Product Information
Material Safety Data Sheet
In compliance with OSHA韘 Hazard
Communication Standard 29 CFR 1910.1200
Jowat Corporation
6058 Lois Lane
Archdale, NC 27263
Phone: 336-434-9000
Fax: 336-434-9019
MSDS 03
Date Prepared: 11/08/99 Date Issued: 12/14/2005 Date Reviewed: 08/10/04
Prepared by: G.Haas
Section II - Hazardous Ingredients
CAS# CONCENTRATION OSHA PEL ACGIH TLV
[ppm] [ppm] [ppm]
Vinyl acetate monomer 108-05-4 <10 10 10
Section III - Physical Data
MELTING POINT: N/A BOILING POINT: N/A
VOC: <= 10g/L MOISTURE CONTENT: <=0.5%
WATER SOLUBILITY: negligible ODOR: mild ester odor
FORM: at room temperature solid blocks, pellets or slugs
Page 1/3 Printed: 12/14/2005
Section IV - Fire and Explosion Hazard Data
FLASHPOINT: >250僀 (>482僃) COC.
FIRE AND EXPLOSION HAZARDS: None known to Jowat Corporation.
HAZARDOUS COMBUSTION PRODUCTS: Like most organic products it may form carbon monoxide, -dioxide, and
other byproducts.
EXTINGUISHING MEDIA: Water fog, carbondioxide, foam, dry chemical.
SPECIAL FIREFIGHTING PROCEDURES: Do not use water to extinguish fire at temperatures above 220僀 (430F).
Material may foam and sputter. Wear NIOSH/MSHA approved positive pressure self- contained breathing apparatus if
exposed to fumes.
Section V - Reactivity Data
STABILITY: Stable
CONDITIONS TO AVOID: Do not heat above 220僀 (430F) for prolonged time.
MATERIALS TO AVOID: None known to Jowat Corporation.
HAZARDOUS DECOMPOSITION AND BYPRODUCTS: Like most organic materials it may form carbon monoxide, -
dioxide and others.
HAZARDOUS POLYMERIZATION: Will not occur.
Section VI - Health Hazard Data
ROUTE(S) OF ENTRY:
-INHALATION: of vapors of molten materials
-INGESTION: very unlikely
-SKIN: N/A
HEALTH HAZARDS (ACUTE AND CHRONIC): None known to Jowat Corporation.
CARCINOGENICITY:
-NTP: not listed
-IARC: not listed
-OSHA: not regulated
SIGNS AND SYMPTOMS OF OVEREXPOSURE:
- Eyes: Vapors and fumes may cause irritation.
-Skin: No known effects.
-Inhalation: Vapors and fumes may cause irritation of the nose, throat, and respiratory - tract.
-Chronic: None known to Jowat Corporation.
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE: None known to Jowat Corporation.
EMERGENCY AND FIRST AID PROCEDURES:
-Eyes: Flush with plenty of water; if irritation appears consult physician.
-Skin: If irritation appears flush with plenty of soap and water; in case of contact with molten material flush with plenty of
cold water; do not attempt to remove solidified material. Consult a physician for burn treatment.
-Inhalation: Remove to fresh air; if breathing stops administer respiration or oxygen; call a physician.
-Ingestion: Induce vomiting after drinking two glasses of water; consult a physician.
Section VII - Precautions for Safe Handling and Use
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED: Pellets or solid material: sweep area
immediately and dispose of contaminated material accordingly.
MOLTEN MATERIAL: Allow to cool and solidify then remove.
Page 2/3 Printed: 12/14/2005
WASTE DISPOSAL METHOD: Dispose of as solid waste in compliance with federal, state and local regulations for non-
hazardous substances.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORAGE: Store in dry, clean and cool area. Avoid temperatures
above 50僀 (120F) to prevent material from blocking.
OTHER PRECAUTIONS: normal usage involves hot, molten adhesive which can cause severe burns; handle with care.
Section VIII - Control Measures
RESPIRATORY - PROTECTION: No special requirement under ordinary conditions of use when adequate ventilation is
provided
LOCAL EXHAUST: Recommended to remove vapors when processing material.
PROTECTIVE GLOVES: Recommended to wear heat protective gloves when handling adhesive.
EYE PROTECTION: Safety glasses or better recommended.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Protective apron, long sleeve and safety shower when processing
material ?recommended.
WORK/HYGIENIC PRACTICES: Use good hygiene and housekeeping practice.
Section IX - Regulatory Information
HMIS - RATING: HEALTH-1 FLAMMABILITY-1 REACTIVITY-0
WHMIS CLASS: Not controlled
DOT PROPER SHIPPING NAME: Not a regulated material.
TSCA STATUS: All components of this material are registered under the regulation of the toxic substances control act.
SARA Section 313 listed Ingredients: Vinyl Acetate Monomer (108-05-4)