Page 1 of 6
MATERIAL SAFETY DATA SHEET
__________________________________________________________________________________________
SECTION 1 IDENTIFICATION OF THE SUBSTANCE/PREPARATION AND OF THE
COMPANY/UNDERTAKING
LUBRIPLATE?Lubricants Co. Emergency Telephone Number:
129 Lockwood St. 1-800-255-3924-CHEM-TEL (24 hour)
Newark, NJ 07105 Telephone Number for information:
1-973-589-9150
__________________________________________________________________________________________
SECTION 2 COMPOSITION/INFORMATION ON INGREDIENTS
COMPONENT: Polyalphaolefin
CAS NUMBER: 68037-01-4
EC NUMBER (EINECS): 500-183-1
PERCENTAGE: 95-100
COMPONENT: Benzenepropanoic acid
CAS NUMBER: 41484-35-9
EC NUMBER (EINECS): 255-392-8
PERCENTAGE: 0-1
COMPONENT: Alkylated diphenylamine
CAS NUMBER: 41484-35-9/68411-46-1
EC NUMBER (EINECS): 255-392-8/270-128-1
PERCENTAGE: 0-1
COMPONENT: Triphenyl phosphorothionate
CAS NUMBER: 597-82-0
EC NUMBER (EINECS): 209-909-9
PERCENTAGE: 0-1
COMPONENT: Amines
CAS NUMBER: 80939-62-4
EC NUMBER (EINECS): 500-004-7
PERCENTAGE: 0-1
Page 2 of 6
COMPONENT: Phosphate derivatives
CAS NUMBER: NA
EC NUMBER (EINECS): NA
PERCENTAGE: 0-1
COMPONENT: Polyisobutylene
CAS NUMBER: 9003-27-4
EC NUMBER (EINECS): not assigned
PERCENTAGE: 0-1
COMPONENT: Propyl paraben
CAS NUMBER: 94-13-3
EC NUMBER (EINECS): 202-307-7
PERCENTAGE: 0-1
COMPONENT: Antifoam/defoamer
CAS NUMBER: NA
EC NUMBER (EINECS): NA
PERCENTAGE: 0-1
NOTE: The IP 346 value of the mineral oil is less than 3%
POTENTIAL HEALTH EFFECTS:
INHALATION:
SHORT TERM EXPOSURE: Irritation
LONG TERM EXPOSURE: Lung damage
SKIN CONTACT:
SHORT TERM EXPOSURE: Irritation
LONG TERM EXPOSURE: Irritation, skin disorders
EYE CONTACT:
SHORT TERM EXPOSURE: Irritation
LONG TERM EXPOSURE: No information available
INGESTION:
SHORT TERM EXPOSURE: Diarrhea, difficulty breathing
LONG TERM EXPOSURE: no information on significant adverse effects
HAZARDOUS MATERIAL IDENTIFICATION SYSTEM (HMIS):
Health ?1
Flammability ?1
Reactivity ?0
Not a Controlled Product under (WHMIS) ?Canada Special Protection: See Section 8
Page 3 of 6
__________________________________________________________________________________________
SECTION 4 FIRST AID MEASURES
INHALATION: Vapor pressure is very low and inhalation at room temperature is not a problem. If overcome
by vapor from hot product, immediately remove from exposure and call a physician.
SKIN CONTACT: Remove any contaminated clothing and wash with soap and warm water. If injected by
high pressure under skin, regardless of the appearance or its size, contact a physician IMMEDIATELY. Delay
may cause loss of affected part of body.
EYE CONTACT: Flush eyes with clear water for 15 minutes or until irritation subsides. If irritation persists,
consult a physician.
INGESTION: If ingested, call a physician immediately. Do not induce vomiting.
__________________________________________________________________________________________
SECTION 5 FIRE FIGHTING MEASURES
FIRE AND EXPLOSION HAZARDS: Slight fire hazard
EXTINGUISHING MEDIA: Foam, dry chemical, carbon dioxide or water spray (fog)
FIRE FIGHTING: Cool exposed containers with water. Use air-supplied breathing equipment for enclosed or
confined spaces.
HAZARDOUS COMBUSTION PRODUCTS:
Thermal decomposition products or combustion: oxides of carbon, oxides of sulphur
UNUSUAL FIRE AND EXPLOSION HAZARDS: Do not store or mix with strong oxidants. Empty
containers contain residue. Do not cut, drill, grind, or weld, as they may explode.
OCCUPATIONAL RELEASE: Recover liquid, wash remainder with suitable petroleum solvent or add
absorbent. Keep petroleum products out of sewers and watercourses. Advise authorities if product has entered
or may enter sewers and watercourses.
__________________________________________________________________________________________
SECTION 7 HANDLING AND STORAGE
STORAGE: Store and handle in accordance with all current regulations and standards. Keep container tightly
closed. Keep away from heat, sparks, and flame. See original container for storage recommendations. Keep
separated from incompatible substances.
EXPOSURE LIMITS:
Page 4 of 6
White mineral oil:
MINERAL OIL MIST:
5 mg/m3 UK OES TWA
10mg/m3 UK OES STEL
VENTILATION: Provide local exhaust ventilation system. Ensure compliance with applicable exposure
limits.
EYE PROTECTION: Wear splash resistant safety goggles. Provide an emergency eye wash fountain and
quick drench shower in the immediate work area.
CLOTHING: Wear appropriate chemical resistant clothing.
GLOVES: Wear appropriate chemical resistant (nitrile) gloves.
RESPIRATOR: Consider the need for appropriate protective equipment, such as self-contained breathing
apparatus, adequate masks and filters.
__________________________________________________________________________________________
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
PHYSICAL STATE: liquid
APPEARANCE: clear
COLOUR: water-white
PHYSICAL FORM: oil
ODOR: odorless
BOILING POINT: >288 C
FREEZING POINT: Not available
FLASH POINT: 288 C (COC)
LOWER FLAMMABLE LIMIT: 0.9% by volume
UPPER FLAMMABLE LIMIT: 7.0% by volume
AUTO IGNITION: 307 C (COC)
VAPOUR PRESSURE: <0.01 mm Hg
VAPOR DENSITY (air=1): >5
SPECIFIC GRAVITY (water=1): 0.8597
DENSITY: not available
WATER SOLUBILITY: negligible
pH: not available
VOLATILITY: not available
ODOR THRESHOLD: not available
EVAPORATION RATE: <0.01 (Butyl acetate=1)
VISCOSITY: 46.6 mm2/s @ 100 C
COEFFICIENT OF WATER/OIL DISTRIBUTION: not available
__________________________________________________________________________________________
SECTION 10 STABILITY AND REACTIVITY
REACTIVITY: Stable at normal temperatures and pressures
Page 5 of 6
CONDITIONS TO AVOID: Avoid heat, flames, sparks and other sources of ignition. Avoid contact with
strong oxidants like liquid chlorine, concentrated oxygen.
INCOMPATIBLES: Oxidising materials, chlorine
HAZARDOUS DECOMPOSITION:
Thermal decomposition products or combustion: oxides of carbon, oxides of sulphur
POLYMERISATION: Will not polymerise.
__________________________________________________________________________________________
SECTION 11 TOXICOLOGICAL INFORMATION
Polyalphaolefin:
TOXICITY DATA:
Greater than 2,000 mg/kg LD50 oral-rat
Benzenepropanoic acid:
TOXICITY DATA:
Greater than 5,000 mg/kg LD50 oral-rat
Alkylated diphenylamine:
TOXICITY DATA:
Greater than 5,000 mg/kg LD50 oral-rat
Triphenyl phosphorothionate:
TOXICITY DATA:
Greater than 10,000 mg/kg LD50 oral-rat
Amines:
TOXICITY DATA:
Greater than 5,000 mg/kg LD50 oral-rat
Phosphate derivatives:
TOXICITY DATA:
Greater than 2,000 mg/kg LD50 oral-rat
Polyisobutylene:
TOXICITY DATA:
No data available
Propyl paraben:
TOXICITY DATA:
Greater than 8,000 mg/kg LD50 oral-rat
Antifoam/defoamer:
TOXICITY DATA:
Greater than 10,000 mg/kg LD50 oral-rat
Page 6 of 6
____________________________________________________________________________________________________________
SECTION 12 ECOLOGICAL INFORMATION
Dispose in accordance with all applicable regulations
__________________________________________________________________________________________
SECTION 14 TRANSPORT INFORMATION
LAND TRANSPORT ADR: No classification assigned.
LAND TRANSPORT RID: No classification assigned.
AIR TRANSPORT IATA: No classification assigned.
AIR TRANSPORT ICAO: No classification assigned.
MARITIME TRANSPORT IMDG: No classification assigned.
__________________________________________________________________________________________
SECTION 15 REGULATORY INFORMATION
EUROPEAN REGULATIONS:
EC CLASSIFICATION (CALCULATED): Not classified as dangerous.
__________________________________________________________________________________________
SECTION 16 OTHER INFORMATION
The above information is furnished without warranty, expressed or implied, except that it is accurate to
the best knowledge of LUBRIPLATE Lubricants Company. The data on these sheets relates only to the
specific material designated herein. LUBRIPLATE Lubricants Company assumes no legal responsibility
for use or reliance upon this data.