Page 1 of 4
MATERIAL SAFETY DATA SHEET
MSDS No. 700C43
PRODUCT NAME: TT-S-171C Class 2, CLEAR SEALER
HMIS CODES:HEALTH 2 FIRE 3 REACTIVITY 0 PERSONAL PROTECTION G
SECTION I: MANUFACTURER IDENTIFICATION
MANUFACTURER NAME: MACH-DYNAMICS
ADDRESS: 3870 La Sierra Avenue, Suite 212, Riverside, CA 92505
INFORMATION PHONE: (951) 515-3748 FAX: (775) 599-4585
PREPARED BY: MARK GINGERELLA
DATE REVISED: MAY-12-2004 (12-22-99)
REASON REVISED: Format (Formula Change)
EMERGENCY PHONE: CHEMTRC 1-800-424-9300
SECTION II: HAZARDOUS INGREDIANTS / SARA III INFORMATION
HAZARDOUS COMPONENT CAS No. OSHA PEL ACCIW TLV OTHER mm Hg @ Temp Percent
*N/BUTYL ACETATE 123-86-4 150 PPM 200 PPM N/A 8.0 @ 68 Deg F 18
*METHYL AMYL KETONE 110-43-0 NOT ESTB 50 PPM 100 PPM 2.1 @ 68 Deg F 10
*CYCLOHEXANONE 108-94-1 25 PPM N/A N/A 2.0 @ 68 Deg F 6
*DIOCTYL PHTHALATE 117-81-7 5 MG/M3 5 MG/M3 N/A 1.2 @ 200 Deg F 2
*METHYL ETHYL KETONE 78-93-3 200 PPM 200 PPM N/A 70.0 @ 68 Deg F 14
*INDICATES TOXIC CHEMICAL(S) SUBJECT TO REPORTING REQUIREMENTS OF SECTION 313 OF TITLE III
AND OF 40 CFR 372. *WARNING THIS PRODUCT CONTAINS CHEMICALS KNOW TO THE STATE OF CALIFORNIA
TO CAUSE CANCER AND BIRTH DEFECTS OR OTHER REPRODUCTIVE HARM.
Page 2 of 4
MATERIAL SAFETY DATA SHEET
MSDS No. 700C43
SECTION III: PHYSICAL / CHEMICAL CHARACTERISTICS
BOILING RANGE: 172 TO 724 Deg F 0.9
SPECIFIC GRAVITY (H20=1):
VAPOR DENSITY: HEAVIER THAN AIR SLOWER THAN ETHER
EVAPORATION RATE:
MATERIAL V.O.C.: 5.10 LB/GL (612 G/L)
VISCOUS LIQUID WITH
SOLUBILITY IN WATER: ESSENTIALLY NIL APPEARANCE AND ODOR:
STRONG SOLVENT ODOR
SECTION IV: FIRE AND EXPLOSION HAZARD DATA
Flash Point 24 Deg F Method Used: TCC
Flammable Limits In Air By Volume: Lower: 0.3% Upper: 7.9%
Extinguishing Media: Foam, CO2, Dry Chemical, Water Fog
Approved gas mask required for fire fighting personnel.
Special Fire Fighting Procedures: Water may be ineffective. Water may be used to cool
containers. If water is used, fog nozzles are preferred.
Unusual Fire And Explosion Keep containers tightly closed. Isolate from heat,
Hazards: electrical equipment, sparks, and open flame. Closed
containers may explode when exposed to heat.
SECTION V: REACTIVITY DATA
Stability: Stable
Conditions To Avoid: Flames, Sparking, Smoking, and Heat.
Incompatibility or Materials to Avoid: Strong Oxidizing Agents.
Hazardous Decomposition or By Products: carbon Monoxide and Carbon Dioxide.
Hazardous Polymerization: Will Not Occur.
SECTION VI: HEALTH HAZARD DATA
INHALATION HEALTH RISK AND SYMPTOMS OF EXPOSURE:
Breathing of high vapor concentrations may cause drowsiness, dizziness, fatigue, followed by
coma.
SKIN AND EYE CONTACT HEALTH RISK AND SYMPTOMS OF EXPOSURE:
Direct contact and/or contact with vapors may cause irritation.
EYE:
SKIN: Prolonged and/or repeated contact may cause irritation and/or dermatitis. May be
absorbed through the skin.
SKIN ABSORBTION HEALTH RISK AND SYMPTOMS OF EXPOSURE: Prolonged or repeated exposure can
cause moderate irritation, defatting,
and dermatitis.
INGESTION HEALTH RISK AND SYMPTOMS OF EXPOSURE: Aspiration of this product into the
lungs may cause pneumontitis,
pulmonary edema, and hemorrhage.
Ingestion may cause
gastrointestinal disturbances.
Page 3 of 4
MATERIAL SAFETY DATA SHEET
MSDS No.:700C43
SECTION VI: HEALTH HAZARD DATA continued
HEALTH HAZARDS -- ACUTE AND CRONIC:
Direct contact to eyes may cause irritation, prolonged and/or repeated
contact may cause skin irritation. Inhalation of high concentrations of
vapors may lead to lung changes, nausea, vomiting, cough, pulmonary
irritation, and central nervous system depression. Ingestion may cause
gastrointestinal disturbance. Aspiration of this product into the lungs
may cause pneumontitis, pulmonary edema and hemorrhage.
CARCINOGENICITY: NTP? No IARC MONOGRAPHS? No OSHA REGULATED? No
MEDICAL CONDITIONS GENERALLY AGGRAVATED BY EXPOSURE:
Individuals with preexisting diseases in or history of ailments
involving skin, central nervous system, liver, and kidney.
EMERGENCY AND FIRST AID PROCEDURES:
IMMEDIATELY FLUSH WITH LARGE AMOUNTS OF WATER FOR 15 MINUTES, SEEK MEDICAL
EYE CONTACT: AID.
WASH THOROUGHLY WITH SOAP AND WATER. SEEK MEDICAL AID IF IRRITATION
SKIN: PERSIST.
IMMEDIATELY SEEK MEDICAL AID, DO NOT INDUCE VOMITING.
INGESTION: DO NOT ATTEMPT TO GIVE ANYTHING BY MOUTH TO AN UNCONSCIOUS PERSON.
INHALATION:
SECTION VII: PRECAUTIONS FOR SAFE HANDLING AND USE
STEPS TO BE TAKEN IN CASE MATERIAL IS RELEASED OR SPILLED:
Stop leak if no risk involved. Remove all sources of ignition, stay upwind. Absorb with
inert material. Flush area with water. Ventilate area for at least 24 hours or until area
has been declared safe.
WASTE DISPOSAL METHODS:
Use inert absorbent material on spills. Dispose of in accordance with all Federal, State,
and Local Regulations.
PRECAUTIONS TO BE TAKEN IN HANDLING AND STORING:
Keep containers closed and upright to prevent leakage. Avoid flames, welding, open lights,
etc. Avoid breathing of vapor and spray mist. Avoid skin and eye contact.
Maintain good personal hygiene.Do Not Use in confined
OTHER PRECAUTIONS:
areas, tank or pit, without adequate ventilation.
Page 4 of 4 MATERIAL SAFETY DATA SHEET
MSDS No. 700C43
SECTION VIII: CONTROL MEASURES
RESPIRATORY PROTECTION:
If ventilation does not maintain inhalation exposures below TLV (PEL), use MSHA/NIOSH
approved units. Use units per current 29 CFR1910.134 and follow manufacturer's instructions
and warnings. If within OSHA protection factor, air purifying OV/filter units OK for use.
VENTILATION: Local and mechanical exhaust.
PROTECTIVE GLOVES: Rubber gloves.
Safety glasses with side shields or goggles.
EYE PROTECTION:
OTHER PROTECTIVE CLOTHING OR EQUIPMENT: Eye bath and safety shower.
Maintain good personal hygiene. Do not use in
WORK/HYGIENIC PRACTICES:
confined areas without adequate ventilation.
SECTION IX: DISCLAIMER
AS THE CONDITIONS OR METHODS ARE BEYOND OUR CONTROL WE DO NOT ASSUME ANY RESPONSIBILITY
REGARDING USE OF PRODUCT. WE EXPRESSLY DISCLAIM ANY LIABILITY FOR ANY USE OF THE MATERIAL.
INFORMATION CONTAINED HEREIN IS BELIEVED TO BE ACCURATE, ALL STATEMENTS OR SUGGESTIONS ARE
MADE WITHOUT ANY WARRANTY, EXPRESSED OR IMPLIED TO THE ACCURACY OF THE DOCUMENT.
SECTION X: TRANSPORTATION DATA
GROUND:
PROPER SHIPPING NAME: PAINT, FLAMMABLE LIQUID
HAZARD CLASS: FLAMMABLE LIQUID
UN/NA NUMBER: UN1263
APPLICABLE REGULATION: 49 CFR 171-179
U.S. POSTAL REGULATION: NOT SHIPPABLE
LABEL: FLAMMABLE LIQUID
DISPOSAL INFORMATION:
THIS PRODUCT IS A US EPA DEFINED IGNITABLE HAZARDOUS WASTE. DISPOSE OF AS AN IGNITABLE
HAZARDOUS WASTE IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS. AVOID STORING
MATERIAL NEXT TO OR NEAR OXIDIZING MATERIALS. EPA IGNITABLE.
AIR:
PROPER SHIPPING NAME: PAINT
HAZARD CLASS: CLASS 3
UN/NA NUMBER: UN 1263
LABEL: FLAMMABLE LIQUID
PACKAGING GROUP: CONSULT IATA MANUAL
APPLICABLE REGULATION: IATA
U.S. POSTAL REGULATION: NOT SHPPABLE
DISPOSAL INFORMATION:
THIS PRODUCT IS A US EPA DEFINED IGNITABLE HAZARDOUS WASTE. DISPOSE OF AS AN IGNITABLE
HAZARDOUS WASTE IN ACCORDANCE WITH LOCAL, STATE, AND FEDERAL REGULATIONS. AVOID STORING
MATERIAL NEXT TO OR NEAR OXIDIZING MATERIALS. EPA IGNITABLE.
|