MATERIAL SAFETY DATA SHEET
Inter-Lock #90 (10mL bottle)
Product Number: 790 Note: Blank spaces are not permitted. If any item is not applicable or no
Threadlocker information is available, the space must be marked to indicate that.
SECTION I - CHEMICAL PRODUCT AND COMPANY IDENTIFICATION
Company Name, Address Infotrac Number Outside U.S. Call Collect
International Epoxies and Sealers 1 (352) 323-3500
(800) 535-5053
P.O. Box 185 Telephone Number for Information
San Antonio, FL 33576 U.S.A (800)451-7206
08-16-2007
Date Prepared:
SECTION II - HAZARDOUS INGREDIENTS/IDENTITY INFORMATION
CAS # % ACGIH TVL OSHA PEL
Hazardous Components
Polyglycol dimethacrylate 25852-47-5 60-100 None None
Saccharin 81-07-2 1-5 None None
Cumene hydroperoxide 80-15-9 1-5 None None
United States Regulatory Information
All components are listed or are exempt from listing on the Toxic Substances
TSCA 8 (b) Inventory Status: Control Act Inventory.
TSCA 12 (b) Export Notification: None. None
CERCLA/SARA Section 302 EHS: None above reporting de minimum
CERCLA/SARA Section 311/312: Immediate Health Hazard, Delayed Health Hazard
This product contains the following toxic chemicals subject to the reporting
CERCLA/SARA 313: requirements of section 313 of the Emergency
Planning and Community Right-To-Know Act of 1986 (40 CFR 372). Cumene
hydroperoxide (CAS# 80-15-9)
This product contains a chemical known to the State of California to cause cancer
California Proposition 65: and birth defects or other reproductive harm.
1,4-Dioxane (CAS# 123-91-1), Ethylene oxide (CAS# 75-21-8),. Arsenic (CAS#
7440-38-2). Lead (CAS# 7439-92-1)
HMIS: HEALTH: 1 FLAMMABILITY: 1 REACTIVITY: 1 PPE: H
WARNING: CAUSES EYE IRRITATION. MAY CAUSE SKIN IRRITATION. MAY CAUSE ALLERGIC SKIN
REACTION. MAY CAUSE RESPIRATORY TRACT IRRITATION
SECTION III - PHYSICAL/CHEMICAL CHARACTERISTICS
Boiling Point: Greater than 149 Deg. C (300 Deg. F) Specific Gravity: (H2O=1) 1.1 at 23.9 deg. C (75 Deg F)
Vapor Pressure: Less than 5mm Hg at 27 Deg. C (80 Deg. F) Melting Point: Not available
Solubility in Water: Slight Evaporation Rate: Not available
Appearance and Odor: Green liquid with mild odor VOC Content: 4.39%, 48.6 grams/liter (EPA Method 24)
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flash Point: Greater than 93 deg. C (200 Deg F) Cleveland closed cup.
Flammable Limits: LEL%: 2.6 (propylene glycol), UEL%: 12.5% (propylene glycol)
Extinguishing Media: . Foam, dry chemical or carbon dioxide
Special Fire Fighting procedures: None
Unusual Fire or Explosion Hazards: None
Oxides of carbon. Oxides of sulfur. Oxides of nitrogen. Irritating organic vapors.
Hazardous Combustion Products:
SECTION V - REACTIVITY DATA
Stability: Stable
Hazardous polymerization: Will not occur
Hazardous decomposition products: Oxides of carbon. Oxides of sulfur. Oxides of nitrogen. Irritating organic vapors
Strong oxidizers. Free radical initiators. Strong reducing agents. Alkalis. Oxygen
Incompatibility: scavengers. Other polymerization initiators. Copper, Iron, Zinc, aluminum, Rust.
See "Handling and Storage" (Section VII) and "Incompatibility" (Section V)
Conditions to Avoid:
1 of 3 Pages IES 08/2007
MATERIAL SAFETY DATA SHEET
SECTION VI - HEALTH HAZARD DATA
Routes of Entry: Skin, Inhalation, Eyes
Health Hazards (Acute And Chronic): May cause respiratory tract irritation.
May cause allergic skin reaction. May cause skin irritation.
Contact with eyes will cause irritation.
Ingestion: Not expected to be harmful by ingestion.
Carcinogenicity: NTP Carcinogen IARC Carcinogen OSHA Carcinogen
Polyglycol dimethacrylate No No No
Saccharin No No No
Cumene hydroperoxide No No No
Skin: Prolonged or repeated contact may cause skin irritation.
Signs and Symptoms of Exposure See Above
Medical Conditions: Generally aggravated by Exposure. Respiratory if very high concentration.
Emergency and First Aid Procedures:
Inhalation: Remove to fresh air. If symptoms develop and persist, get medical attention.
Wash with soap and water. Remove contaminated clothing and shoes. Wash
Skin Contact: clothing before reuse. Get medical attention if symptoms occur.
Flush with copious amounts of water, preferably, lukewarm water for at least 15
Eye Contact: minutes, holding eyelids open all the time. Get medical attention.
Ingestion: Do not induce vomiting. Keep individual calm. Obtain medical attention.
SECTION VII - PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS SPILLED OR Eliminate sources of ignition. Small spills, allow to dry or cleanup with inert
RELEASED absorbent. Store in partly filled, closed container until disposal.
Prevent product from entering drains and/or open waters.
Waste Disposal Method: Dispose of according to Federal, State and local governmental regulations.
EPA Hazardous Waste Number: Not a RCRA hazardous waste.
Precautions to be Taking in Handling and Storage: Keep away from heat, sparks and flame. Use with adequate ventilation.
Comply with all Federal, State and Local codes pertaining to storage.
For safe storage, store at or below 38 Deg. C (100 deg. F)
Keep container tightly closed until ready for use.
Other Precautions: Do not spray near sources of ignition, open fires, lit cigarettes, etc.
SECTION VIII - CONTROL MEASURES
Respiratory protection: Use NIOSH approved respirator if there is potential to exceed exposure limit(s).
No specific ventilation requirements noted, but forced ventilation may still be
Ventilation: required if concentrations exceed occupational exposure limits.
Use impermeable gloves and protective clothing as necessary to prevent skin
Skin Protection: contact. Neoprene gloves. Butyl rubber gloves. Natural rubber gloves.
Avoid contact with skin and clothing. Void breathing vapor and mist. Wash
thoroughly after handling.
Eye/face protection: Safety goggles or safety glasses with side shields.
See Section II for exposure limits.
SECTION IX - TRANSPORT INFORMATION
U. S. Department of Transportation (49 CFR)
Proper shipping name: Unrestricted
Hazard class or division None
Identification Number: None
Packing group: None
International Air Transportation (ICAO/IATA):
Proper shipping name: Unrestricted
DISCLAIMER:
The information contained within this MSDS applies only to the IES product to which the sheet relates. The information provided
is based on our best knowledge at the time of issue.
The information contained within this MSDS is believed to be accurate and is given in good faith. However, no warranty is made, either
expressed or implied, regarding its accuracy or any liability arising out of the use of the information herein or the product supplied.
When used in other preparations, formulations, or in mixtures, it is necessary to ascertain whether the classifications of the hazards have changed. The
attention of the user is drawn to the possibility of creating other hazards when the product is used for purpose other than that for which it was
recommended. In such cases, a reassessment may be necessary and should be made by the user.
This MSDS should only be used and reproduced in order that the necessary measures are taken relating to the protection of health and safety
at work.
It is the responsibility of the handlers to pass on the totality of the information contained within this document to any subsequent person(s) who will
come in to contact with, handle or use this product in any way.
2 of 3 Pages IES 08/2007
MATERIAL SAFETY DATA SHEET
They should check the adequacy of the information provided within this MSDS before passing it on to their customers/staff.
3 of 3 Pages IES 08/2007
|