Page 1 of 4
MATERIAL SAFETY DATA SHEET
MSDS No. 100V27
PRODUCT NAME: MIL-C-46168D, Type IV Catalyst
HMIS CODES:HEALTH 3 FIRE 3 REACTIVITY 0 PERSONAL PROTECTION G
SECTION I: MANUFACTURER IDENTIFICATION
MANUFACTURER NAME: MACH-DYNAMICS
ADDRESS: 3870 La Sierra Avenue, Suite 212, Riverside, CA 92505
INFORMATION PHONE: (909) 515-3748 FAX: (775) 599-4585
PREPARED BY: MARK GINGERELLA
DATE REVISED: APR-15-2004 (01-01-99)
REASON REVISED: Format (Prop 65 Statement)
EMERGENCY PHONE: CHEMTRC 1-800-424-9300
SECTION II: HAZARDOUS INGREDIANTS / SARA III INFORMATION
HAZARDOUS COMPONENT CAS No. OSHA PEL ACCIW TLV OTHER mm Hg @ Temp Percent
*XYLENE 1330-20-7 100 PPM 100 PPM N/A 5.1 @ 68 Deg F 25
1.6-HEXAMETHYLENE 822-06-0 50 PPM N/A N/A 0.0 @ 68 Deg F 75
DIISOCYANATE BASED POLYISOCYANTE
*INDICATES TOXIC CHEMICAL(S) SUBJECT TO REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III
AND OF 40 CFR 372. *WARNING THIS PRODUCT CONTAINS CHEMICALS KNOW TO THE STATE OF CALIFORNIA
TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
Page 2 of 4
MATERIAL SAFETY DATA SHEET
MSDS No. 100V27
SECTION III: PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING POINT: 280 Deg F 1.0
SPECIFIC GRAVITY (H20=1):
VAPOR DENSITY: HEAVIER THAN AIR SLOWER THAN ETHER
EVAPORATION RATE:
MATERIAL V.O.C.: 2.15 LB/GL (258 G/L)
CLEAR LIQUID WITH
SOLUBILITY IN WATER: ESSENTIALLY NIL APPEARANCE AND ODOR:
STRONG SOLVENT ODOR
SECTION IV: FIRE AND EXPLOSION HAZARD DATA
Flash Point 80 Deg F Method Used: TCC
Flammable Limits In Air By Volume: Lower: 1.0% Upper: N/A
Extinguishing Media: Foam, CO2, Dry Chemical, Water Fog
USE AIR SUPPLIED EQUIPMENT FOR ENCLOSED AREAS. COOL
Special Fire Fighting Procedures: EXPOSED CONTAINERS WITH WATER
HEAT/FIRE CONDITIONS: VAPORS FORM FLAMMABLE/EXPLOSIVE MIXTURES IN AIR,
Unusual Fire And Explosion
VAPORS, HEAVY, MAY TRAVEL TO IGNITION SOURCE. OPEN/CLOSED CONTAINERS MAY
Hazards: CONTAIN FLAMMABLE/EXPLOSIVE VAPORS. UNDER FIRE CONDITIONS. MAY EMIT
IRRITANT/TOXIC GAS AND/OR FUMES. CLOSED CONTAINERS MAY EXPLODE WHEN EXPOSED
TO EXTREME HEAT(FIRE)
SECTION V: REACTIVITY DATA
Stability: Stable
Conditions To Avoid: Flames, Sparking, Smoking, and Heat.
Incompatibility or Materials to Avoid: Strong Oxidizing Agents.
HDI VAPORS AND OTHER IRRITATING, HIGHLY TOXIC GASES MAY BE GENERATED
Hazardous Decomposition or By Products: BY THERMAL DECOMPOSITION OR COMBUSTION
Will Not Occur. POLYMERIZATION MAY OCCUR IF IN CONTACT WITH MOISTURE OR OTHER MATERIALS
Hazardous Polymerization: WHICH REACT WITH ISOCYANATES.
SECTION VI: HEALTH HAZARD DATA
INHALATION HEALTH RISK AND SYMPTOMS OF EXPOSURE:
Prolonged and/or repeated exposure to high concentrations of airborne particles may lead to
lung changes. Inhalation of high concentrations may also cause nausea, vomiting, cough,
pulmonary irritation and headache
SKIN AND EYE CONTACT HEALTH RISK AND SYMPTOMS OF EXPOSURE:
Direct contact and/or contact with vapors may cause irritation.
EYE:
SKIN: Prolonged and/or repeated contact may cause irritation and/or dermatitis. May be
absorbed through the skin.
SKIN ABSORBTION HEALTH RISK AND SYMPTOMS OF EXPOSURE: Contact may cause irritation and/or
dermatitis. May be absorbed through
the skin, leading to systemic effects
INGESTION HEALTH RISK AND SYMPTOMS OF EXPOSURE: Aspiration of this product into the
lungs may cause pneumontitis,
pulmonary edema, and hemorrhage.
Ingestion may cause
gastrointestinal disturbances.
Page 3 of 4
MATERIAL SAFETY DATA SHEET
MSDS No.:100V27
SECTION VI: HEALTH HAZARD DATA continued
HEALTH HAZARDS -- ACUTE AND CRONIC:
Direct contact to eyes may cause irritation, prolonged and/or repeated
contact may cause skin irritation. Inhalation of high concentrations of
vapors may lead to lung changes, nausea, vomiting, cough, pulmonary
irritation, and central nervous system depression. Ingestion may cause
gastrointestinal disturbance. Aspiration of this product into the lungs
may cause pneumontitis, pulmonary edema and hemorrhage.
CARCINOGENICITY: NTP? No IARC MONOGRAPHS? No OSHA REGULATED? No
NTP---NOT LISTED OSHA----NOT REGULATED IARC ---NOT LISTED
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Asthma and any other respiratory disorders (Bronhitis, Emphysema..etc),
skin, allergies, eczema.
EMERGENCY AND FIRST AID PROCEDURES:
IMMEDIATELY FLUSH WITH LARGE AMOUNTS OF WATER FOR 15 MINUTES, SEEK MEDICAL
EYE CONTACT: AID.
WASH THOROUGHLY WITH SOAP AND WATER. SEEK MEDICAL AID IF IRRITATION
SKIN: PERSIST.
IMMEDIATELY SEEK MEDICAL AID, DO NOT INDUCE VOMITING. GIVE 1 GLASS OF
INGESTION: MILK OR 1-2 OUNCES OF ACTIVATED CHARCOAL IN WATER TO VICTIM.
DO NOT ATTEMPT TO GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.
Move to area free from risk of further exposure. Administer artificial
INHALATION: respiration or oxygen as needed. Obtain medical attention
SECTION VII: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Stop leak if no risk involved. Remove all sources of ignition, stay upwind. Absorb with
inert material. Flush area with water. Ventilate area for at least 24 hours or until area
has been declared safe.
WASTE DISPOSAL METHODS:
Use inert absorbent materials on spills. Dispose of in accordance with all Federal, State, and Local Regulations.
Decontamination Solution: Concentrated ammonia (3-8%), detergent (2%), and water (90-05%). Decontaminate before disposal.
Respiratory protection is recommended during spill clean-up, wash down spill area with decontamination solution.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
Keep containers closed and upright to prevent leakage. Avoid flames, welding, open lights,
etc. Avoid breathing of vapor and spray mist. Avoid skin and eye contact.
Maintain good personal hygiene. Decontamination solution should be used if
OTHER PRECAUTIONS: spill or contact occurs.
Do Not Use in confined areas, tank or pit, without adequate ventilation.
Persons with asthmatic type conditions, respiratory diseases or skin eczema
should be excluded from Isocyanate contact.
Page 4 of 4 MATERIAL SAFETY DATA SHEET
MSDS No. 100V27
SECTION VIII: CONTROL MEASURES
RESPIRATORY PROTECTION:
If ventilation does not maintain inhalation exposures below TLV (PEL), use MSHA/NIOSH
approved units. Use units per current 29 CFR1910.134 and follow manufacturer's instructions
and warnings. If within OSHA protection factor, air purifying OV/filter units OK for use.
VENTILATION: Local and mechanical exhaust.
PROTECTIVE GLOVES: Chemical resistant gloves. Cover as much of the exposed skin
area as possible with appropriate clothing.
Safety glasses with side shields or goggles. Contact lenses should
EYE PROTECTION:
not be worn.
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Eye bath and safety shower.
Maintain good personal hygiene. Do not use in
WORK/HYGIENIC PRACTICES:
confined areas without adequate ventilation.
SECTION IX: DISCLAIMER
AS THE CONDITIONS OR METHODS ARE BEYOND OUR CONTROL WE DO NOT ASSUME ANY RESPONSIBILITY
REGARDING USE OF PRODUCT. WE EXPRESSLY DISCLAIM ANY LIABILITY FOR ANY USE OF THE MATERIAL.
INFORMATION CONTAINED HEREIN IS BELIEVED TO BE ACCURATE, ALL STATEMENTS OR SUGGESTIONS ARE
MADE WITHOUT ANY WARRANTY, EXPRESSED OR IMPLIED TO THE ACCURACY OF THE DOCUMENT.
SECTION X: TRANSPORTATION DATA
GROUND:
PROPER SHIPPING NAME: PAINT, FLAMMABLE LIQUID
HAZARD CLASS: FLAMMABLE LIQUID
UN/NA NUMBER: UN1263
APPLICABLE REGULATION: 49 CFR 171-179
U.S. POSTAL REGULATION: NOT SHIPPABLE
LABEL: FLAMMABLE LIQUID
DISPOSAL INFORMATION:
THIS PRODUCT IS A US EPA DEFINED IGNITABLE HAZARDOUS WASTE. DISPOSE OF AS AN IGNITABLE
HAZARDOUS WASTE IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS. AVOID STORING
MATERIAL NEXT TO OR NEAR OXIDIZING MATERIALS. EPA IGNITABLE.
AIR:
PROPER SHIPPING NAME: PAINT
HAZARD CLASS: CLASS 3
UN/NA NUMBER: UN 1263
LABEL: FLAMMABLE LIQUID
PACKAGING GROUP: CONSULT IATA MANUAL
APPLICABLE REGULATION: IATA
U.S. POSTAL REGULATION: NOT SHPPABLE
DISPOSAL INFORMATION:
THIS PRODUCT IS A US EPA DEFINED IGNITABLE HAZARDOUS WASTE. DISPOSE OF AS AN IGNITABLE
HAZARDOUS WASTE IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS. AVOID STORING
MATERIAL NEXT TO OR NEAR OXIDIZING MATERIALS. EPA IGNITABLE.
|