Requisition Number NSN Z888-00-000-0028
Page 1 of 7
MATERIAL SAFETY DATA SHEET
SECTION 1: CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
COMPANY INFORMATION MSDS INFORMATION
H. B. Fuller company Preparation Date: 08/09/95
3530 Lexington Avenue N. Supersedes: 12/30/94
St. Paul, MN 55126-8076 Prepared By: Industrial Hygiene
Phone: 612-481-3300 Phone Number 612-481-4842
Fax: 612-481-3309
Medical Emergency Phone Number: 1-800-228-5635 ext 018
Transport Emergency Phone Number (Chemtrec): 1-800-424-9300
PRODUCT INFORMATION
Product Name/Number: SC-0639
Product Description (product use): Solvent based adhesive
SECTION 2: COMPOSITION/INFORMATION ON INGREDIENTS
This Material Safety Data Sheet is prepared to comply with the United States Occupational Safety and Health Administration (OSHA) Hazard Communication Standard (29 CFR 1910.1200) and the Canadian Workplace Hazardous Materials Information System (WHMIS). Unlisted ingredients are not 慼azardous' per the OSHA standard and/or are not found on the WHMIS ingredient disclosure list.
Chemical/CAS Number Percent OSHA PEL ACGIH TLV
n-Hexane (110-54-3) 30-50% 50 ppm 50 ppm
other isomers 500 ppm 500 ppm
LD50: 28,710 mg/kg (oral, rat) LC50: 48,000 ppm/4h (rat)
Vapor pressure, in mm Hg @ 20 C: 120
OSHA, ACGIH STEL: 1000 ppm (for isomers)
Mineral oil mist (8012-95-1) 1-5% 5mg/M3 5mg/M3
LD50: No data found LC50: No data found
ACGIH STEL: 10 mg/M3
Hydrocarbon oil 1-5% 5mg/M3* 5 mg/M3*
LD50: No data found LC50: No data found
*These exposure limits are for mineral oil mist, a material related to hydrocarbon oil mist.
ACGIH STEL: 10 mg/M3
See Section 16 for additional information.
NSN Z888-00-000-0028
Page 2 of 7
SECTION 3: HAZARDS IDENTIFICATION
EMERGENCY OVERVIEW
Flammable
Eye irritant
Contact will dry and defat the skin
Vapors harmful
Harmful if swallowed
Repeated exposure may lead to respiratory sensitization
POTENTIAL HEALTH EFFECTS
Eyes: Contact with product or high vapor levels will cause irritation
Skin: Liquid contact will dry and defat the skin. Prolonged or repeated contact may cause irritation and sensitization.
Inhalation: Overexposure to vapors in poorly ventilated areas will cause irritation of the nose, throat and respiratory tract and may cause dizziness, headaches, nausea or unconsciousness. Repeated exposure may lead to respiratory sensitization.
Ingestion: Harmful if swallowed
Chronic: Long-term overexposure to solvents cause liver and kidney damage. N-Hexane has been demonstrated to cause peripheral nerve damage in overexposed workers. Symptoms include loss of feeling and weakness in the hands and feet and loss of manual dexterity.
REGULATED CARCINOGEN STATUS:
This product does not contain regulated levels of NTP, IARC, ACGIH or OSHA listed carcinogens.
Existing Health Conditions Affected by Exposure: No known effects on other illnesses.
SECTION 4: FIRST AID MEASURES
If in eye: Flush immediately with large amounts of water for at least 15 minutes. Call a physician.
If on skin: Wash affected area with soap and water. Launder contaminated clothing before reuse.
If vapors inhaled: Remove from exposure. Restore breathing if necessary. Keep warm and quiet. Call a physician.
If ingested: If person can swallow, give one glass of water or milk. Do not induce vomiting. Get immediate medical attention. Never give
Z888-00-000-0028
Page 3 of 7
anything by mouth to an unconscious person.
SECTION 5: FIRE FIGHTING MEASURES
Flash Point/Method: Less than 0 degrees F TCC, Less than -18 degrees C
Upper Explosive Limit/Lower Explosive Limit: Not established
Autoignition Temperature: Not established
Appropriate Extinguishers: Use water spray, foam, dry chemical or carbon dioxide.
Special Fire Fighting Procedures: Persons exposed to products of combustion should wear self-contained breathing apparatus and full protective equipment.
Unusual Fire and Explosion Hazards: There is the possibility of pressure buildup in closed containers when heated. Water spray may be used to cool containers.
Solvent vapors are heavier than air any may travel along the ground or be moved by ventilation and ignited by heat, pilot lights, other flames and ignition sources at locations distant from the material handling point. Never use welding or cutting torch on or near drum (even empty) because product (even just residue) can ignite explosively.
Hazardous Combustion Product: Incomplete combustion can yield low molecular weight hydrocarbons, carbon monoxide.
SECTION 6: ACCIDENTAL RELEASE MEASURES
Spill or Leak Procedures: Remove all sources of ignition. Ventilate area. Avoid breathing vapors. Dike and contain spill with inert absorbent and transfer to container for disposal. Use non-sparking tools. Keep spill out of sewers.
SECTION 7: HANDLING AND STORAGE
HANDLING INFORMATION: Keep away from sparks and flame. Avoid breathing vapors. Use only with adequate ventilation. Avoid contact with eyes, skin and clothing. Wash thoroughly after handling. Keep container closed. Emptied container retains vapor and product residue. Observe all labeled precautions until container is cleaned. DO NOT CUT OR WELD ON OR NEAR THIS CONTAINER.
NSN Z888-00-000-0028
Page 4 of 7
STORAGE INFORMATION: Consult the Technical Data Sheet for specific storage instructions.
SECTION 8: EXPOSURE CONTROLS/PERSONAL PROTECTION
Eye Protection: Wear safety glasses to reduce the potential for eye contact; chemical safety goggles are appropriate if splashing is likely. Have eye washes available where eye contact can occur.
Skin Protection: Prevent contact by using rubber gloves and appropriate protective clothing. Launder contaminated clothing before reuse.
Respiratory Protection: Use NIOSH approved supplied air respirator in conditions warrant.
Ventilation: Local exhaust ventilation preferred. Provide ventilation to control contaminant levels below airborne exposure limits.
SECTION 9: PHYSICAL AND CHEMICAL PROPERTIES
Physical State: Liquid
Color: Amber
Odor: Pungent Solvent
Odor Threshold: Not established
Weight per Gallon: 7.2 lbs
Specific Gravity: 0.85
% Solids by Weight: 60
pH: Not applicable
Boiling Range: Greater than 156 F (69 C)
Freezing/Melting Point: Not applicable
Vapor Pressure: Not established
Vapor Density: Not established
Evaporation Rate: Not established
Water/Oil Partition Coefficient: Not established
VOC: 345 g VOC/liter of material
(VOC theoretically determined using EPA Publication 450/3-84-019)
VOC, less water: 345 g VOC/liter of material, less water and exempt solvents
(VOC theoretically determined using EPA Publication 450/3-84-019)
Z888-00-000-0028
Page 5 of 7
SECTION 10: STABILITY AND REACTIVITY DATA
Stability: Stable
Incompability: Not established
Hazardous Decomposition: Not established
Hazardous Polymerization: Will not occur
SECTION 11: TOXICOLOGICAL INFORMATION
No data available
SECTION 12: ECOLOGICAL INFORMATION
No data available
SECTION 13: DISPOSAL CONSIDERATIONS
This product meets the definition of hazardous waste under the U.S. EPA Hazardous Waste Regulations 40 CFR 261. It is ignitable waste. Class D001. Disposal via incineration is recommended. Consult your state, local, or provincial authorities for more restrictive requirements.
SECTION 14: TRANSPORTATION INFORMATION
UNITED STATES DEPARTMENT OF TRANSPORTATION (DOT)
DOT Proper Shipping Name: Adhesives
DOT Hazard Class/I.D. Code: 3, UN1133
DOT Label: FLAMMABLE LIQUID
DOT Packaging Group: III
It is our opinion that the information provided here may be used to transport this product in compliance with Canadian Transportation of Dangerous Goods.
SECTION 15: REGULATORY INFORMATION
FEDERAL
Toxic Substances Control Act (TSCA)
Section 8 (b) - Inventory Status
All components of this product are registered under the regulations of the Toxic Substance Control Act
Section 12 (b) - Export Notice Requirements
Z888-00-000-0028
Page 6 of 7
This product contains a chemical substance that is currently on the EPA's Section 12 (b) Export List. Within seven days of entering into a contract to export and certainly no later than the day of export, the agent of export must notify the EPA of their intent.
Contact the H.B. Fuller TSCA Compliance Manager at 612-481-4816 for the identity of the Section 12 (b) chemical(s).
SARA TITLE III
Section 313
This product contains the following toxic chemical(s) subject to the reporting requirements of section 313 of Title III of the Superfund Amendments and Reauthorization Act of 1986 (SARA) and 40 CFR
Chemical Name CAS Number Percent
n-Hexane 110-54-3 30-50%
STATE REGULATIONS
California Proposition 65: Proposition 65, The Safe Drinking Water and Toxic Enforcement Act of 1986:
This product contains chemical(s) known to the state of California to cause cancer (c) or reproductive (r) damage.
<0.0003% Benzene (c) 71-43-2
listed February 27, 1987
WHMIS IDENTIFICATION/OTHER INTERNATIONAL REGULATIONS
B2, D2B
SECTION 16: ADDITIONAL INFORMATION
Drums of this material should be grounded when pouring. This product contains the following substance(s) identified by OSHA, WHMIS, or the ACGIH as hazardous. During normal use, the material will not present an exposure risk. Once the product has reached its final state and is abraded or disturbed, dusting and exposure may occur.
1-5% Calcium carbonate (1317-65-3)
Exposure limit total dust 15 mg/M3 (OSHA) 10 mg/M3 (ACGIH)
Exposure limit respirable dust 5 mg/M3 (OSHA)
LD50: No data found LC50: No data found
Z888-00-000-0028
Page 7 of 7
HMIS RATING
Health-2 Flammability-3 Reactivity-0
See Section 8: EXPOSURE CONTROL/PERSONAL PROTECTION for personal protective equipment recommendations.
The information and recommendations set forth therein are believed to be accurate. Because some of the information is derived from information provided to the H.B. Fuller Company from its suppliers, and because the H.B. Fuller Company has no control over the conditions of handling and regarding the accuracy of the data or the results to be obtained from the use thereof. The information is supplied solely for your information and consideration, and the H.B. Fuller Company assumes no responsibility from use or reliance thereon. It is the responsibility of the user of H.B. Fuller Company products to comply with all applicable federal, state and local laws and regulations.
|