appearance (Physical Form): Finished Board / Sheet (Solid)
Boiling Point(oF): Soild
Specific Gravity (H20=1): 0.45 to 1.55
Vapor Pressure (mm Hg): Solid
Melting Point: Decomposes before melting
Solubility in Water: Solid
Vapor Density: Solid
Appearance and Odor: Finished Sheet
PH: Not Applicable (Solid)
D: Fire and Explosion Data:
Flash Point: Not Applicable
Autoignition Temperature: Not Applicable
Flammable Limits In Air. % by VOL.
Lower Not Applicable
Upper Not Applicable
Extinguishing Media: Water Spray(Fog), Foam, Dry Chemical or CO2
Special Fire Fighting Procedure: Cool exposed equipment with water spray. Wear
NIOSH approves, positive pressure,
self-contained breathing apparatus if fighting
fire in confined spaces. Full protective clothing,
Evacuate all personnel from danger area.
Unusual Fire and Explosion Hazard: PVC evolves hydrogen chloride, carbon
monoxide, and other toxic gases when burned.
Exposure to combustion products may be fatal
and should be avoided.
E: Health Hazard Information:
(Pertains to dust or chips generated during fabrication processes on finished trim boards
and sheet. )
First Aid:
Eyes: Immediately flush with plenty of water for a
period of 15 minutes. Do not rub eyes. If
irritation persists consult a physician.
Skin: Flush skin with plenty of water. Remove
contaminated clothing. Wash clothing before
reuse. If irritation persists immediately consult a
physician. If burnt by molten, get medical
attention immediately.
Ingestion: Seek medical aid.
Inhalation: If smoke from burning plastic is inhaled,
remove subject to fresh air immediately. If
symptoms develop, seek immediate medical
attention.
Note to Physician: Treat symptomatically and supportively.
Medical Conditions Aggravated
by Overexposure: Available toxicological data and the physical
and chemical properties of the product suggest
that there is no evidence that this product will
aggravate an existing medical condition.
Other Instructions: Never give anything by mouth to an
unconscious person.
Nature of Hazaed:
Eyes: If exposed to high concentrations of dust,
physical irritation of the eyes.
Skin: This material is not expected to present a hazard
to the intact skin. Molten sheet will produce
thermal burns.
Inhalation: Under normal conditions and with normal use,
no inhalation hazard is presented. Please refer to
Section IV, Fire and Explosion Data.
Ingestion: No significant health hazard anticipated.
Exposure Limits:
None established. ACGIH TLV of 10 mg/m3 total dust as an 8-hour TWA is recommended.
Toxicity Data:
Skin Contact: A review of the pertinent literature did not
reveal specific information for PVC.
Eye Contact: A review of the pertinent literature did not
reveal specific information for PVC.
Inhalation: Rodents exposed by the dietary or inhalation
route for 6 to 24 months have shown no
significant toxicological effects.
Ingestion: Rodents exposed by the dietary or inhalation
route for 6 to 24 months have shown no
significant toxicological effects.
Special Precautions:
Avoid inhalation of combustion products.
F: Reactivity Data:
Conditions Contributing to Instability: Not applicable.
Incompatibility: Not applicable.
Hazardous Decomposition Products: Hydrogen chloride and other toxic fumes
generated with combustion.
Conditions Contributing to
Hazardous Polymerization: Not applicable.
G: Spill or Leak Procedures:
When producing chips or dust from fabricating PVC sheet, sweep, scoop, or vacuum and
remove .Dispose of only in accordance with local, state, and federal regulations. Recycling of
PVC sheet and boards should be encouraged whenever possible.
H: Special Protection Information
(Pertains to dust or chips generated during fabrication process on finished trim boards and
sheet.)
Ventilation Recommendations: General ventilation when fabricating and
nuisance dust control.
Specific Personal Protective Equipment
Respirator Protection: If dust is produced during handling, an approved
particulate filter respirator should be used.
Eyes: Safety glasses or goggles.
Gloves: Necessary when handling hot or molten sheet.
Other Clothing and Equipment: As necessary when handling hot or molten sheet.
I: Shipping Transfer and Storages:
Shipping Information: Non-hazardous for transportation purposes.
Transpiration and Storage
Usual Shipping Containers: Palletized sheets.
Sustainer Temperatures above 150oF may cause
Storage Transport:
slow degradation.
Electrostatic Accumulation Hazard: Yes.
Dot Shipping Name: Not listed.
Dot Hazard Glass: Not regulated.
Dot Label: Not listed,
UN/AN Number: Not applicable.
Hazard Labels/Placard(S): Not applicable.
Packing Group: Not applicable.
Bulk Packaging: Not applicable.
RQ: Not applicable.
EGR No.: Not applicable.
J: Ecological Information:
No data is available on the adverse effects of this product on the environment.
Disclaimer:
The above data is based upon tests performed by, and experience of Century Trim or Century
Trim鈥檚 suppliers and is provided for informational and safety purposes only. The information is
believed to be accurate and complete. It is based on our current knowledge, however unknown
hazards may exist. Asia Building Materials Limited does not warranty, guarantee, or assume any
liability for the accuracy or completeness of the MSDS information. Century Trim鈥檚 products are
intended for sale to industrial and commercial customers. Asia Building Materials Limited requests
that customers inspect and test our products before use and satisfy themselves as to contents and
suitability. Compliance with all applicable Federal, State, and Local laws and regulations remains
the responsibility of the user.
Date: August 16, 2006
|