24 HR EMERGENCY PHONE HM IS
KENDALL AND SON LTD. CHEMTREC 800-424-9300 Codes
MATERIAL SAFETY DATA SHEET 0
K & K Chemical Co.
1303 Industrial Drive, Royse City, TX 75189
SEWER SLAYERTM MSDS Prepared By: J. Austin Maglothin, Ph.D.
K-694 Revision Date: April 13, 2010
SECTION I - GENERAL
Chemical Name & Synonym Not Applicable
Trade Name & Synonyms
Chemical Family Petrochemical mixture
Formula Trade Secret
SECTION II - HAZARDOUS INGREDIENTS
Heavy aromatic naphtha CAS No. 68333-29-9
o-Methylchlorobenzene CAS No. 95-49-8
p-Methylchlorobenzene CAS No. 106-43-4
Tall oil fatty acid CAS No. 61790-12-3
Diethanolamine CAS No. 111-42-2
2-Butoxyethanol CAS No. 111-76-2
Sodium sulfonate CAS No. Unknown
SECTION III - PHYSICAL AND CHEMICAL DATA
Boiling Point (oC) Not Determined
Vapor Pressure (mm Hg @ 20oC) Not Determined
Vapor Density (Air = 1) >1
Specific Gravity (H2O = 1) 0.947
% Volatile by Volume Not Determined
Evaporation Rate (H2 O = 1) <1
Solubility in Water Dispersible
Appearance and Odor Clear brown fluid with petroleum odor
SECTION IV - FIRE AND EXPLOSION HAZARD DATA
Flammable Limits (%)
- LEL Not Determined
- UEL Not Determined
42.4o C (TCC)
Flash Point (Method Used)
Extinguishing Media Water fog, foam, dry chemical or CO2 .
Special Fire Fighting Procedures Burning product may give off noxious and toxic fumes. Firefighters should wear NIOSH approved self-contained breathing apparatus.
Unusual Fire & Explosion Hazards Burning product may float on surface of water and spread fire to other areas. Concentrate is combustible.
SECTION V - HEALTH HAZARD DATA
Route of Entry Skin absorption, eye contact, inhalation, ingestion
Carcinogenic Assessment No listed components
Threshold Limit Value 25 ppm OSHA and ACGIH
Effects of Overexposure Skin absorption: Irritation and defatting
Eye contact: Irritation
Inhalation: Irritation of upper respiratory tract. Exposure to high concentrations may cause systemic toxicity (CNS depression producing
headache, dizziness, numbness and loss of consciousness).
Ingestion: Irritation of gastrointestinal tract. Possible systemic toxicity as described above.
Chronic effects: Possible liver or kidney dysfunction.
Emergency & First Aid Procedures Eye contact: Flush with water for 15 minutes. Get medical attention.
Skin contact: Wash with soap and water, then flush with large amounts of water. If irritation persists, get medical attention.
Ingestion: DO NOT INDUCE VOMITING. Drink 3 to 4 glasses of water. Get immediate medical attention.
Inhalation: Remove patient to fresh air. Administer artificial respiration if breathing has stopped. Get immediate medical attention.
SECTION VI - REACTIVITY DATA
Incompatibility (Materials to Avoid) Strong oxidizers, strong acids, caustics, halogens, strong reducing agents.
Hazardous Decomposition Products Reactive hydrocarbons and other toxic and irritating organic compounds, hydrogen chloride
Hazardous Polymerization Will not occur
SECTION VII - SPILL OR LEAK PROCEDURE
Steps To Be Taken In Case Material Is Released Or Spilled Do not allow large spills to contaminate ground or surface waters. Contain spills and soak up with inert absorbent material. Place in leak-proof
containers for proper disposal.
Waste Disposal Method Dispose of in accordance with all local, state and federal regulations. Rinse empty container 3 times before discarding in an authorized local, state
or federal landfill.
SECTION VIII - SPECIAL PROTECTION INFORMATION
Respiratory Protection None required under normal use.
Ventilation Special ventilation not normally needed. If required to maintain concentrations below specified levels, use explosion-proof ventilation.
Protective Gloves Solvent resistant
Eye Protection Splash goggles
Other Protective Equipment None required.
SECTION IX - SPECIAL PRECAUTIONS
Precautions To Be Taken In Handling And Storing Store in original containers for up to one year. Keep closed when not in use. Protect from extreme heat and cold. Protect from possible sources
of ignition (sparks, open flame, etc.)
DOT Classification Not Regulated
Other Precautions KEEP OUT OF REACH OF CHILDREN. Read and follow label directions. Do not cut, weld or drill on drums whether full, part full or empty.
Notice: While K & K Chemical Co. believes the information contained herein is accurate and valid, Kendall and Son makes no warranty or representation as to its validity, accuracy, or currency. Kendall and Son shall not be
liable or otherwise responsible in any way for use of either this information, or the material to which it applies. Disposal of hazardous material may be subject to federal, state, or local laws or regulations.