DOT REGULATED-SEE 11
M a t e r ii a ll S a f e t y D a t a S h e e t
Mater a Safety Data Sheet
MMP Primer
Component B
MANUFACTURER
Elastomer Specialties, Inc.
2210 South Highway 69
Wagoner, OK 74467 Issued: June 2008
(918) 485-2835 Revised: August 2009
1 - Chemical Product Identification
Product Code: 2105
Product Name: MMP Primer Component B
Product Description
Synonyms
Formula Not applicable
2 - Composition / Information on Ingredients
CHEMICAL/CAS# EXPOSURE LIMITS (Wt.%)
Methyl Amyl Ketone ACGIH TLV: 50 ppm TWA ACGIH STEL: 5-20
(1) CAS # 110-43-0 OSHA PEL: 100 ppm TWA OSHA Ceiling:
OSHA Peak:
Vapor Pressure: 2.14 mm LEL%: 1.1
Butyl Acetate ACGIH TLV: 150 ppm TWA ACGIH STEL: 200 ppm 5-20
(1) CAS # 123-86-4 OSHA PEL: 150 ppm TWA OSHA Ceiling:
OSHA Peak:
Vapor Pressure: 7.8 mm Hg@20癈 LEL%: 1.7
Oxo-Hexyl Acetate ACGIH TLV: ACGIH STEL: 1-5
(1) CAS # 88230-35-7 OSHA PEL: OSHA Ceiling:
OSHA Peak:
PropyGlycolMethylEtherAcet ACGIH TLV: N/E ACGIH STEL: N/E 1-5
(1) CAS # 108-65-6 OSHA PEL: N/E OSHA Ceiling:
OSHA Peak:
Vapor Pressure: 3.7 mm Hg@20癈 LEL%: 1.6
Ethyl Benzene ACGIH TLV: 100 ppm TWA ACGIH STEL: 125 ppm 0.498
CAS # 100-41-4 OSHA PEL: 100 ppm TWA OSHA Ceiling:
OSHA Peak:
Warning message: 1. Reports have associated repeated and prolonged occupational over-exposure to solvents with
permanent brain and nervous system damage. Intentional misuse by deliberately concentrating and inhaling the
contents may be harmful or fatal. Chronic exposure may cause damage to the central nervous system, respiratory
system, lung, eye, skin, liver, gastrointestinal tract, spleen, kidneys, and blood.
2. See section IX for reportable hazardous air pollutants.
3 - Hazards Identification
Emergency Overview! Danger
Ethyl benzene is classified as "possibly" carcinogenic to humans, Class 2Bm by the International Agency for
Research on Cancer (IARC), on the basis of sufficient evidence of carcinogenicity in laboratory animals but inadequate
evidence for cancer in humans. Prolonged or repeated over-exposure to ethyl benzene may cause the following: kidney
effects, liver effects, lung effects, thyroid effects, testicular effects, pituitary effects.
Medical conditions prone to aggravation by exposure: consult physician.
Elastomer Specialties, Inc. MSDS MMP Primer Side B Page 2
Primary Route (s) of Entry: Skin and Inhalation.
SKIN CONTACT:
Acute: Severe irritant, corrosion to tissue, possible skin burns.
Chronic: Causes burns to exposed tissue.
EYE CONTACT: Acute: Severe irritant, chemical burn possible, possible tissue damage.
INHALATION:
Acute: Moderate to severe irritant.
Chronic: Slightly toxic with repeated inhalation.
INGESTION:
Acute: Severe irritation, possible gastrointestinal tract.
Chronic: Slightly toxic with repeated ingestion.
Medical Conditions Generally Aggravated by Exposure: Eye disease, kidney and liver disorders, skin disorders and
allergies.
4 - First Aid Measures
Emergency and First Aid Procedures:
Skin Contact: Immediately flush with water for at least 15 minutes while removing contaminated clothing. Wash the
contaminated skin with soap and water. If clothing comes in contact with the product, the clothing should be
laundered before reuse.
Eye Contact: Immediately flush with large amounts of water for at least 15 minutes occasionally lifting the upper and
lower eyelids. Call a physician for medical treatment.
Inhalation: Remove to fresh air. Restore breathing. Treat symptomatically. Consult a physician.
Ingestion: If swallowed, call a physician immediately. Remove stomach contents by gastric suction or induce vomiting
only as directed by medical personnel. Never give anything by mouth to an unconscious person.
5 - Fire Fighting Measures
FLASH POINT: 27癈 - 80癋 LEL: See Section II
FLAMMABILITY CLASSIFICATION: Class 1C
HAZARD CLASSIFICATION: *Flammable Liquid*
RECOMMENDED EXTINGUISHING MEDIA: Carbon Dioxide (CO2), fire foam, dry chemical.
SPECIAL FIRE FIGHTING PROCEDURES: Burning will product toxic fumes. Wear self-contained breathing
apparatus and full turn-out gear to fight fires. USE WATER WITH CAUTION. Material will float and may ignite on
surface of water. Use water spray to keep fire exposed containers cool. Water may be ineffective in fighting the
fire.
UNUSUAL FIRE OR EXPLOSION HAZARDS: With excessive heat, cans will rupture from internal pressure and
discharge flammable contents. Vapors may ignite explosively. Keep away from heat, sparks and flame. Do not
smoke. Extinguish all flames and pilot lights, and turn off stoves, heaters, electric motors and other sources of
ignition during use and until all vapors are gone. Prevent build up of vapors by opening all windows and doors to
achieve cross-ventilation.
6 - Accidental Release Measures
SPILL OR LEAK PROCEDURES: Remove all sources of ignition (flames, hot surfaces and electrical, static or frictional
sparks). Avoid breathing vapors. Ventilate area. Use non-sparking tools. Remove with inert absorbant.
7 - Handling and Storage
Do not handle or use product until safety precautions recommended in this data sheet have been read and fully
understood. This product contains no reportable Hazardous Air Pollutants.
Precautions: Keep away from heat. Keep away from sparks, flames and other sources of ignition. Store in a cool, dry
place. Keep container closed when not in use. Avoid contact with eyes, skin and clothing. Avoid breathing vapor
or mist. Use with adequate ventilation.
Waste Disposal Method: Waste must be disposed of in accordance with federal, state and local environmental control
regulations.
8 - Personal Protection/Exposure Controls
EYE PROTECTION REQUIREMENTS: Wear splash proof eye goggles or safety glasses if there is a danger of splashing
or if product is applied by spraying.
Revised: August 2009
2210 South Highway 69, Wagoner, OK 74467 * 918-485-2835 * Fax 918-485-2856 * www.elastomer.com / www.gatorhyde.com
Elastomer Specialties, Inc. MSDS MMP Primer Side B Page 3
SKIN PROTECTION REQIREMENTS: Impermeable gloves to prevent skin contact.
RESPIRATORY REQUIREMENTS: In confined areas of poor ventilation, use chemical cartridge respirator or self-
contained breathing apparatus.
VENTILATION: Provide general dilution or local exhaust ventilation in volume and pattern to keep TLV and LEL of most
hazardous ingredient in section II, below acceptable limit.
OTHER PROTECTIVE EQUIPMENT: Safety showers and eyewash stations should be available. Educate and train
employees in safe use of product. Promote frequent hand washing with soap and water.
9 - Physical and Chemical Properties
PHYSICAL FORM: Liquid COLOR: Grey ODOR: ODOR THRESHOLD:
WEIGHT PER GALLON 11.96 lbs.
BOILING POINT 244?308?F
% VOLATILE BY VOLUME: 51.81 %
VAPOR DENSITY heavier than air
EVAPORATION RATE: * slower than ether *
ACTUAL VOC CONTENT (lb/gal): 2.42 %
EPA VOC (lb/gal): 2.42 %
EPA VOC (g/L): 290.0 %
10 - Stability and Reactivity
STABILITY: Stable
HAZARDOUS POLYMERIZATION: Will not occur.
INCOMPATIBILITY: Material can react violently with strong oxidizing agents, strong bases, and strong reducing agents.
CONDITIONS TO AVOID: Fire, burning and welding.
HAZARDOUS DECOMPOSITION PRODUCTS: Fire, burning, and welding may generate carbon monoxide.
11 - Transportation Information
PROPER SHIPPING NAME: UN-1263 Paint
UN/NA : UN1263
DOT HAZARD CLASS: 3
DOT HAZARDOUS MATERIALS: *Flammable Liquid*
PACKAGING GROUP: III
12 - Other Information
HMIS RATINGS:
Health Flammability Reactivity
3 3 1
0 = Minimal 1 = slight 2 = Moderate 3 = Serious 4 = Severe * = Chronic Health Hazard
All information, recommendations, and suggestions appearing herein concerning our product are based upon tests and data
believed to be reliable. However, it is the user's responsibility to determine the safety, toxicity, and suitability for his own use
of the product described herein. Since the actual use by others is beyond our control, no guarantee, express or implied, is
made by Elastomer Specialties, Inc. as to the effects of such use, the results obtained, or the safety and toxicity of the
product nor does Elastomer Specialties assume any liability arising out of use, by others, of the product referred to herein.
The information herein is not to be construed as absolutely complete since additional information may be necessary or
desirable when particular or exceptional conditions or circumstance exist or because of applicable laws or government
regulations.
Revised: August 2009
2210 South Highway 69, Wagoner, OK 74467 * 918-485-2835 * Fax 918-485-2856 * www.elastomer.com / www.gatorhyde.com
|