MATERIAL SAFETY DATA SHEET
FOR: 8995C PUMPING/TRAPPING FLUID
HMIS Rating: Health: 0 Flammability: 1 Reactivity: 0 Special: X
SECTION 1 - IDENTIFICATION
Chemical Name: Synthetic Hydrocarbon Oil
Synonyms: 8995C Pumping / Trapping Fluid
Formula: N/A (Product is refined naturally occurring mixture)
Manufacturer's Name: Gardner Denver Thomas, Inc., Welch Vacuum Technology
4601 Central Avenue
Monroe, LA 71203
Date Prepared: April 23 2009
Telephone Number for
General Information: (847) 676-8800
SECTION 2 - HAZARDOUS INGREDIENTS/IDENTITY
Exposure Limits in Air 5mg/m3 Oil Mist
Component CAS No. OSHA PEL ACGIH TVL
Synthetic Hydrocarbon Oil 68037-01-4 (100%) NO NO
Keystone oil blue
Component-Solvent Blue 386 14233-37-5 NO NO
To the best of our knowledge, the above listed component is not hazardous according to OSHA (1910.1200) or
one or more state right-to-know lists.
SECTION 3 - PHYSICAL AND CHEMICAL CHARACTERISTICS
Appearance and Odor: Blue; slight odor
Specific Gravity @ 22癈 (72癋) (Water = 1): 0.82
Vapor Pressure, Torr @ 25癈: 5x10-7
Vapor Density (Air = 1): N/A
Water Solubility: Insoluble
Boiling Point (ASTM D-86 Method): N/A
Reactivity in Water: N/A
Melting Point: N/A
THE INFORMATION HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESS OR IMPLIES, IS MADE.
Revision Date: 04/23/09 Rev. A P/N: 67-0490A 1 of 4
SECTION 4 - FIRE AND EXPLOSION HAZARDS DATA
Flash Point: 480癋, 249癈
Method Used: COC
Flammable Limits: Upper: N/D Lower: N/D
Extinguishing Media: Water Spray, Dry Chemical, Foam or CO2
Special Fire Fighting Procedures: Water or foam may cause frothing. Use water spray to cool fire
exposed containers. If a leak or spill has not ignited, use water
spray to disperse the vapors and to provide protection for those
persons attempting to stop the leak.
Unusual Fire and Explosion Hazards: None known
CAUTION: DO NOT USE PRESSURE TO EMPTY DRUM,
OR EXPLOSION MAY RESULT.
SECTION 5 - PHYSICAL HAZARDS (REACTIVITY DATA)
Stability: Product is stable under normal conditions.
Hazardous Polymerization: Will not occur.
Conditions to Avoid: Excessive heat.
Incompatibility (Materials to Avoid): May react with strong oxidizing agents such as Chlorates, Nitrates,
Peroxides, etc...
Hazardous Decomposition Products: Excessive heat. may produce Carbon Monoxide, Carbon Dioxide,
Aldehydes and Ketones, combustion products of Nitrogen and
Sulfur.
SECTION 6 - HEALTH HAZARD DATA
Eyes: This substance is not expected to cause prolonged or significant eye irritation.
This hazard evaluation is based on data from similar materials
Skin: This substance is not expected to cause prolonged or significant skin irritation.
This hazard evaluation is based on data from similar materials
Inhalation: If inhalation, this substance is considered practically non-toxic to internal organs.
This hazard evaluation is based on data from similar materials
Ingestion: If swallowed, this substance is considered practically non-toxic to internal organs.
This hazard evaluation is based on data from similar materials
Chemical Listed as Carcinogen or Potential Carcinogen:
IARC Monographs: No OSHA: No National Toxicology Program: No
THE INFORMATION HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESS OR IMPLIES, IS MADE.
Revision Date: 04/23/09 Rev. A P/N: 67-0490A 2 of 4
SIGNS AND SYMPTOMS OF EXPOSURE
Primary Routes
of Exposure: Inhalation, skin or eye contact, and ingestion.
ROUTES OF ENTRY FIRST AID MEASURES
Inhalation: This material is not expected to be an immediate inhalation problem.
Remove to fresh air. Obtain medical assistance if difficult breathing.
Eyes: Immediately flush eyes with plenty of cool water for 15 minutes.
Remove contact lenses if worn. Do not let victim rub eyes.
No First Aid procedures are required.
Skin: No First Aid procedures are required. As precaution, wash skin thoroughly with
soap. Remove and wash contaminated clothing.
Ingestion: No adverse effects are expected. If more then several mouthfuls are swallowed,
Abdominal discomfort, nausea and diarrhea may occur. Consult Medical Personnel
before inducing vomiting. If Medical advice cannot be obtained, take person and
product container to the nearest Medical Emergency Treatment Center or hospital.
SECTION 7 ?SPECIAL PRECAUTIONS AND SPILL/LEAK PROCEDURES
Precaution to be taken in Handling and Storage: Minimum feasible handling temperatures should be maintained.
Periods of exposure to high temperature should be minimized. Water contamination should be avoided.
Steps to be taken in Case of Release or Spill: Stop source of leak: Ventilate area, Avoid breathing vapor. Use
self-contained breathing apparatus or supplied air for large spills or confined areas. Contain spill if possible.
Wipe up or absorb in suitable material and shovel up. Prevent entry into sewers and waterways.
Waste Disposal Method (Consult Federal, State, Local Regulations): Under RCRA, it is the responsibility to the
user of products to determine at the time of disposal whether product meets RCRA criteria for hazardous waste.
This is because product uses, transformations, mixture, processes, etc., may render the resulting material
hazardous.
SECTION 8 - CONTROL MEASURES
Respiratory Protection: None required if exposures are within permissible concentrations of
5.0mg/m3 of air for mineral oil mist average over an eight-hour daily
exposure (ACGIH 1984-85).
Ventilation: Normal.
Protective Gloves: Impervious gloves when prolonged contact cannot be avoided.
Eye Protection: Chemical type goggles/face shield.
Protective Clothing: Impervious gloves when prolonged contact cannot be avoided.
Other Protective Measures: None considered necessary at this time.
Work/Hygienic Practices: Employees should exercise reasonable personal cleanliness.
THE INFORMATION HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESS OR IMPLIES, IS MADE.
Revision Date: 04/23/09 Rev. A P/N: 67-0490A 3 of 4
Information given herein is offered in good faith as accurate, but without guarantee. Conditions of use and
suitability of product for particular uses are beyond our control; all risks of use of the product are therefore
assumed by the user and we expressly disclaim all warranties of every kind of nature, including warranties
of merchantability and fitness for a particle purpose in respect to the use or suitability of the product.
Nothing is intended as a recommendation for uses which infringe valid patents or as extending license under
valid patents. Appropriate warnings and safe-handling procedures should be provided to handlers and users.
ATTENTION: Misuse of empty containers can be hazardous. Empty containers can be hazardous if used
to store toxic, flammable, or reactive materials. Cutting or welding of empty containers
might cause fire, explosion or toxic fumes from residues. Do not pressurize or expose to
open flame or heat. Keep container closed and drum bungs in place.
REGULATION INFORMATION: D.O.T. SHIPPING NAME: N/A
D.O.T. HAZARD CLASS: N/A
D.O.T. IDENTIFICATION NUMBER: N/A
THE INFORMATION HEREIN IS GIVEN IN GOOD FAITH, BUT NO WARRANTY, EXPRESS OR IMPLIES, IS MADE.
Revision Date: 04/23/09 Rev. A P/N: 67-0490A 4 of 4
|