Material Safety Data Sheet TRIBOLUBE-2N
QUICK IDENTIFIER
May be used to comply with OSHA's ,Hazard Communication Standard.
29 CFR 1910. 1200 Standard must be consulted for specific requirements. Common Name: (used on Label and list)
SECTION 1- MANUFACTURER
Manufacturer's
HEALTH 1
Name Aerospace Lubricants, Inc
Address
FLAMMABILITY 0
Emergency
1600 Georgesville Road Telephone No.
614-878-3600
Other
City, State, and Zip
REACTIVITY 0
Columbus, Ohio 43228 Information
614-878-3600
Calls
B
January 12, 2004 PERSONAL PROTECTION
Signature of Person Date
Prepared Rev. B
Responsible for Preparation Stephen E. Gates
SECTION 2- HAZARDOUS INGREDIENTS/IDENTITY
Hazardous Component(s) (chemical & common name(s) OSHA ACGIH Other Exposure % CAS
PEL TLV Limits (optional) NO.
No hazardous components were knowingly incorporated into this lubricant. This product is not considered hazardous according to the OSHA
Hazardous Communication Standard 29CFR 1910.1200
SECTION 3 - PHYSICAL & CHEMICAL CHARACTERISTICS
Boiling Specific Vapor
Point Gravity (H O=1)
Above 500潞 F Pressure (mm Hg)
1.86 Less than 5 mm
Vapor
Density (Air=1)
N/A
Solubility Reactivity in
in Water Water
Negligible Negligible
Melting
Appearance
Yellow Grease, slight petroleum odor Point
and Odor
Above 550潞 F
SECTION 4 - FIRE & EXPLOSION DATA
Flash UEL
Flammable Limits LEL
Method
Point Upper
in Air % by Volume Lower
N/A N/A N/A
Used N/A
N/A
Extinguisher
Auto-Ignition
Media
Temperature
CO2 , dry chemical, foam, water spray
Above 600潞F
Special Fire
Fighting Procedures
Self contained breathing apparatus and protective clothing should be worn in fighting fires involving chemicals. Decomposition
at temperatures above 290潞C may cause the evolution of toxic gasoeus fluorine compounds.
Unusual Fire and
Explosion Hazards
Toxic fluorine gases are by-products of combustion
Tribodat/tribomsd/T-2N
TRIBOLUBE-2N
SECTION 5 - PHYSICAL HAZARDS (REACTIVITY DATA)
Conditions
Stability Unstable
to Avoid
Stable X Strong Oxidizers
Incompatability
(Materials to Avoid Oxidizing material can cause a reaction
Hazardous
Fluorine products, CO2 , traces of incompletely burned carbon
Decomposition Products
May Cccur Conditions
Hazardous
to Avoid
Will Not Occur X
polymerization
None Known
SECTION 6 - HEALTH HAZARDS
1. Acute 2. Chronic
None None
Signs and
Prolonged and repeated contact with skin may cause skin irritation.
Sympton of Exposure
Decomposition products formed at high temperatures above 250潞C may cause "polymer fever."
Medical Condition Generally
No known medical condition that might be aggravated by exposure
Aggravated by Exposure
National Toxicology I.A.R.C. OSHA Yes
Yes
Yes
Chemical Listed as Carcinogen
X
Program Monographs No
X X
No No
or Potential Carcinogen
Emergency and
First Aid Procedures Skin contact: Wipe off and wash with soap and water.
1. Inhalation
Remove to fresh air, if necessary seek medical attention
2. Eyes
ROUTES
Flush with water, get medical attention
OF 3. Skin
ENTRY Wipe off and wash with soap and water
4. Ingestion
No known adverse effects are known, consult physician
SECTION 7 -SPECIAL PRECAUTION AND SPILL/LEAK PROCEDURES
Precautions to be Taken
Use reasonable care. Do not store above 250潞F or near flammables
in Handling and Storage
Other
Toxic vapors may evolve above 550潞F; provide adequate ventilation if used above this temperature.
Precautions
Avoid spills; causes slippery surfaces.
Steps to be Taken in Case
Material is Released or Spilled Scrape up with proper tools; wipe up with absorbant cloth or paper towel; apply non-skid absorbant material to floor. Collect
waste materials for salvage or disposal.
Waste Disposal
Methods (Consult federal, state, and local regulations)
Dispose of in accordance with current Federal, State, and Local Regulations.
SECTION 8 - SPECIAL PROTECTION INFORMATION/CONTROL MEASURES
Respiratory Protection
Not required unless product is being used as a mist.
(Specify Type)
Mechanical Special
Local Other
Ventilation
Exhaust (General)
Not required Recommended Not Required
Recommeneded
Protective Eye
Gloves Safety glasses recommeneded.
Protection
Plastic disposable
Other Protective
Clothing or Equipment Plastic apron, fabric laboratory coat recommended.
Work/Hygienic Practices
Do not contaminate smoking materials; wash hands and / or contaminated area after exposure.
|