PILOT SXS-40
1. PRODUCT AND COMPANY IDENTIFICATION
Product name PILOT SXS-40
Company Address 2744 East Kemper Road
Cincinnati, Ohio 45241
Emergency Telephone Number Chemtrec 1-800-424-9300
Pilot Chemical Corporate Office 1-513-326-0600
Potential Health Effects
Eyes Contact with eyes may cause irritation.
Skin Substance may cause slight skin irritation..
Inhalation May cause irritation of respiratory tract.
Ingestion Ingestion may cause gastrointestinal irritation, nausea, vomiting and diarrhea.
Chronic effects No information available
4. FIRST AID MEASURES
Eye Contact Rinse thoroughly with plenty of water, also under the eyelids. If symptoms persist, call a
physician.
Skin Contact Wash off immediately with soap and plenty of water removing all contaminated clothes and
shoes.
If symptoms persist, call a physician
Inhalation Move to fresh air. If symptoms persist, call a physician.
Ingestion Drink plenty of water. Do not induce vomiting without medical advice. Consult a physician.
5. FIRE-FIGHTING MEASURES
Flammable Properties Non-flammable water solution.
Flammable Limits Not Determined.
Hazardous Combustion Products Oxides of carbon. Oxides of sulfur.
FIRE FIGHTING INSTRUCTIONS:
Method Water mist may be used to cool closed containers.
Suitable Extinguishing Media Water spray. Foam. Dry powder. Carbon dioxide (CO2).
Unusual Fire & Explosive Hazards None
Small Spill Recover all usable material. Soak up balance with sand or dirt. Material is slippery on wet or
hard surfaces.
Large Spill In case of a large spill by truck, use small spill procedure and a vacuum truck. Call
CHEMTREC at 1-800-424-9300.
7. HANDLING AND STORAGE
Handling Wear personal protective equipment. Avoid contact with skin, eyes and clothing.
Storage Store above 45 癋 . Keep container tightly closed in a dry and well-ventilated place.
8. EXPOSURE CONTROLS / PERSONAL PROTECTION
Engineering measures Ensure adequate ventilation, especially in confined areas.
Eye/Face Protection Tightly fitting safety goggles. If splashes are likely to occur, wear:. Face-shield.
Skin Protection Wear protective gloves/clothing..
Respiratory Protection No special protective equipment required.
9. PHYSICAL AND CHEMICAL PROPERTIES
Boiling Point/Range Not available
Vapor pressure 16.6 mmHg @ 20 C
% Volatile by Weight 56-62
Water Solubility Soluble in all proportions
Specific Gravity 1.20
pH 7-9
Odor Mild detergent odor
Appearance Clear water white to pale yellow.
Physical state Liquid
10. STABILITY AND REACTIVITY
Chemical Stability Stable under normal conditions.
Component Freshwater Algae Freshwater Fish Microtox Water Flea
Sodium sulfate (solution) EC50 = 2564 mg/L 48 h
EC50 = 4547 mg/L 96 h
Ecotoxicity effects This surfactant complies with the biodegradability criteria as laid down in Regulation (EC) No.
648/2004 on detergents.
Chemical Fate Material is readily biodegradable.
13. DISPOSAL CONSIDERATIONS
Waste Disposal Methods Dispose of contents/container in accordance with local regulation.
14. TRANSPORT INFORMATION
DOT Not regulated
ICAO Not regulated
IATA Not regulated
IMDG/IMO Not regulated
RID Not regulated
ADR Not regulated
12/08/2008 Page 3 / 4 MSD 494S00D
15. REGULATORY INFORMATION
International Inventories
Component TSCA DSL NDSL EINECS ELINCS ENCS CHINA KECL PICCS AICS
Sodium sulfate (solution) X X - X - X X X X X
Sodium xylene sulfonate X X - X - X X X X X
Water X X - X - X X X X X
USA
Federal Regulations
SARA 313
Section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA). This product does not contain any
chemicals which are subject to the reporting requirements of the Act and Title 40 of the Code of Federal Regulations, Part 372.
SARA 311/312 Hazardous Categorization
Acute Health Hazard Yes
Chronic Health Hazard No
Fire Hazard No
Sudden Release of Pressure Hazard No
Reactive Hazard No
Clean Air Act, Section 112 Hazardous Air Pollutants (HAPs) (see 40 CFR 61)
This product does not contain any HAPs.
State Regulations
None
16. OTHER INFORMATION
Revision Date 12/08/2008
Prepared by Donna M. Mellon
Disclaimer
The information provided on this MSDS is correct to the best of our knowledge, information and belief at the date of its publication. The
information given is designed only as a guide for safe handling, use, processing, storage, transportation, disposal and release and is
not to be considered as a warranty or quality specification. The information relates only to the specific material designated and may not
be valid for such material used in combination with any other material or in any process, unless specified in the text.