MSDS# 5700W Staticide Premium ESD Paint Page 1 of 5
Material Safety Data Sheet
Section 1. CHEMICAL PRODUCT and COMPANY IDENTIFICATION
Identification:
Product Name: Staticide Premium ESD Paint - White
Product Number: # 5700WQ, 5700W1, 5700W5
Recommend use: Water-Based polyurethane paint for static control on interior concrete
floors
Manufacturer: ACL Incorporated
840 W 49th Place
Chicago, Il 60609
PH: (01) 847.981.9212 [U.S.A.]
FAX: (01) 847.981.9278 [U.S.A.]
Emergency telephone: INFOTRAC: (01) 800.535.5053 (day or night)
Section 2. HAZARDOUS IDENTIFICATION
HMIS HAZARD RATING: (2) Health (1 ) Flammability (0 ) Reactivity
Potential Health Effects:
Inhalation: Excessive inhalation of vapors can cause nasal and respiratory irritation. Respiratory symptoms
associated with pre-existing lung disorders may be aggravated by exposure to this material.
Eyes: This material may cause eye irritation.
Skin: Prolonged and repeated contact with skin can cause defatting and drying of the skin, which may result
in skin irritation and dermatitis. Contact may result is skin absorption, but symptoms of toxicity are not
anticipated by this route alone under normal conditions of use. Persons with pre-existing skin disorders may
be more susceptible to effects of this material.
Ingestion: Ingestion can cause gastrointestinal irritation, nausea, vomiting, and diarrhea. Aspiration of
material into lungs can cause chemical pneumonitis, which can be fatal.
Chronic Effects: This product contains small amounts of organic solvent(s) and reports have associated
repeated and prolonged occupational overexposure to solvents with permanent brain and nervous system
damage. Intentional misuse by deliberately concentrating and inhaling the contents may be harmful or fatal.
Section 3. COMPOSITION / INFORMATION ON INGREDIENTS
CHEMICAL C.A.S. Number EINECS Weight % EU Class
1-Methyl-2-Pyrrolidinone 872-50-4 212-828-1 4-7 Xi, R36/37/38, R61
Dipropylene Glycol Butoxy Ether 29911-28-2 249-951-5 4-7 Not classified
Tin Oxide 18282-10-5 242-159-0 * Not classified
Titanium Dioxide 13463-67-7 236-675-5 * Not classified
Water and other non-hazardous substances Mixture Balance Not c lassified
*Value and hazard are for particulate (nuisance) dust which is not present in form supplied
Section 4 FIRST AID MEASURES
Eye Contact: Immediately flush eyes with water for at least 15 minutes. Hold eyelids open during the water
flushing. Get medical attention!
Page 1 of 5
MSDS# 5700W Staticide Premium ESD Paint Page 2 of 5
Skin Contact: Thoroughly wash exposed area with soap and water. Remove contaminated clothing and
launder before re-use.
Ingestion: Do not induce vomiting. Keep person warm and quiet. Obtain immediate medical assistance to
determine best emergency treatment. Never give anything by mouth to an unconscious person.
Inhalation: If affected, remove individual to fresh air. If breathing is difficult, administer oxygen. If
breathing has stopped, give artificial respiration. Keep person warm and quiet. Get immediate medical
attention.
Section 5 FIRE FIGHTING MEASURES
Flash Point & Method: None
Extinguishing Media: Water spray may be useful in minimizing vapors and cooling containers exposed to
heat and flame to prevent pressure build-up. Avoid spreading burning liquid with water used for cooling
purposes.
Fire Fighting Equipment: Wear self-contained breathing apparatus with full-face piece operated in the
positive pressure demand mode when fighting fires.
Special Fire Fighting Procedures: During emergency conditions, decomposition products may cause health
hazard. (See reactivity data) Evacuate area of unprotected personnel.
Unusual Fire and Explosion Hazards: This material will not support combustion unless the water has
evaporated. Material can splatter above 212?F
Section 6 ACCIDENTAL RELEASE MEASURES
FOR SMALL SPILLS Use absorbent material, placing the contained material in an approved salvage
container.
FOR LARGE SPILLS Persons not wearing protective equipment should be excluded from area of spill until
clean up has been completed. Maintain adequate ventilation. Shut off source of leak or spill if safe to do so.
Dike area of spill to prevent spreading and pump liquid to salvage container. Remaining liquid may be taken
up with absorbent material. Place contained material in approved salvage container with non-sparking tools.
Prevent run-off to sewer, streams or other bodies of water.
Section 7 HANDLING AND STORAGE
Handling: Wash hands before eating, smoking, or using the restroom. Eat only in designated areas. Smoke
only in approved designated areas.
Storage Temperatures: Keep from freezing. Store in a cool place in original container and protect from
sunlight.
Storage Pressure: Store at local atmospheric pressure.
General: Observe good housekeeping practices. Follow all MSD sheet and label warnings even after
container is emptied.
Keep from freezing. Use with adequate ventilation. Avoid prolonged or repeated breathing of vapors. Keep
containers tightly closed when not in use, and protect from moisture and foreign materials. Never use
pressure to empty the container. The container is not a pressure vessel.
Section 8 EXPOSURE CONTROL / PERSONAL PROTECTION
OSHA HAZARDOUS COMPONENTS (29 CFR 1910.1200)
Exposure Limits
Chemical Name OSHA PEL ACGIH TLV
1-Methyl-2-Pyrrolidinone NE NE
Dipropylene Glycol Butoxy Ether NE NE
2 mg/m3 2 mg/m3
Tin Oxide
Titanium Dioxide 15 mg/m3 10 mg/m3
Page 2 of 5
MSDS# 5700W Staticide Premium ESD Paint Page 3 of 5
Engineering Controls: Provide sufficient mechanical (general and/or local) ventilation to maintain exposure
below TLV(s)
Personal Protection:
Respirator If workplace limit(s) of product or any component is exceeded (see Section II), use appropriate
properly fitted NIOSH/MSHA approved respirator in absence of proper environmental control (see you safety
equipment supplier for proper respirator). Respiratory protection program must be in accordance with OSHA
Standard 29 CFR1910.134. Engineering and administrative controls should be implemented to reduce
exposure.
Hand Protection Use of chemical resistant, wear resistant gloves is advised to avoid contact with the
product.
Eye Protection: Chemical splash goggles in compliance with OSHA regulations are advised. However,
OSHA regulations also may permit the use of other types of safety glasses (consult your safety equipment
supplier).
Section 9 PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point: 171 ?444 / F Coverage: 250 sq ft / gal @ 2 mils
Evaporation rate: Slower than ether Freezing Point: 0癈 / 32癋
Percent Volatile by volume: 68 ?70
Odor: Solvent
Surface Resistivity: 10E6 ?10E9 ohms per square
Visual appearance: White
Vapor Density: Heavier than air Viscosity @ 77F / 25C: 90-150 seconds
Weight per gallon: 9 ?10 lbs
VOC Range: < 2.5 lbs/gallon
Section 10 STABILITY AND REACTIVITY
General: Stable. Polymerization will not occur.
Incompatible Materials and Conditions to Avoid: Avoid contact with strong oxidizing agents, acids, or
bases, or reactive metals such as aluminum or magnesium.
Hazardous Decomposition: Normal combustion products including carbon monoxide, carbon dioxide, and
oxides of nitrogen.
Section 11 TOXICOLOGY INFORMATION
Carcinogenicity: This product does not contain a substance listed by ACGIH, IARC, NTP, or CA Prop 65.
Mutagenicity: Not established
Reproductive toxicity / teratogenic effects: None Expected.
1-Methyl-2-pyrrolidinone is nvestigated as a mutagen, tumorigen and reproductive effector.
LD50 Rabbit (oral) 3914 mg/kg (1-Methyl-2-pyrrolidinone)
LD50 Rabbit (skin) 8 gm/kg (1-Methyl-2-pyrrolidinone)
Section 12 ECOLOGICAL INFORMATION
The LC50 96-hour values for fish are over 100 mg/l (1-Methyl-2-pyrrolidinone)
Section 13 DISPOSAL CONSIDERATIONS
RCRA 40 CFR 261 Classifications:
As packaged and after use, it does not meet the criteria of a hazardous waste as defied under the Resource
Conservation and Recovery Act (RCRA) 40 CFR 261, since it has neither the characteristics of Subpart C nor
is listed in Subpart D.
Federal, State, and Local laws governing disposal of material can differ.
Ensure proper disposal compliance with proper authorities before disposal.
Page 3 of 5
MSDS# 5700W Staticide Premium ESD Paint Page 4 of 5
Section 14 TRANSPORTATION INFORMATION
U.S. DOT Information
Proper Shipping Name: Non Hazardous Material
Hazard Class: NA
IATA
Proper Shipping Name: NON HAZARDOUS MATERIAL
Hazard Class: NA
Section 15 REGULATORY INFORMATION
MSDS complies with the OSHA Hazard Communication Rule, 29 CFR 1910.1200.
CERCLA/Superfund, 40 CFR 117.302:
SARA Superfund and Reauthorization Act of 1986 Title III sections 302, 311,312 and 313:
Section 302 ?Extremely hazardous substances (40 CFR 355): None of the chemicals are Section 302 hazards
Section 311/312 ?Material Safety Data Sheet Requirements (40 CFR 370): By our hazard evaluation, this
product is non-hazardous.
Section 313 ?List of Toxic Chemicals (40CFC 372): This product does not contain chemicals (at level of 1%
or greater) found on the 313 list of Toxic Chemicals.
Toxic Substance Control Act (TSCA): All substances are TSCA listed.
Resource Conservation and Recovery Act (RCRA 40 CFR 261) Subpart C & D: Refer to Section 13 for
RCRA classification.
STATE REGULATIONS:
California Proposition 65: This product does not contain a substance on prop 65.
INTERNATIONAL REGULATIONS:
Canada WHMIS: This product has been classified in accordance with the hazard criteria of
the CPR and the MSDS contains all the information required by the CPR.
Sections 16 OTHER INFORMATION
REVISION DATES, SECTIONS, REVISED BY:
17-Sept-09, Original release date, mkb
29-Sep-09 Update section 9, mkb
4-Dec-09 Revised section 2, mkb
ABBREVIATIONS USED IN THIS DOCUMENT:
NE ?Not Established, NA ?Not Applicable, NIF ?No Information Found
ABRIDGED LIST OF REFERENCES:
Code of Federal Regulations (CFR)
The Sigma-Aldrich Library of Regulatory and Safety Data
Chemical Guide and OSHA Hazardous Communication Standard
The Environmental Protection Agency (www.epa.gov)
ANSI Standard: ANSI Z400.1-1998
Merck Index
To the best of our knowledge, the information contained herein is accurate. However, neither ACL STATICIDE nor any of its
subsidiaries assumes any liability whatsoever for the accuracy or completeness of the information contained herein. Final
Page 4 of 5
MSDS# 5700W Staticide Premium ESD Paint Page 5 of 5
determination of suitability of any material is the sole responsibility of the user. All materials may present unknown hazards and should
be used with caution. Although certain hazards are described herein, we cannot guarantee that these are the only hazards which exist.
Page 5 of 5
|